John Lewis JLTDC 05 - Manual

5 Description of the Appliance 0 1 Control panel 0 2 Water reservoir 3 Drum Light 0 4 Fluff filters 0 5 Rating Plate 0 6 Condenser unit 0 7 Adjustable feet 1 2 6 7 4 5 4 3 125980753.qxp 2005-12-05 07:57 Page 5

6 Technical Specifications DIMENSIONS Height 85 cm (33.5”) Width 60 cm (23.6”) Depth 58 cm (22.8”) POWER SUPPLY VOLTAGE 230-240 V/50 Hz TOTAL POWER ADSORBED 2450 W (13A) MAX LOAD CAPACITY Cotton, linen 6 kg (13.2 lbs) Synthetics 3 kg ( 0 6.6 lbs) DRUM VOLUME 108 l CONSUMPTIONS Cotton, linen 4.37 kWh...

7 Stacking kit (optional accessory) I t should be possible to stack your new dryer on top of a front loading washing machine with cover’s depthbetween 48 and 60 cm. Read carefully the instructions supplied with the kit. Please contact your local John Lewis branch for furtheradvice. Door reversal To ...

8 Any electrical work required to install this applianceshould be carried out by a qualified electrician orcompetent person . WARNING: THIS APPLIANCE MUST BE EARTHED. The manufacturer declines any liability should this safety measure not beobserved.Should the appliance power supply cableneed to be r...

9 The Control Panel 1 Programme/Time Selector Dial Allows you to select electronically controlled or timecontrolled drying. Turn the dial to the required programme or time. Electronically controlled drying (automatic) The appliance runs these programmes with the help ofprobes which detect the degree...

10 Every time the button is pressed, the time is increased by30 minutes, until the display shows a delay of “2 hours”.After this, the delay is displayed hour by hour. The minutes or hours of delay that have been selectedare displayed for 2 seconds, then the display shows theduration of the previousl...

11 8 Start/Pause button Press this button to start the dryer after having selectedthe programme and the options. The relevant light will stop flashing. If you have chosen adelayed start, the machine will begin the countdown. If the door of the appliance or the small door atthe bottom is opened while...

12 Programme Chart Automatic drying (electronic programmes) Type of laundry Degree of drying required Max-load (1) COTTON Extra dry store dry CUPBOARD dry damp DRY iron dry MACHINE IRON dry 6 kg6 kg 6 kg6 kg 6 kg6 kg Time controlled drying (1) Never overfill the drum (do not load large quilts, for e...

13 Operating Sequence Before using your tumble dryer for the first time, werecommend that you to place a few damp clothsinside the appliance and dry for 30 minutes.There may be dust inside a brand new tumble dryer. Drying 1. Connect the appliance. 2. Open the door (see picture). 3. Load the items on...

14 Before placing articles of laundry in your tumbledryer, check the care labels to ensure they arerecommended for tumble drying. Care Labels you may find on your laundry may be tumble dried normal drying (high temperature) delicate drying (low temperature) do not tumble dry Do not overload the appl...

15 You must disconnect the appliance from the electricity supply, before you can carry out anycleaning or maintenance work. External cleaning Use only soap and water and then dry thoroughly. Important: do not use methylated spirit, diluents or similar products. Cleaning the door Clean periodically t...

16 Clean it with a brush and rinse it under the shower ifnecessary. Also clean the outside, removing all fluff. Clean the rubber seal round the condenser cabinet and inthe inner part of the small door with a damp cloth. Important! Do not use pointed objects or utensils to clean the spaces between th...

17 Adjusting the level of conductivity Water contains, a variable quantity of limestone andmineral salts of which quantities vary according togeographical locations thus varying its conductivity values. Relevant variations of the conductivity of the watercompared to those prefixed by the factory cou...

18 Service & Spare Parts In the event of your appliance requiring service, or if youwish to purchase spare parts, please contact ourextended warranty administrators by telephoning: 0870 010 7887 They will give you details for your local Service ForceCentre. Before calling out an engineer, please...