JENSEN JCD3010 - Manual
JENSEN JCD3010 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – SAFETY INFORMATION; When Driving; DISC NOTES; Compatible Disc Types; Table 1: General Disc Information; Disc Type; Audio CD; Insert label
- Page 3 – INSTALLATION; Before You Begin; Disconnect Battery; Important Notes; Be sure to remove the control panel before installing the unit.; Mounting the Unit
- Page 4 – WIRING; Wire Connector; SHOWN FROM PIN VIEW
- Page 5 – BASIC OPERATION; press and hold
- Page 6 – Setting the Clock; TUNER OPERATION; Select a Band; Auto Seek Tuning; Scan; Store a Station
- Page 7 – CD OPERATION; Insert and Eject Disc; Track Select
- Page 8 – SPECIFICATIONS; CD; TROUBLESHOOTING; Symptom; AUDIO
JCD3010
JCD3010
Installation and Operation Manual
MOBILE CD PLAYER / RECEIVER
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
JCD3010 2 SAFETY INFORMATION When Driving Keep the volume level Iow enough to be aware of your surroundings. When Washing your Vehicle Do not expose the product directly to water, as this can cause electrical shorts, fire or other damage. When Parked Exposure to direct sunlight for an extended perio...
JCD3010 3 INSTALLATION Before You Begin 1. Disconnect Battery Before you begin, always disconnect the battery negative terminal. 2. Remove Transport Screws Important Notes • Before final installation, test the wiring connections to make sure the unit is connected properly and the system works. • Use...
JCD3010 4 WIRING 15A FUSE A - A Wire Connector A- A SHOWN FROM PIN VIEW ACCESSORY/IGNITION (+) Connect to existing radio accessory fuse or+12 VDC switched power source. POWER ANTENNA Connect to power antenna or amplifier. If notused, tape bare end of wire. MEMORY/BATTERY (+) GROUND Connect to batter...