JBL VT4887 - Manual - manualsarea.com

Page 2 - TABLE OF CONTENTS

Page 2 TABLE OF CONTENTS PAGE GENERAL AMPLIFICATION NOTES & REQUIREMENTS…………………. 3 SUBWOOFER WIRING NOTES………………………………………………… 4 STANDARD AMPLIFICATION RACK LIMITER SETTINGS NOTES …………….……………………………..…….. 5 VT4887 & VT4881 TRANSDUCER COMPLEMENT.………………………………….…….. 5 AMPLIFIER CONFIGURATION OPTIO...

Page 3 - GENERAL AMPLIFICATION NOTES & REQUIREMENTS

Page 3 GENERAL AMPLIFICATION NOTES & REQUIREMENTS • For the purpose of this discussion: Crown MA series amplifiers are used below. HF indicates High Frequency drivers, MF indicates Mid Frequency drivers, LF indicates Low Frequency drivers and VLF stands for Very Low Frequency drivers (subwoofers...

Page 4 - OR

Page 4 NOTES ON SUBWOOFER WIRING • VT4880: Users may choose to wire both 2258 (18”) components in parallel to one (1) channel of a MA-3600 or MA-5002 for (4) ohms load. In this case each amplifier channel drives one VT4880. If two VT4880 are wired in parallel, the load is two ohms and there will be ...

Page 5 - NOTES REGARDING LIMITER SETTINGS

Page 5 NOTES REGARDING LIMITER SETTINGS • The recommended limiter threshold settings provide 3 dB of headroom before the component or bandpass peak voltage is reached. • The component or bandpass peak voltage is 6 dB above the voltage used at continuous maximum power. • These settings assume the use...

Page 6 - * 6 dB of headroom required for extended bandpass.; Amplifier Configurations:

Page 6 Amplifier Configurations: 4 x VT4887 & 2 VT4881 / 3 MA- 5002 Amplifier Channel Speakon NL8 Terminals Driving Nominal Impedance at Pins Amplifier Power Rating at Nominal Impedance Power Available to each Bandpass Bandpass Peak Voltage Vac Limiter Threshold dBu Pins 4± 4 x 2407H & 8 x 2...

Page 7 - Power Amplifiers; Power Amplifier configurations - 4 +2 Box Array

Page 7 IMPORTANT NOTES: All wiring configurations shown above use 8-conductor speaker cables terminated with Neutrik NL8 "Speakons".Ensure that each conductor in the cable is a minimum of #13 AW (3-4 mm). JBL VT4887: The MF & HF section of a VT4887 has an internal passive crossover netwo...

Page 9 - Please refer to: NOTES REGARDING LIMITER SETTINGS on page 5.

Page 9 Amplifier Configurations: 6 VT4888 / 4 MA-5002VZ Amplifier Channel Speakon NL8 Terminals Driving Nominal Impedance at Pins Amplifier Power Rating at Nominal Impedance Power Available to each Component Bandpass Peak Voltage Vac Limiter Threshold dBu Pins 4± 6 x 2431H 5.7 Ω 1300W 216W 56V -3 Ch...

Page 10 - x Power Amplifiers; JBL V; ER

Page 10 IMPORTANT NOTES: All wiring configurations shown above use 8-conductor speaker cables terminated with Neutrik NL8 "Speakons".Ensure that each conductor in the cable is a minimum of #13 AWGuage (3-4 mm). JBL VT4888: The HF section of a VT4888 has two 2431H drivers (8 Ω ) wired in Seri...

Page 13 - JBL VerTec VT4889 Line Array

Page 13 IMPORTANT NOTES: All wiring configurations shown above use 8-conductor speaker cables terminated with Neutrik NL8 "Speakons".Ensure that each conductor in the cable is a minimum of #13 AWGuage (3-4 mm). JBL VT4889: The HF section of a VT4889 has three 2435H drivers (5.3 Ω ) wired in ...

Page 14 - Arrays of similar V; Models

Page 14 VERTEC SYSTEMS SUSPENSION HARDWARE & ASSEMBLY NOTES Arrays of similar V ER T EC Model • Each V ER T EC model uses the matching model of Array Frame (VT488X-AF) or Short Frame (VT488X-SF) to create clusters of the same model. • These same frames can also be used to ground stack the variou...

Page 15 - VERTEC SYSTEMS SUSPENSION FRAMES & HINGE BARS; MODEL; Basic Principles for

Page 15 VERTEC SYSTEMS SUSPENSION FRAMES & HINGE BARS V ER T EC MODEL FRAME MODELS NOTES HINGE Part # VT4889 VT4889-AF VT4889-SF VT4800-UA VT4800-DA Standard long frame. 16 VT4889 @ 7:1 DF* Standard short frame. 16 VT4889 @ 7:1 DF Universal frame to hang any model to any model. Adapter frame to ...

Page 16 - SUSPENSION FRAMES

Page 16 VERTEC VT4888, VT4887, VT4881 SYSTEMS: SUSPENSION FRAMES

Page 17 - VERTEC SYSTEMS: SUSPENSION HINGE BARS

Page 17 VERTEC SYSTEMS: SUSPENSION HINGE BARS \ High-grade steel alloy hinge bars are used to couple adjacent boxes together. There are several different types. To ensure ease and proper inter-connection, make certain that the correct hinge bar model is matched to the appropriate Array Frame or Shor...

Page 19 - TYPICAL 8-BOX HANGING ARRAY

Page 19 TYPICAL 8-BOX HANGING ARRAY The VT4889 full size, the VT4888 mid size, and VT4887 compact line array elements can be suspended from either the “AF” (long) or “SF” (short) array frame. Shown here, eight VT4887 suspended from a VT4887-AF array frame.

Page 20 - VERTEC SUPPORT TEAM; TOUR SOUND PRODUCT MANAGER; WEBLINKS; JBL PROFESSIONAL:

Page 20 VERTEC SUPPORT TEAM DIRECTOR, TOUR SOUND David Scheirman Office phone: (818) 895-3458 Pager: (888) 861-1622 Email address: [email protected] TOUR SOUND PRODUCT MANAGER Raul Gonzalez Office phone: (818) 830-8749 Mobile phone: (818) 802-9176 Email address: [email protected] DIRECTOR, SYSTE...

JBL VT4887 - Manual

Table of Contents:

Summary

Other JBL Models