Insignia NS-PS10CC - Manual

Using the shredder

Warning

: Always turn off the shredder when it is not in use.

Caution

: Do not insert more than 10 sheets of paper, one credit card, or one disc at a

time. You may damage the shredder.

To shred paper:

Insert paper into the paper or disc slot. When the paper has passed
through, the shredder will stop.

Caution

: Always feed paper in as straight as possible to avoid paper jams.

To shred discs and credit cards:

Hold the disc or credit card by the edge and feed
into the paper or disc slot one at a time, releasing
when shredding begins. The shredder stops when
the entire disc or credit card has been destroyed.

Caution

: Do not hold the disc with your finger through

the center hole while feeding it into the shredder.
Serious injury may occur. Never feed more than one disc
or credit card at a time.

Notes

:

• Never shred plastic (except credit cards, CDs, or DVDs), continuous forms, anything

with adhesive including labels and envelopes, newsprint, or any hard materials.

• While this shredder will shred staples and small paperclips, it is recommended that

you remove them whenever possible to extend the life of your shredder.

LEDs

Setting up the shredder

1

Place the shredder head securely on the rim of

the supplied wastebasket.

Caution

: Your shredder has very sharp, exposed

blades on the underside. Use care when mounting the
shredder to the wastebasket.

Note

: Do not use bags to line the wastebasket.

2

Connect the power cord to a power outlet.

3

Slide the power switch from

off

to

auto

.

auto

The shredder starts automatically when an item is inserted into the paper or disc slot.

When the item has passed through the slot, the shredder stops.

off

Turns off the shredder.

rev

Use the reverse setting to clear a paper jam or to pull out unshredded paper.

Caution

: Never try to clear a jam by using REV when the wastebasket is full. This could make the jam

worse.

Power

Overheat/Overload

Door Open

Lights green when the shredder is in use. Turns off when the shredder is in
standy-by (power-saving) mode.

Lights red when the shredder is jammed or overheated, you have inserted
more sheets of paper than recommended or the shredder has been used
too long.

Lights yellow if the wastebasket is opened or the shredder head is not
mounted correctly.

Quick Setup Guide

Crosscut Paper Shredder | NS-PS10CC

Before using your new product, please read these instructions to prevent any damage.

Features

Power switch

Handle

Power switch

Paper or disc slot

Shredder head

Wastebasket

1

LEDs

NS-PS10CC_14-0476_QSG_V2_EN.ai 1 5/6/2014 3:16:05 PM

NS-PS10CC_14-0476_QSG_V2_EN.ai 1 5/6/2014 3:16:05 PM