Ingersoll Rand SRV125F - Manual
Ingersoll Rand SRV125F – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – USING THE VALVE; This product is not insulated against electric shock.; WARNING SYMBOL IDENTIFICATION; N OT I C E; WARNING
- Page 3 – EXPLODED VIEW AND PARTS LIST; When ordering, use applicable part number; SERIES SRV125F STARTER RELAY VALVE
- Page 4 – OPTIONAL EQUIPMENT
- Page 5 – PLACING THE STARTER RELAY VALVE IN SERVICE; Do not over tighten the air line connections.; vertical; Installation; Push the two clamp halves inward as far as they will go.; WA R N I N G
- Page 6 – MAINTENANCE; Lubrication; Periodically lubricate the Starter Relay Valve as follows:; Installation of the Tune Up Kit; Disassembly of the Starter Relay Valve; Bleed off the air pressure.; Assembly of the Starter Relay Valve; Place the End Plug Assembly on the Piston Spring.
- Page 7 – NOTES
1
P7630 Edition 1
Form P7648
Edition 1
August 2004
CCN 04579728
Operation and Maintenance Manual
for
Series SRV125F
Starter Relay Valve
Series SRV125F Starter Relay valves are designed for controlling fluid flow in conjunction with Air Starting
Systems
.
• IMPORTANT SAFETY INFORMATION ENCLOSED - SAVE THESE INSTRUCTIONS.
•
Read and understand this manual before operating Valve.
• Failure to observe the following warnings could result in injury.
PLACING THE VALVE IN SERVICE
•
Always install, operate, inspect and maintain this prod-
uct in accordance with all applicable standards and reg-
ulations (local, state, country, federal, etc.).
•
Always use clean, dry air at a pressure which does not
exceed the pressure rating listed on the valve.
•
Do not use damaged, frayed or deteriorated air hoses &
fittings.
•
Always turn off the air and disconnect the air hose
before installing, removing or adjusting any accessory
on this valve, or before performing any maintenance on
this valve or accessory.
•
Do not lubricate the valve with flammable or volatile
liquids such as kerosene, diesel or jet fuel, use only
recommended lubricants.
•
Series SRV125F Valves are not designed for working
in explosive atmospheres.
•
Do not remove any labels, replace any damaged labels.
•
Operate this valve only when properly installed in the
Air Starting System.
•
Always bleed off the air pressure before attempting to
remove the Starter Relay Valve from the Receiver or
before attempting to perform any maintenance on the
Starter Relay Valve.
•
Never attempt to remove the Retaining Ring (12) from
the bottom side of the Starter Relay Valve until the air
pressure has bled off. If the Retaining Ring is removed
while there is pressure in the Receiver, internal parts of
the Starter Relay Valve will be blown out with consid-
erable force.
•
Use only recommended
Ingersoll-Rand
accessories.
N OT I C E
WA R N I N G
Refer All Communications to the Nearest
Ingersoll-Rand Office or Distributor.
© Ingersoll-Rand Company 2004
Printed in U.S.A
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 P7648 Edition 1 USING THE VALVE • This product is not designed for working in explosive environments, including those caused by fumes & dust, or near flammable materials. • This product is not insulated against electric shock. • Never use a damaged or malfunctioning product or accessory. • Do ...
3 P7648 Edition 1 EXPLODED VIEW AND PARTS LIST (Dwg. TP2184) Item Part Description Part Number Item Part Descri ption Part Number 1 Valve Housing . . . . . . . . . . . . . . . . . . . . SRV125F-40 10 End Plug . . . . . . . . . . . . . . . . . . . . . . . . . SRV150-338 2 Pipe Plug (2 required) . . ....
4 P7648 Edition 1 OPTIONAL EQUIPMENT (Dwg. TP2212) Item Part Descri ption Part Number Item Part Descripti on Par t Number Solenoid and Mounting Hardware - Position 1 Pilot Port Hardware - Position 2 A Solenoid L 90° Elbow with Push to Lock . . . . . . . . . EL90-4M4DOT 12 Volt, Pioneer Connections ....
