Page 2 - WARNING; SPECIAL NOTES; NOTICE; ACCESSORY WARNING
SPECIAL NOTES MA80 Series 2 Part No 1148138 WARNING DO NOT use this product or any available optional equipment without first completely reading and understanding these instructions and any additional instructional material such as owner’s manuals, service manuals or instruction sheets supplied with...
Page 3 - TABLE OF CONTENTS
TABLE OF CONTENTS Part No 1148138 3 MA80 Series TABLE OF CONTENTS SPECIAL NOTES ................................................................................ 2REGISTER YOUR PRODUCT ............................................................... 4TYPICAL PRODUCT PARAMETERS ...........................
Page 5 - TYPICAL PRODUCT PARAMETERS; Electrical Parameters
TYPICAL PRODUCT PARAMETERS Part No 1148138 5 MA80 Series TYPICAL PRODUCT PARAMETERS Electrical Parameters Performance Parameters Mechanical Parameters MA80/MA85 INPUT VOLTAGE AC: 90 V INPUT FREQUENCY: 60 Hz CURRENT: 2 A MAXIMUM POWER CONSUMPTION: 150 ± 10 W CIRCUIT PROTECTION: Dual fused, 250 V, 5 A...
Page 6 - Environmental Parameters
TYPICAL PRODUCT PARAMETERS MA80 Series 6 Part No 1148138 Environmental Parameters MA80/MA85 OPERATING CONDITIONS AMBIENT TEMPERATURE: RELATIVE HUMIDITY: ATMOSPHERIC PRESSURE: 50° - 104° F 30% - 75% Non-Condensing 70 - 106 kPa STORAGE AND SHIPPING CONDITIONS AMBIENT TEMPERATURE: RELATIVE HUMIDITY: AT...
Page 7 - LABEL LOCATION; ATTENTION
LABEL LOCATION Part No 1148138 7 MA80 Series LABEL LOCATION DANGER-EXPLOSION HAZARD: DO NOT use in the presence of flammable anesthetics.CAUTION: Equipment should be connected to a properly grounded receptacle (3-prong). Risk of Electrical shock. DO NOT remove back. Disconnect air hose before admini...
Page 8 - SECTION 1—GENERAL GUIDELINES; Contraindications
SECTION 1—GENERAL GUIDELINES MA80 Series 8 Part No 1148138 SECTION 1—GENERAL GUIDELINES WARNING SECTION 1 - GENERAL GUIDELINES contains important information for the safe operation and use of this product. Contraindications ALWAYS consult the patient’s physician before using the MA80 and MA85 system...
Page 9 - Fire Hazard; Anesthesia Equipment; Oxygen; Electrical; DANGER
SECTION 1—GENERAL GUIDELINES Part No 1148138 9 MA80 Series Fire Hazard DANGER Smoking DO NOT SMOKE while using this device. This system uses room air for circulation through the mattress. A cigarette can burn a hole in the bed surface and cause damage to the mattress. Also, patient clothing, bed she...
Page 10 - SECTION 2—OPERATION; CAUTION; Installing the Mattress Replacement System; CAUTION
SECTION 2—OPERATION MA80 Series 10 Part No 1148138 SECTION 2—OPERATION CAUTION The control unit and mattress on the MA80 series are designed to be used as a system. DO NOT replace mattresses or control units with other models or other brands. Otherwise, damage to the system may occur. Contact your s...
Page 11 - Installing the Side Rails; Installing the Control Unit
SECTION 2—OPERATION Part No 1148138 11 MA80 Series FIGURE 2.1 Installing the Mattress Replacement System Installing the Side Rails WARNING Patient entrapment with bed side rails may cause injury or death. Mattress MUST fit bed frame and side rails snugly to prevent patient entrapment. Follow the man...
Page 12 - Connecting the Hose
SECTION 2—OPERATION MA80 Series 12 Part No 1148138 Connecting the Hose CAUTION Ensure that the hose connecting the control unit to the mattress is routed such that it cannot be stepped on, kinked, squeezed or otherwise damaged. NOTE: For this procedure, refer to FIGURE 2.3. 1. Locate the hose at the...
