IVES VR910M - Manual
IVES VR910M – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
829560_00(2) Copyright © 2003 Ingersoll-Rand. All rights reserved.
FOR USE WITH MORTISE DEVICES
VR910M/VR914M VANDAL RESISTANT TRIM
INSTALLATION INSTRUCTIONS
INSTALL MORTISE LOCK. SEE MORTISE LOCK
INSTRUCTIONS.
INSTALL EXIT DEVICE AND TRIM.
3
4
RHR
SHOWN
LHR
OPPOSITE
VR910M/VR914M
TRIM
SCREWS (4):
10-24 X 1”
PPHMS SCREWS
(1-3/4” DOORS)
10-24 X 1-1/2”
PPHMS SCREWS
(2-1/4” DOORS)
INSTALL CYLINDER, IF USING.
5
KEYHOLE
POSITION
WHEN INSTALLED
USE WAVE WASHERS
INSIDE CYLINDER
COLLAR AS NEEDED
FOR PROPER FIT
SET SCREW:
REMOVE FROM CYLINDER
SIDE UNTIL CYLINDER IS SCREWED INTO
PLACE, THEN REINSTALL SCREW
CYLINDER COLLAR
3-1/2”
7 ”
3-1/2”
1-3/8”
13/32” DIAMETER HOLES,
4 PLACES (TRIM SIDE)
1/4” DIAMETER HOLES,
4 PLACES (OPPOSITE SIDE)
1-5/8” DIAMETER
HOLE (TRIM SIDE
OF DOOR) FOR
CYLINDERS ONLY
DEVICE & TRIM
HORIZONTAL
L
C
RHR SHOWN
LHR OPPOSITE
OUTSIDE FACE
OF LOCK STILE
11/16”
PREPARE PUSH SIDE OF DOOR FOR EXIT
DEVICE. SEE EXIT DEVICE INSTRUCTIONS
FOR PREPARATION.
PREPARE PULL SIDE OF DOOR FOR TRIM.
A
TRANSFER VERTICAL AND HORIZONTAL
DEVICE CENTER LINES FROM PUSH SIDE
OF DOOR TO PULL SIDE.
B
LOCATE AND PREPARE ALL HOLES AS
INDICATED BELOW.
1
2
DEVICE & TRIM
VERTICAL
LC
2-1/4”
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
