Invacare 1496 - Manual
Invacare 1496 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
NOTE: Check all parts for shipping damage. If ship-
ping damage is noted, DO NOT use. Contact Dealer/
Invacare for further instructions.
SAFETY SUMMARY
The following recommendations are made for the
safe installation of the IV/O2 Cylinder Holder
Accessory Kit:
WA R N I N G
DO NOT assemble or use this equipment
without first reading and understanding
this instruction sheet. If you are unable to
understand the Warnings, Cautions or In-
structions, contact a healthcare profes-
sional, dealer or technical personnel if ap-
plicable before attempting to install this
equipment - otherwise, injury or damage
may occur.
After ANY adjustments, repair or service
and BEFORE use, make sure all attach-
i n g h a r d w a r e i s t i g h t e n e d s e c u r e l y .
Follow the Oxygen Cylinder manufactur-
ers guidelines for proper usage of the oxy-
gen cylinder.
INSTALLING IV/O2 CYLINDER
HOLDER (FIGURE 1)
NOTE: IF rear step tube is 7/8-inch diameter tubing, in-
stall the long tube guide insert into the rear step tube be-
fore installing the IV/O2 cylinder holder.
1. Place the IV/O2 cylinder holder and slide it onto the
rear step tube of the wheelchair.
NOTE: IF rear upright tubing is 7/8-inch diameter tub-
ing, install the short tube guide insert over the rear
upright before installing and securing the IV/O2 cylin-
der holder bracket.
2. Push the bracket of the IV/O2 cylinder holder over the
rear upright of the wheelchair and secure in place with
the hex screw, spacer and locknut.
3. Secure IV/O2 cylinder holder to push handle using a
ty-wrap.
4. Loosen the short adjustment knob to move IV/O2
cylinder holder to desired height and then retighten.
5. Use the long adjustment knob on the IV/O2 cylinder
holder bracket to secure the oxygen cylinder in place.
Spacer
Rear Step
Tube
IV/O2 Cylinder Holder
Ty-wrap
Short
Adjustment
Knob
Long
Adjustment
Knob
Short
Tube
Guide
Insert
Long Tube Guide
Insert
Locknut
Rear
Upright
Push
Handle
FIGURE 1 - INSTALLING IV/O2 CYLINDER
H O L D E R
Hex
Screw
Bracket
I.V./O
2
Cylinder Holder Accessory Kit
Assembly, Installation and Operating Instructions
Model Nos. 1487,1496 and T1496
Invacare Corporation
www.invacare.com
USA
Canada
One Invacare Way
5970 Chedworth Way
Invacare
®
and Yes, you can. are trademarks of Invacare
Elyria, Ohio USA
Mississauga, Ontario
Corporation.
44036-2125
L5R 3T9, Canada
© 2000 Invacare Corporation
800-333-6900
905-890-8838
Form No. 91-201 Part No. 1027931
Rev E (1) 12/00
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
