IVES 7245F - Manual
IVES 7245F – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
7244F and 7245F
1-1/2” Intermediate Pivot
Improper pivot set installation can lead to personal injury or property damage. Follow
all instructions carefully. For questions contact Technical Support at 1-888-371-7331.
CAUTION
!
1. Prepare and mortise hinge stile of door and hinge side jamb to receive pivot set. Determine
pivot location using dimensions on reverse side. The pivots are handed and must match
hand of door. To determine hand of door and proper pivot position, see diagrams above.
Install top and bottom pivot sets before installing intermediate pivot.
2. Locate, drill, and tap 1/4-20 mounting holes for metal door or metal frame. Locate and drill
pilot holes for #14 wood screws for wood door or wood frame. Then hang door.
3. Open door about 90°. Install pivot leafs with 1/4-20 x 3/4” FHMS or #14 FHWS screws provided.
4. The door weight should be balanced between bottom and intermediate pivots. Refer to
diagram above. To adjust intermediate pivot:
A. Use 5/32” Allen wrench to remove pivot cap from frame leaf.
B. Insert Allen wrench into pivot pin height adjuster.
C. Turn clockwise until pivot pin makes contact with steel ball inside door leaf.
D. Adjust carefully to balance the weight of the door.
5. Re-install pivot cap.
Left hand
installation
Right hand
installation
Right hand
installation shown;
left hand opposite
Door leaf
Frame
leaf
5/32” Allen
wrench
Pivot
cap
Pivot pin height
adjuster
Installation Instructions
26366 Rev. 3
© 2006 Ingersoll-Rand Company Limited
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
