JL Audio M600/1 - Manual

JL Audio M600/1

JL Audio M600/1 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
Page: / 11

Table of Contents:

  • Page 4 – page; any channel(s) of any amplifier in the system
  • Page 7 – “Filter Freq” amP Filter; One Stereo Pair; rated Power at 14.4V with less than; Signal to Noise Ratio:; Following the directions below will allow the; target aC Voltage; Not Recommended
  • Page 8 – contact with the input jacks on the amplifier.
  • Page 11 – (do not send product for repair to this address); international warranties:; by that country’s distributor and not by JL Audio, Inc.
Loading the manual

Thank you for purchasing a JL Audio amplifier for

your marine sound system.

Your amplifier has been designed and manufactured to exacting

standards in order to ensure years of musical enjoyment in your vessel.

For maximum performance, we highly recommend that you have

your new amplifier installed by an authorized JL Audio dealer. Your

authorized dealer has the training, expertise and installation equipment

to ensure optimum performance from this product. Should you

decide to install the amplifier yourself, please take the time

to read this manual thoroughly so as to familiarize yourself

with its installation requirements and setup procedures.

If you have any questions regarding the instructions in this

manual or any aspect of your amplifier’s operation, please contact your

authorized JL Audio dealer for assistance. If you need further assistance,

please call the JL Audio Technical Support Department

at (954) 443-1100 during business hours.

owner’s manual

600W Marine Monoblock Subwoofer Amplifier

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 4 - page; any channel(s) of any amplifier in the system

6 | JL Audio - M600/1 Owner’s Manual 7 inPut seCtion The M600/1’s input section allows you to send signal to the amplifier section through the use of two differential-balanced inputs, one for the left channel signal and one for the right channel signal. Connection is via RCA-type jacks. You may run ...

Page 7 - “Filter Freq” amP Filter; One Stereo Pair; rated Power at 14.4V with less than; Signal to Noise Ratio:; Following the directions below will allow the; target aC Voltage; Not Recommended

12 | JL Audio - M600/1 Owner’s Manual 13 aPPendix b: Precise Frequency selection Chart “Filter Freq” amP Filter detent Panel actual number marking Freq. Full counter-clockwise: 53 01 . . . . . . . . . . . . . . . . . . . . . . . . . . . .53 02 . . . . . . . . . . . “50” . . . . . . . . . . . .53 03 ...

Page 8 - contact with the input jacks on the amplifier.

14 | JL Audio - M600/1 Owner’s Manual 15 “my amplifier shuts off once in a while, usually at higher volumes.” Check your voltage source and grounding point. The power supply of the M600/1 will operate with charging system voltages down to 10V. Shutdown problems at higher volume levels can occur when...

Other JL Audio Models

All JL Audio Other