Page 2 - TABLE OF CONTENTS
SECTION ONE Safety Instructions………………………………… Placement of the Grill ……………………………. SECTION TWO Side Shelf & Side Burner Assembly……………. Side Shelf Handle Assembly & Battery Installation………………………………………… Braking System Operations & Liquid Propane Cylinder Retention System………………………. Slide-Out ...
Page 3 - SAFETY INSTRUCTIONS; RECOGNIZED SAFETY SYMBOLS, WORDS AND LABELS
SAFETY INSTRUCTIONS WARNING 1. Do not store spare liquid propane cylinders under or near this appliance. 2. Never fill the cylinder beyond 80 percent capacity. 3. If the information above is not followed exactly, a fire resulting in death or serious injury could occur. WARNING Never attempt to use d...
Page 7 - PLACEMENT OF THE GRILL
SAFETY INSTRUCTIONS When using the grill, do not touch the grill rack, burner grate or immediate surroundings as these areas become extremely hot and could cause burns. Use only dry potholders. Moist or damp potholders on hot surfaces may cause steam burns. Do not use a towel or bulky cloth in place...
Page 8 - SIDE SHELF ASSEMBLY
6 SIDE SHELF ASSEMBLY Estimated Assembly Time: Approximately 10 minutes Required Tools: Phillips Screwdriver (not included) 1. Remove side shelf from inside grill cart. 2. The screws used to attach the side shelf are already screwed into the side of the grill cart. Remove the screws from the side pa...
Page 10 - BRAKING SYSTEM OPERATIONS
8 BRAKING SYSTEM OPERATIONS 1. Push to the right to lock. 2. Push to the left to unlock. LIQUID PROPANE CYLINDER RETENTION SYSTEM 1. Set the liquid propane gas cylinder into the slide-out tray. Turn the retention screw clockwise to secure the gas cylinder. 2. Make sure tank is leveled with bottom pa...
Page 13 - LEAK TESTING
11 3. Detach the regulator assembly from the tank valve by turning the quick coupling nut counterclockwise. 4. Place the dust cap on the liquid propane cylinder valve outlet when the cylinder is not in use. Only install the type of dust cap that is provided with the cylinder valve. The use of other ...
Page 14 - INSTALLER FINAL CHECK
12 The gas must be turned off at the supply cylinder when the unit is not in use. If the appliance is stored indoors, the cylinder must be disconnected and removed from the appliance. Cylinders must be stored outdoors in a well-ventilated area out of the reach of children. WARNING Cylinder must be s...
Page 15 - OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS GENERAL USE OF THE GRILL AND ROTISSERIE Each main burner is rated at 15,000 BTU/Hr. The main grill burners encompass the entire cooking area and are side ported to minimize blockage from falling grease and debris. Above the burners are stainless steel flame tamers. The igniter...
Page 16 - CAUTION; LIGHTING INSTRUCTIONS
NOTE It is normal for the skewer to flex when larger cuts of meat are being cooked. If the meat scrapes on the cooking grids during any part of the rotation, the cooking grids must be removed. Test this clearance before lighting the grill as the cooking grids become hot when the grill is lit. 14 Adj...
Page 17 - LIGHTING ILLUSTRATIONS; MAIN BURNER LIGHTING
15 LIGHTING ILLUSTRATIONS MAIN BURNER LIGHTING ROTISSERIE BURNER & SEARING SIDE BURNER LIGHTING 1. Open the top cover or lid. 1. Push and turn rear burner slowly to “INGITE / ON” setting; you should hear a “clicking sound if the electronic ignition system is working properly. The burner should i...
Page 18 - TO MATCH LIGHT THE GRILL
16 TO MATCH LIGHT THE GRILL If the burner will not light after several attempts using the control knobs, the burner may be lit with a match. Main Burner 1. If you have already attempted to light the burner with the igniter, allow 5 minutes for any accumulated gas to dissipate. 2. Insert a match into...
Page 21 - GRILL LIGHTS; Light Operation Instruction; Bulb Replacement
19 GRILL LIGHTS Light Operation Instruction 1. Make sure light’s power switch on the control panel is in the “OFF” position. 2. Connect power plug to properly grounded outlet. 3. Turn the light’s power switch to “ON”. WARNING Keep any electrical supply cord away from any heated surface. Bulb Replace...
Page 22 - Cleaning Method; Bulb Specification
5. Use a screwdriver to loosen the two screws locking the bulb. Pull out the light bulb and replace with a new bulb. 6. Reverse the instruction from steps 5-1 for installation. Cleaning Method Follow steps 1-4 above for glass cover removal. Use a damp towel to clean the surface of glass cover. Make ...
Page 24 - CARE & MAINTENANCE OF THE GRILL; GRILL BURNER CLEANING
CARE & MAINTENANCE OF THE GRILL STAINLESS STEEL Grease specks can gather and bake onto the surfaces of the stainless steel, giving the appearance of rust. For removal, use an abrasive pad with a stainless steel cleaner. GRILL RACK The best time to clean the grill is immediately after cooking is ...
Page 25 - TROUBLESHOOTING
TROUBLESHOOTING WHEN TO LOOK FOR SPIDERS You should inspect the burners at least twice a year or immediately after any of the following conditions occur: 1. The smell of gas in conjunction with burner flames appearing yellow. 2. The grill does not reach temperature. 3. The grill heats unevenly. 4. T...
Page 29 - GRILL COOKING CHART
This Jenn-Air grill has an infrared side burner – commonly referred to as a “searing” burner. This type of burner produces extreme heat that can be used to “sear” the outside of food thus locking the juices inside. This process is used at many upscale restaurants to improve the flavor of the food. T...
Page 32 - GRILL RECIPES
BBQ SALMON 2 large salmon steaks 2 tbs. oil Salt & pepper 2 oz. thin bacon slices 2 tbs. butter 1 tbs. lemon juice Sprig of parsley Lemon wedges *You can substitute catfish, halibut or cod for salmon. Preheat the BBQ Brush the steaks with oil and season with salt and pepper. Place on BBQ grill a...
