John Lewis JLBIUCL 01 - Manual

5 Description of the Appliance 1 2 5 6 1 3 4 1 Dairy compartments 2 Movable storage shelf 3 Bottle storage shelf 4 Interior light 5 Storage shelves 6 Salad crispers

6 Installation Electrical connection Any electrical work required to install this applianceshould be carried out by a qualified electrician orcompetent person. WARNING:THIS APPLIANCE MUST BEEARTHED. The manufacturer declines any liability should thissafety measure not be observed. If the plug that i...

Warning IF YOU ARE DISCARDING AN OLD APPLIANCETHAT HAS A LOCK OR CATCH ON THE DOOR,YOU MUST ENSURE THAT IT IS MADEUNUSABLE TO PREVENT YOUNG CHILDRENBEING TRAPPED INSIDE. Depending upon the position which you choose foryour appliance, you may wish to reverse the way inwhich the door opens. To do this...

8 To reverse the opening direction of the door,proceed as shown in the figures: Warning After completion of the door reversingoperation, check that the door gasket adheresto the cabinet. If the ambient temperature iscold (i.e. in Winter), the gasket may not fitperfectly to the cabinet. In that case,...

Before carrying out any work, remove the plug fromthe power socket. Grid preparation Left door opening: Remove the left side (A) of the grid cutting it fromthe rear (see figure). Right door opening: Remove the right side (B) of the grid cutting it fromthe rear (see figure). To position the grid on t...

Fitting the plinth Important For the efficient operation of the appliance, it is important that the original ventilation grid isused. • For an opening height dimension A=820 mm and a plinth height dimension a=100 mm, the plinth maybe fitted without adjustments. The same applies toan opening height d...

13 Start your appliance Allow the appliance to stand for 2 hours afterinstallation. Insert the plug into the wall socket. The pilot light(A) will illuminate to show that the appliance is on. Turn the thermostat control (B) to a midway setting.Leave the appliance for approximately 4 hours forthe corr...

15 Food Storage • To obtain the best results from your appliance,neither hot foods nor liquids which mayevaporate, should be placed in the lardercompartment. • Keep the time between buying chilled food andplacing it in your fridge as short as possible. • Do not push food together too much, try toall...

Defrosting The refrigerator automatically defrosts every timethe compressor stops. The water is discharged, viathe pipe, into a tray located below the appliance,where it evaporates. Important To avoid defrost water overflowing anddripping onto the food in the fridge,periodically clean the water disc...

17 Important: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation a charge will be made, even if the appliance is under guarantee. Before contacting your local Service Force Centre, check the following points: Something not working SYMPTO...

18 If your appliance is not performing satisfactorily;consult the fault finding guide within this instructionbook (Something not working). In the event of afault occurring which you cannot resolve yourselffrom advice given within this instruction manualyour first step is to contact our extended warr...