Jasco 45132 - Manual - manualsarea.com

Page 2 - Table of Contents

Important Safeguards 4 Introduction 5 Assigning a Sensor to a Zone 6-7 Testing a Sensor or your system 7-8 Installation 8 Erasing a Sensor from a Zone 8-9 Low battery indicator 10 Battery warnings 11 F.A.Q.'S 1-1 FCC Warning 14 Table of Contents

Page 3 - Congratulations; The GE Choice Alert

Before connecting or operating the Motion Sensor, please read these instructions carefully and save this manual for future reference. Congratulations The GE Choice Alert ™ Wireless Alarm System is one of the most affordable and expandable wireless alarm systems available. You’ll discover the system ...

Page 4 - Important safeguards; PreCautions

4 5 Important safeguards PreCautions 1. Do not attempt to disassemble the Motion Sensor, unless described in the user’s manual. There are no user serviceable parts. . Handle with Care – Avoid striking or shaking. Improper use or storage could damage the Motion Sensor. Modifying or tampering the devi...

Page 5 - Introduction; Parts Check List; Identify all the parts before proceeding.

4 5 Introduction The Motion Sensor is designed to be used indoors or out. When mounted properly it can monitor large or open areas such as entrances, living rooms, family rooms, driveways, backyards, walkways, workshops, etc. When the Sensor detects motion, it will transmit a signal to the Control C...

Page 6 - Step 1 –; Zone 4 is for dedicated alerts only. Sensors in this Zone; Step 4 –

6 7 Preparing the Motion Sensor for Installation The Motion Sensor consists of 2 parts – The Sensor (Transmitter) and the wall mount. Before installing, remove the screw from the battery door on the back of the Sensor. You’ll need to attach the battery leads to a “9V” battery (not included); Take ca...

Page 7 - Testing a Sensor or your system

6 7 - To activate the Motion Sensor, press the Learn button located inside the battery compartment, or if mounted wave your hand in front of the Sensor (the red LED indicator will flash inside lens area in front of the Motion Sensor). Testing a Sensor or your system Once all the Sensors have been as...

Page 8 - Installing the Sensor

8 9 Step - Set the Notification Mode to switch ‘Alert’ position and begin activating Sensors one at a time. Note: The sensor has a LED that flashes to show when the sensor has triggered and transmitted to the main unit. Step 4 - When testing is complete, unplug the AC adapter, then plug the AC adapt...

Page 11 - Control Center

10 11 WARNING!Risk of personal injury - Prolonged exposure to alarm siren may cause permanent hearing loss Battery Warning! - Remove batteries before storing the Alarm or Sensor for extended periods- Batteries may leak harmful liquids or ignitable materials or explode causing injury and product dama...

Page 14 - FCC Warning

14 15 FCC Warning Any unauthorized changes or modifications to the equipment would void the user’s warranty and may conflict with both state and federal laws. The Choice Alert system complies with part 15 of the FCC rules. Operation is subject to the following conditions: 1) The Choice Alert system ...

Page 15 - WARNING

14 15 WARNING Limitations of Alarm ProductsThis product should be tested periodically to make sure it is working properly. The product, if used properly, may reduce the risk of burglary, robbery, or other adverse events. However, JASCO is not an insurer, this product is neither insurance nor a guara...

Jasco 45132 - Manual

Table of Contents:

Summary

Other Jasco Models