iSpring GA1-AW - User Manual
iSpring GA1-AW Water Dispenser – User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
iSpring
Water
Systems
Installing the Drinking Water Faucet
1.
If your kitchen sink does not have an existing 1/2” hole, you will have to
drill one. (Refer to How to drill a Hole in Your Sink or Counter-top in our RO
User Manual). Wipe clean and dry the area.
1/2”
3.
Slide the quick connect
fitting up the push-in adapter
on the base so that it seats
securely into the faucet stem,
then lock it in place by sliding
the blue clip under the collet.
Insert the
BLUE
tubing about
1/2 inch into the push-in
fitting, and again, secure it
with the blue clip.
*To connect, insert the tubing 1/2 inch
deep until it’s sealed by o-ring and
locked by spider teeth.
*To disconnect, remove blue clip, pull
the tubing while pushing down the
collet to release the spider teeth.
2.
Slide the front plate and front washer onto the
faucet stem. Insert the faucet stem into the hole on the
countertop. Under the sink, insert back washer and
tighten the wing nut (you
may apply a few rounds of
Teflon tape to the threads to
get a better grip).
Scan to Register and
Activate Your 3-Year
Manufacturer
Warranty Today!
* 1/4” and 3/8” adapters are included.
Pick one that fits your plumbing.
iSpring
Water
Systems
Installing the Drinking Water Faucet
1.
If your kitchen sink does not have an existing 1/2” hole, you will have to
drill one. (Refer to How to drill a Hole in Your Sink or Counter-top in our RO
User Manual). Wipe clean and dry the area.
1/2”
3.
Slide the quick connect
fitting up the push-in adapter
on the base so that it seats
securely into the faucet stem,
then lock it in place by sliding
the blue clip under the collet.
Insert the
BLUE
tubing about
1/2 inch into the push-in
fitting, and again, secure it
with the blue clip.
*To connect, insert the tubing 1/2 inch
deep until it’s sealed by o-ring and
locked by spider teeth.
*To disconnect, remove blue clip, pull
the tubing while pushing down the
collet to release the spider teeth.
2.
Slide the front plate and front washer onto the
faucet stem. Insert the faucet stem into the hole on the
countertop. Under the sink, insert back washer and
tighten the wing nut (you
may apply a few rounds of
Teflon tape to the threads to
get a better grip).
Scan to Register and
Activate Your 3-Year
Manufacturer
Warranty Today!
* 1/4” and 3/8” adapters are included.
Pick one that fits your plumbing.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
