Jet JT9-724020 - User Manual

8 Unpacking and Cleanup 1. Finish removing all contents from the shipping container. Do not discard any shipping material until the shaper is set up and running. 2. Inspect contents for shipping damage and report any damage or missing parts to your distributor. 3. Clean all protected parts with kero...

9 Setup and Adjustments Spindle Removal and Installation All adjustments to the machine must be made with the power off and unplugged from the power source. Failure to comply may result in serious injury. The spindle guard has been removed for illustration purposes only! Never operate the shaper wit...

11 Operation Spindle Control To raise or lower spindle: 1. Loosen spindle lock handle (A, Figure 9). Turn handle counterclockwise to loosen. 2. Raise or lower spindle to desired height by turning handwheel (B, Figure 9). 3. Turn spindle lock handle clockwise to tighten. Using the Fence as a Guide Sh...

12 Collar Positioning Collars may be positioned above, below, or between two cutters: 1. When using the collar below the cutter (Figure 17), you can always observe the progress of the cut. A disadvantage of this method is any accidental lifting of the work will gouge the wood and ruin the workpiece....

13 Starting Pin Only experienced, advanced users should attempt starting pin shaping! If you have never used this method, get training from a qualified person who is knowledgeable in starting pin shaping! Failure to comply may cause serious injury! Place the starting pin in one of the two threaded h...

14 Troubleshooting Trouble Probable Cause Remedy Shaper will not start. Cord unplugged from the power source. Plug in power cord. Fuse blown, or circuit breaker tripped. Replace fuse, or reset circuit breaker. Cord damaged. Replace cord. Reversing switch is in the OFF position. Turn switch to forwar...

15 Trouble Probable Cause Remedy Work pulled from hand. Feeding work in the wrong direction. Always feed work against the rotation of the cutterhead. Depth of cut not uniform. Fence misalignment. Align outfeed fence. Side pressure not uniform. Use hold-downs; keep constant pressure against fence. Wo...

17 JWS-20CS Base Assembly – Parts List Index No Part No Description Size Qty 1 ................ JWS20-101 ................ Cabinet .................................................................... ...................................... 1 2 ................ JWS20-102 ................ JET Stripe .....

19 JWS-20CS Motor Assembly – Parts List Index No Part No Description Size Qty 1 ................ JWS20-201 ................ Spindle Bracket ....................................................... ...................................... 1 2 ................ JWS20-202 ................ Gear Shaft .........

21 JWS-20CS Spindle Assembly – Parts List Index No Part No Description Size Qty 1 ................ JWS25-301 ................ Hex Nut ................................................................... 5/8 L.H. ......................... 1 2 ................ JWS25-302 ................ Hex Nut ..........

23 JWS-20CS Fence Assembly – Parts List Index No Part No Description Size Qty 1 ................ JWS20-401 ................ Knob ........................................................................ ...................................... 2 2 ................ TS-0720091 ............... Lock Washer...

26 JWS-20CS Shaper Electrical Connections Electrical Schematic Electrical Schematic for the Forward/Reverse Switch