Invacare 9153644018 - Manual
Invacare 9153644018 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – CAUTION; Two (2) mounting screws are used to secure the front rigging support; Installing Front Rigging Support Brackets; DETAIL “A”
- Page 3 – Installing; FIGURE 2; Installing/Removing the Front Rigging Assembly; Outside of
- Page 4 – Remove the hex screw and coved spacer.; FIGURE 3; Adjusting Footrest Height
1
Installing Front Riggings on the At’m
For more information regarding Invacare products, parts, and services,
please visit www.invacare.com
Installing Front Riggings on the At’m
Kit Numbers: 9153644014, 9153644018
NOTE: Check all parts for shipping damage. In case of damage, DO NOT use. Contact
Carrier/Invacare for further instructions.
Safety Summary
To ensure the safe and proper installation and use of the front riggings on the At’m, these
instructions
MUST
be followed:
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure that all
attaching hardware is tightened securely - otherwise injury or damage may result.
Invacare products are specifically designed and manufactured for use in conjunction
with Invacare accessories. Accessories designed by other manufacturers have not
been tested by Invacare and are not recommended for use with Invacare products.
Description of the Kit
Kit Numbers 9153644014 and 9153644018 for Red or Blue At’m Front Riggings contain:
Installing Front Rigging Support Brackets
NOTE: For this procedure, refer to FIGURE 1.
NOTE: Perform the following steps one (1) side at a time.
1. Remove the plug button from the seat frame tube.
2. Note the orientation of the hardware that connects front seat support tube to the seat
frame tube.
3. Remove the mounting screw, coved washers, spacers, washers and locknut securing
front seat support tube to the seat frame tube. DO NOT discard.
Assembly, Installation and Operating Instructions
SAVE THESE INSTRUCTIONS
PART NUMBER
DESCRIPTION
QUANTITY
1132651
Right Legrest Support Assembly
1
1132652
Left Legrest Support Assembly
1
1133151
Mounting Hardware Assembly
1
1134702
70° Complete Right Footrest Assembly
1
1134703
70° Complete Left Footrest Assembly
1
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Installing Front Riggings on the At’m 2 Part No 1130250 4. Insert the proper (right or left) front rigging support bracket into the seat frame tube until two (2) of the four (4) mounting holes on the front rigging support bracket are aligned with the two (2) mounting holes in the seat frame tube. CA...
Part No 1130250 3 Installing Front Riggings on the At’m Installing/Removing the Front Rigging Assembly NOTE: For this procedure, refer to FIGURE 2. Installing 1. Turn the front rigging assembly to the side (open footrest is perpendicular to the wheelchair). 2. Insert the mounting pin on the front ri...
Adjusting Footrest Height NOTE: For this procedure, refer to FIGURE 3. 1. Remove the front rigging assembly. Refer to Installing/Removing the Front Rigging Assembly on page 3. 2. Remove the hex screw and coved spacer. 3. Move the footrest with slide tube up or down on its mounting tube until the des...
