Invacare 1183379-A - Manual
Invacare 1183379-A – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Safety; General Guidelines; Operating Information
- Page 3 – Setup; Assembling the Freestanding Rail
- Page 4 – Installing the Hoist
- Page 5 – After Use
- Page 6 – Troubleshooting Table; Technical Data; Typical Product Parameters; Freestanding rail system
- Page 7 – Warranty; Limited Warranty — Europe
- Page 8 – Making Life’s Experiences PossibleTM
This manual MUST be given to the user of the product.
BEFORE using this product, read this manual and save for future reference.
I
EN
I
1 General
1.1 Symbols
Signal words are used in this manual and apply to hazards or unsafe
practices which could result in personal injury or property damage.
See the information below for definitions of the signal words.
WARNING!
–
Warning indicates a potentially hazardous situation
which, if not avoided, could result in death or serious
injury.
CAUTION!
–
Caution indicates a potentially hazardous situation
which, if not avoided, may result in property damage
or minor injury or both.
IMPORTANT
–
Indicates a hazardous situation that could result in
damage to property if it is not avoided.
Gives useful tips, recommendations and information for
efficient, trouble-free use.
This product complies with Directive 93/42/EEC
concerning medical devices.
The launch date of this product is stated in the EC
declaration of conformity.
1.2 Intended Use
I-Transia is a hoist which covers the need for lifting or moving a
person with disabilities in the home care sector, nursing homes,
rehabilitation centres, and institutions.
The freestanding rail system is a portable rail system which can be set
up in many locations* and requires no mounting on walls, ceiling or
floors. The freestanding rail system is length and height adjustable.
*The freestanding rail system and hoist are not designed for
use in moist or wet areas.
1.3 Conditions for Use
The use of the I-Transia hoist is subject to the following:
•
The I-Transia should only be used by trained personnel.
•
The safe working load (SWL), 205 kg (450 lbs) or 250 kg (550
lbs), must not be exceeded. Refer to 2.3 Load Limits, page 2 .
•
The instruction offered by Invacare to all customer groups in
connection with the purchase of a hoist has been received.
•
The caregiver pays attention to the well-being of the user when
using the hoist.
•
The hoist is used in rail systems which are installed, tested and
approved according to DS/EN 10535 and Invacare’s stipulations.
•
Only technicians who have been certified by Invacare may install
and test the rail systems.
•
The hoist is used with an Invacare hanger bar.
•
The hoist is used with an Invacare lifting sling or with other
suitable slings. Refer to the I-Transia hoist user manual for more
information about slings. .
1.4 Service Life
The I-Transia freestanding rail system has an expected lifetime of 15
years, if used according to the procedures in this manual.
Invacare
®
I-Transia™
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
I-Transia™ 2 Safety 2.1 General Guidelines WARNING! – Read and understand these instructions. DO NOT use this product without reading and understandingthese instructions and the hoist user manual. If youneed help with these instructions, contact a healthcareprofessional or an Invacare dealer. Otherw...
2.4 Product Labeling Item Label Text 1 WARNING Tighten top wing knob nuts firmly by hand before system usage. 2 3 3 Setup 3.1 Included Items Each kit contains the following items: 1. Top bracket and rail module 2. Vertical pole module (x2) 3. User manual, part number 1183379 (not shown) 4. Hoist* 5....
I-Transia™ 5. Open the legs of the second vertical pole module. 6. Raise the second vertical pole module B . 7. Lift the other end of the top bracket and rail module C and mount it on top of the vertical pole module C . The top bracket must be flush with the mark on thevertical pole G . 8. Lock the ...
