JENSEN JPA460 - Manual

JENSEN JPA460

JENSEN JPA460 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
Page: / 3
Loading the manual

GND

+12V

REM

1. Disconnect the negative (-) battery terminal.

NOTE: Check your vehicle's owners manual before disconnecting the battery.
Disconnecting the battery in some vehicles may require an anti-theft code when
reconnecting for stereo operation. Some vehicles may run rough after reconnecting
the battery and require service to have the on-board computer reset. Check with
your local dealer if you are uncertain.

2. Run suitable AWG wire to where the amplifier will be mounted (run 1 foot extra than

you think you will need). Use rubber grommets where wires will pass through the

firewall or other areas of the vehicle. Make certain a fuse holder is placed within 18

inches of the vehicle battery

this is mandatory. Do not place a fuse in the fuse

holder at the battery at this time.

3. Mount the amplifier on a flat surface. Since a flat surface in a modern vehicle is often

difficult to find, an alternative is to cut a piece of 1/2 inch wood slightly larger than

the amplifier mounting area (covered with automotive type carpeting). Mount the

piece of wood, and then mount the amplifier to the carpeted wooden mount.

4.

Ground the amplifier using the same AWG wire size used for the power cable. Make

sure the ground location is a clean, unpainted metal surface.

5. Run the RCA and Remote turn-on lead to the amplifier from the head unit.

6. Run speaker wires (16 AWG or larger) from your speakers to the amplifier.

7. Place a suitable size fuse in the fuse holder at the battery.

8. Ensure that the crossover is set to "OFF" and that the input level control is set to

"MIN".

9. Turn on the head unit and make appropriate amplifier adjustments.

JPA460 4-Channel Amp Quick Start Guide

Fuse Block or Fuse Holder

Minimum Wire Size:

+12V -

6

AWG

Ground -

6

AWG

CHASSIS GROUND

(+

)

BATTERY

-

(

)

Remote /

Power Antenna

Turn-on Wire

RCA Cables

RIGHT REAR

SPEAKER

LEFT REAR

SPEAKER

RIGHT FRONT

SPEAKER

LEFT FRONT

SPEAKER

CAR STEREO /
SOURCE UNIT

(LR+)

BRIDGED

(LR-)

(RR+)

(RR-)

(LF+)

(RF+)

(RF-)

BRIDGED

(LF-)

Need help?

For technical

assistance, call the

Jensen customer

support line at 1-800-

323-4815.

AMP

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Other JENSEN Models

All JENSEN Other