John Lewis JLDWW 905 - Manual

1. Upper basket stop 2. Water hardness dial 3. Salt container 4. Detergent dispenser 5. Control panel 6. Rating plate 7. Rinse aid dispenser 8. Filters 9. Lower spray arm 10. Upper spray arm 11. Upper basket 12. Worktop Description of the Appliance 5 IN154

Unpacking ● Remove all packaging before positioning the machine. ● If possible, position the machine next to a water tap and a drain. Water supply connections We recommend that this dishwasher is connected to your coldwater supply. For making the connection itself, the coupling nut fitted to themach...

Fitting under a counter (kitchen worktop or sink) By removing the machine’s worktop, you can install it under aclose fitting sink unit or a pre-existing top, providing thedimensions of the recess correspond to those shown in thepicture. Proceed as follows:Remove the machine’s worktop by unscrewing t...

If you fit your own plug, the colours of the wires in the mains leadof your appliance may not correspond with the markingsidentifying the terminals in your plug. Proceed as follows:1. Connect the Green and Yellow (earth) wire to the terminal in the plug which is marked with the letter "E" or...

1. On/Off indicator light 2. On/Off buton 3. Function buttons In addition to the dishwashing programme selected, the followingfunctions can also be set with the help of these buttons: - the setting of the water softener, - activation/deactivation of the rinse aid dispenser, - the cancelling of a pro...

Before using your dishwasher for the first time: 1. Ensure that the electrical and water connections comply with the installation instructions 2. Remove all packaging from inside the appliance 3. Set the water softener 4. Pour 1 litre of water inside the salt container and then fill with dishwasher ...

a) Setting manually 1. Open the dishwasher door. 2. Remove the lower basket from the dishwasher. 3. Turn the water hardness dial to position 1 or 2 (see table). 4. Replace the lower basket. The dishwasher is factoryset at position 2. b) Setting electronically The dishwasher must be switched off NOTE...

Rinse aid Rinse aid is automatically added during the last rinse, ensuringthorough rinsing, and spot and streak free drying.The dispenser, which is positioned inside the door, holds about110 ml of rinse aid, which is sufficient for 16 - 40 dishwashingprogrammes, depending upon the dosage setting. Fi...

● Check if it’s necessary to refill with dishwasher salt or rinse aid ● Load cutlery and dishes into the dishwasher. ● Fill with dishwasher detergent . ● Select a wash programme suitable for the cutlery and dishes. ● Start the wash programme. Loading cutlery and dishes Sponges, household cloths and ...

Open the door and slide out the baskets to load the dishes. The lower basket The lower basket isdesigned to take saucepans,lids, plates, salad bowls,cutlery etc. Serving dishes and large lidsshould be arranged aroundthe edge of the basket,ensuring that the spray armscan turn freely. The rows of pron...

The upper basket The upper basket is designed for plates (dessert plates, saucers,dinner plates of up to 24 cmin diameter), salad bowls,cups and glasses.Arrange items on andunderneath the cup racks sothat water can reach allsurfaces.For taller items, the cupracks can be foldedupwards.Light items (pl...

Use of detergent Only use detergents specifically designed for usein dishwashers. Please observe the manufacturer’s dosing andstorage recommendations as stated on thedetergent packaging. Using no more than the correct amount ofdetergent contributes to reducing pollution. Fill with detergent 1. If th...

Concentrated detergent Modern detergents for dishwashers are almost exclusively low-alkaline concentrated detergents with natural enzymes in tabletform. Using 50°C washing programmes in conjunction with theseconcentrated detergents reduces pollution and is good for yourdishes, as these washing progr...

Washing Programmes 20 Programme Degree of soil and type of load Heavy soil.Crockery, cutlery,pots and pans Normal soil.Crockery andcutlery Normal soil.Crockery andcutlery Light soil.Crockery andcutlery Half load option Cycle description (3) Consumption values Hot prewashMain wash up to 70°C2 warm ri...

1. Check that the baskets have been loaded correctly and that the spray arms can rotate freely 2. Turn on the water tap 3. Close the dishwasher door 4. Press the On/Off button The On/Off indicator light and all the programme indicator lights illuminate. 5. Setting and starting the programme To selec...

8. End of the washing programme The dishwasher will automatically stop. The “End of cycle” indicator light illuminates. The “Programme time” backlit light and the indicator light of the programme just ended will remain on. In the digital display appears 0, only in this case the programme has ended. ...

You must disconnect the appliance from the electricity supply,before you can carry out any cleaning and maintenance work. External cleaning Clean the external surfaces of the machine and control panelwith a damp soft cloth. If necessary use only neutral detergents.Never use abrasive products, scouri...

If the dishwasher is not working correctly, please carry out the following checks, before contacting your local Service Force agent. Important! If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will bemade even if the applianc...

...the wash results are notsatisfactory The dishes are not clean ● The wrong washing programme has been selected. ● The dishes were arranged in such a way as to stop water reaching all parts of the surface.The baskets must not be overloaded. ● The spray arms do not rotate freely due to wrong arrange...