Invacare 6358 - Manual

For more information regarding Invacare products, parts, and services, please visit www.invacare.com

Part No 1020707

1

Mobile Shower Commode Chair

Mobile Shower Commode Chair

Model 6358

SAVE THESE INSTRUCTIONS

NOTE:

 

Check

 

ALL

 

parts

 

for

 

shipping

 

damage.

 

If

 

shipping

 

damage

 

is

 

noted,

 

DO

 

NOT

 

use.

 

Contact

 

carrier/dealer

 

for

 

further

 

instruction.

WARNING

•

DO NOT install or use this equipment without first reading and understanding these instructions. If you are

unable to understand the Warnings, Cautions or Instructions, contact a healthcare professional, dealer or

technical personnel before attempting to use this equipment - otherwise, injury or damage may occur.

•

All four casters MUST be in contact with the floor at all times.

•

ALWAYS inspect the mobile shower commode chair to ensure that it is properly positioned and stable

before using. DO NOT use if wobbly or unstable.

•

Users with limited physical capabilities should be supervised or assisted when using the mobile shower

commode chair.

•

The mobile shower commode chair is not to be used as a transfer bench, transfer device or climbing device.

•

Exercise caution when assembling to avoid pinching.

•

After ANY adjustments, repair or service and BEFORE use, make sure that all attaching component parts

are secure.

•

The mobile shower commode chair has a weight limitation of 250 lbs (114 kg).

•

ALWAYS observe the weight limit on the labeling of your product. Check that all labels are present and

legible. Replace if necessary.

ACCESSORIES WARNING

•

Invacare products are specifically designed and manufactured for use in conjunction with Invacare

accessories. Accessories designed by other manufacturers have not been tested by Invacare and are not

recommended for use with Invacare products.

Assembling the Mobile Shower Commode Chair

NOTE:

 

For

 

this

 

procedure,

 

refer

 

to

 

FIGURE 1.

NOTE:

 

To

 

disassemble

 

the

 

mobile

 

shower

 

commode

 

chair,

 

reverse

 

this

 

procedure.

1.

Press

 

down

 

on

 

the

 

tab

 

on

 

the

 

caster

 

with

 

your

 

foot

 

until

 

the

 

lock

 

is

 

engaged.

 

Repeat

 

until

 

all

 

four

 

casters

 

are

 

locked.

2.

Align

 

the

 

holes

 

in

 

the

 

back

 

support

 

with

 

the

 

holes

 

on

 

the

 

frame.

 

Attach

 

the

 

back

 

support

 

to

 

the

 

frame

 

with

 

four

 

screws

 

and

 

nuts.

3.

Tighten

 

all

 

hardware.

4.

Put

 

the

 

pail

 

and

 

lid

 

in

 

place

 

on

 

the

 

pail

 

holders.

NOTE:

 

To

 

allow

 

the

 

seat

 

to

 

easily

 

pivot,

 

apply

 

a

 

small

 

amount

 

of

 

Vaseline®

 

or

 

furniture

 

polish

 

to

 

the

 

seat

 

clamps

 

before

 

snapping

 

them

 

into

 

place

 

on

 

the

 

back

 

frame

 

rail.

5.

Put

 

the

 

seat

 

onto

 

the

 

back

 

frame

 

rail.

NOTE:

 

When

 

installed

 

properly,

 

each

 

seat

 

clamp

 

is

 

positioned

 

outside

 

the

 

pail

 

holders

 

(DETAIL

 

“A”).

6.

Push

 

down

 

on

 

the

 

seat

 

until

 

it

 

snaps

 

firmly

 

into

 

place

 

onto

 

the

 

back

 

frame

 

rail.

Cleaning the Mobile Shower

Commode Chair

Use

 

a

 

soft,

 

damp

 

cloth

 

and

 

mild

 

soap

 

to

 

clean

 

the

 

shower

 

chair.

FIGURE 1

Assembling the Mobile Shower Commode Chair

Assembly, Installation and Operating Instructions

Back Support

Frame

Screw

(1 of 4)

Nut

(1 of 4)

Pail

Lid

DETAIL “A” - BOTTOM VIEW

Pail

Holders

Seat

Seat Clamps

(outside of the

Pail Holders

on the back

frame rail)

Pail Holders