John Lewis JLBICM 01 - Manual

7 Installing the machine • Lay the U base plate of the machine on the shelf of the cabinet. • Insert the L plates, compensating for any space. The width of the housing unit the coffee machine depends on the thickness of the cabinetÊs sides. six side plates (four being 2 mm thick and two 1 mm thick) ...

9 Technical specifications Width 594 mm Depth 475 mm Height 378 mm Capacity of water reservoir 2.5 l Net weight 28 kg Gross weight 31 kg Supply voltage 230 V Rated power 2000 W Power absorbed by the heating element 1700 W Power absorbed by the pump 50 W Working pressure 12 bar Fuse 13 A Electrical c...

10 The control panel 1. Water refill indicator 2. ON-OFF/stand-by indicator 3. Start indicator 4. Hot water selector indicator 5. Steam selector indicator 6. Light selector indicator 7. Espresso coffee indicator 8. Regular coffee indicator 9. Used Coffee 'drawer full' indicator 10. ON-OFF/stand-by c...

11 Instructions for the first use Filling up the water reservoir • Squeeze together the unlocking levers found under the drip tray • Gently pull the coffee machine forward from the housing by sliding it along the telescopic runners. Hardness of water: • Before filling up the water reservoir, make su...

13 Filling up the container with coffee beans • Press the unlocking levers located under the drip tray and pull the machine as it is shown in the figure. • pull the coffee machine forward from the housing along the telescopic runners . • Pour approximately 200 g of coffee beans into the container on...

15 Adjusting the texture ground coffee CAUTION This machine is calibrated in the factory for an optimum level of ground coffee. Too „coarse‰ ground coffee will result in a weaker coffee. Too „fine‰ ground coffee will result in very strong coffee, delivered by „drops‰ and tasting „bitter‰. The time r...

17 Making coffee • Press the control corresponding to the desired selection. • Press the start control within 10 seconds and the machine will make the coffee selected. • The machine will stop automatically CAUTION: the desired function will be disabled if the start control is not pressed within 10 s...

18 • The steam/water pipe can be moved to the back of the cabinet when not in use. Hot water Pull forward when required. CAUTION: when HOT! To dispense hot water, place a container under the steam/water nozzle; then press the water control. • the desired amount is dispensed. To stop the water Do not...

19 Steam - Heating liquids • The steam/water pipe can be moved to the back of the cabinet when not in use. Pull forward when required. CAUTION: Do not touch when HOT! • Press the steam control and the corresponding indicator blinks for 20 seconds. The machine will be ready to make steam when the ind...

23 If you wish to reset the standard values Resetting standard values • This coffee machine is calibrated in the factory to make the optimum Italian espresso, the values set for the espresso coffee distribute 30 cc, the values set for the regular coffee is 80 cc. • if the standard values have to be ...

24 Signal and alarms Water refill indicator • This machine has a sensor which detects when the water reservoir is empty. • the reservoir empty led will illuminate. The machine will not operate until the water reservoir is refilled. Volumetric counter fault • This machine has a volumetric counter whi...

25 Cleaning Outer parts • Clean the stainless steel parts of the machine with a soft cloth without using aggressive detergents. Never use any abrasive sponges nor steel wool to clean the parts of steel. Dry well with a soft cloth. Steam nozzle • Remember to clean the steam nozzle periodically that c...

27 • Replace the drawer and close the door. Replace the drip tray. Water reservoir • If the machine is not used for long periods, change the water in the reservoir and drain the boiler by pressing the coffee button several times. • Clean the water reservoir periodically . • The water reservoir can b...

28 Repairs - after sales service If your coffee machine is not performing satisfactorily, consult the fault finding guide within this instruction book (something not working). If a fault occurs which you can not resolve through following the advice and information contained within the instruction ma...