Invacare 1145547 - Manual
Invacare 1145547 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – FIGURE 1; Removing/Installing Handrims with Rivnuts
- Page 3 – Removing/Installing Handrims with Tabs; NOTE: The outside of the wheel should be facing down.
- Page 4 – FIGURE 2
- Page 5 – NOTES
- Page 7 – LIMITED WARRANTY
1
For more information regarding Invacare products, parts, and services,
please visit www.invacare.com
Natural-Fit Handrims
Part Numbers: 1145545, 1145546, 1145547, 1145548, 1145549,
1145550, 1145551, 1145552, 1145553, 1145554
NOTE: Check all parts for shipping damage. In case of shipping damage, DO NOT use. Contact
Invacare for further instruction.
Safety Summary
To ensure the safe and proper installation of the handrims, these instructions MUST
be
followed:
WARNING
DO NOT install this equipment without first reading and understanding this
instruction sheet. If you are unable to understand the warnings, cautions and
instructions, contact Invacare, before attempting to install this equipment -
otherwise, injury or damage may occur.
Invacare products are specifically designed and manufactured for use in conjunction
with Invacare accessories. Accessories designed by other manufacturers have not
been tested by Invacare and are not recommended for use with Invacare products.
INSTALLATION WARNING
This procedure MUST be performed by a qualified technician.
After any adjustments, repair or service and before use, make sure that all attaching
component parts are secure.
Proper installation is critical to the performance of the handrim.
Removing/Installing Handrims with Rivnuts
®
NOTE: For this procedure, refer to FIGURE 1 on page 2.
Tool Needed:
• Phillips
®
head screwdriver
1. Remove the wheel from the wheelchair. Refer to the wheelchair owner ’s manual.
2. Remove the mounting screws that secure the existing handrim to the wheel.
3. Place the Natural Fit handrim on a flat surface with the rivnuts facing up.
4. Place the thumb guard on top of the handrim.
NOTE: The thumb guard is installed on the outside of the wheelchair with wider edge making
contact with the wheel.
5. Place the wheel on top of the thumb guard and handrim.
NOTE: The outside of the wheel should be facing down.
Assembly and Installation Instructions
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Natural-Fit Handrims 2 Part No. 1144492 6. Insert the new mounting screws through the wheel and the new spacers. 7. Thread the mounting screw into the rivnuts on the handrim. NOTE: DO NOT tighten the screws. NOTE: Screws and spacers are provided. DO NOT use the old screws and spacers, you may damage...
Part No. 1144492 3 Natural-Fit Handrims Removing/Installing Handrims with Tabs NOTE: For this procedure, refer to FIGURE 2 on page 4. Tools Needed: • Phillips head screwdriver • 3/8” wrench • Air pump • Tire irons (tools to remove the tire) - if necessary • Pliers - if necessary 1. Remove the wheel ...
Natural-Fit Handrims 4 Part No. 1144492 FIGURE 2 Removing/Installing Handrims with Tabs Handrim Thumb Guard Wheel Tabs Tab Locknut Screw DETAIL “A” - ATTACHING THE HANDRIM DETAIL “B” - SECURING THE HANDRIM Hook and Loop Strap Hook and Loop Strap Wheel Handrim