Page 13 - Connecting the Power Cord
SECTION 2—OPERATION Part No 1148138 13 MA80 Series Connecting the Power Cord WARNING DO NOT alter plug to fit a non-conforming outlet. Instead, have an electrician install a properly grounded outlet. Failure to use the correct plug and outlet can result in a potential safety hazard. CAUTION Ensure t...
Page 14 - Power Button
SECTION 2—OPERATION MA80 Series 14 Part No 1148138 Using the Front Panel NOTE: For this procedure, refer to FIGURE 2.5. FIGURE 2.5 Using the Front Panel Power Button 1. To turn the control unit on or off, press and release the Power button ( ). NOTE: Once the unit is plugged in, an AMBER LED on the ...
Page 16 - Static Button; Fowler Button
SECTION 2—OPERATION MA80 Series 16 Part No 1148138 Static Button 1. Press the Static button ( ) to select the static mode and maintain the mattress at constant pressure. NOTE: The Static LED is illuminated GREEN. Firm/Soft Buttons 1. Select comfort pressure settings by pressing Firm ( ) or Soft ( ) ...
Page 17 - Max Inflate Button; Lock/Alarm Silence Button; Power Fail LED
SECTION 2—OPERATION Part No 1148138 17 MA80 Series 5. Perform one of the following: • Cancel - Press the Fowler button to exit Fowler Transmitter Setup without linking to a transmitter. • Save - Wait 60 seconds without pressing a key. Max Inflate Button 1. Press the Max Inflate button ( ) to select ...
Page 18 - Powering Up the System
SECTION 2—OPERATION MA80 Series 18 Part No 1148138 Powering Up the System NOTE: For this procedure, refer to FIGURE 2.5 on page 14. 1. Turn on the power to the system by pressing the Power button on the control unit. NOTE: Once the button is released, a GREEN LED illuminates when the unit is on. Pla...
Page 19 - Transferring Patient From/To a Gurney; Transferring Patient From/To a Wheelchair; Preparing for CPR Procedure
SECTION 2—OPERATION Part No 1148138 19 MA80 Series Transferring Patient From/To a Gurney WARNING ALWAYS engage the wheel locks of the bed and the wheel locks of the gurney before transferring the patient between the bed and the gurney. 1. Engage the wheel locks of the bed. Refer to the owner’s manua...
Page 21 - SECTION 3—MAINTENANCE AND; Cleaning the System
SECTION 3—MAINTENANCE AND TROUBLESHOOTING Part No 1148138 21 MA80 Series SECTION 3—MAINTENANCE AND TROUBLESHOOTING Cleaning the System WARNING Before cleaning or disassembling the MA80 series, check the underside of the mattress folds for sharp objects such as scissors, needles, etc. These objects s...
Page 22 - Storing the System
SECTION 3—MAINTENANCE AND TROUBLESHOOTING MA80 Series 22 Part No 1148138 CAUTION Laundry workers should always wash their hands before working with clean bedding.DO NOT overload the machine.DO NOT use chlorine bleach because it may damage the fabric coating.High air temperatures will damage the fabr...
Page 23 - Changing the Filter; Troubleshooting
SECTION 3—MAINTENANCE AND TROUBLESHOOTING Part No 1148138 23 MA80 Series Changing the Filter NOTE: For this procedure, refer to FIGURE 3.1. Clean the filter every 5 months or whenever it is dirty. 1. Remove the two screws securing the filter cover to the back of the control unit. 2. Remove the filte...
Page 24 - LIMITED WARRANTY
LIMITED WARRANTY PLEASE NOTE: THE WARRANTY BELOW HAS BEEN DRAFTED TO COMPLY WITH FEDERAL LAW APPLICABLE TO PRODUCTS MANUFACTURED AFTER JULY 4, 1975. This warranty is extended only to the original purchaser who purchases this product when new and unused from Invacare or a dealer. This warranty is not...
