Ingersoll Rand 656652B - Manual

Ingersoll Rand 656652B

Ingersoll Rand 656652B – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
Page: / 8

Table of Contents:

  • Page 2 – AIR MOTOR PARTS LIST; DISASSEMBLY OF AIR MOTOR
  • Page 3 – AIR MOTOR HEAD
  • Page 5 – AIR MOTOR PISTON ROD AND BASE
  • Page 6 – REASSEMBLY OF AIR MOTOR
  • Page 7 – TROUBLE SHOOTING
  • Page 8 – ITEM 52 PISTON ROD END VARIETY
Loading the manual

2001

PRINTED IN U.S.A.

(419) 636-4242

FAX (419) 633-1674

INGERSOLL-RAND COMPANY

P.O. BOX 151

ONE ARO CENTER

BRYAN, OHIO 43506Ć0151

OPERATOR’S MANUAL

INCLUDING: OPERATION, INSTALLATION & MAINTENANCE

6564X-X
6566X-X

66620

RELEASED:

8-28-91

REVISED:

10-11-01

(REV. K)

6” AIR MOTORS

READ THIS MANUAL CAREFULLY BEFORE INSTALLING,

OPERATING OR SERVICING THIS EQUIPMENT.

6564X-X and 66620

4” STROKE

6566X-X

6” STROKE

THIS MANUAL COVERS THE FOLLOWING MODELS

MODEL

65643

65662

65665Ć2B

66620

65645

65665ĆB

65666

SERVICE KITS

61355 for general repair of all 6" air motors.

GENERAL DESCRIPTION

The 6" air motor is a general purpose power unit and is used with many

2Ćball, 4Ćball and chop check pumps. It utilizes tie rod type construction

for easy breakdown and it connects to the various lower ends via tie rods

for easy operation. Consult pump model operator's manual for specific

instructions. It is recommended that a muffler be connected to the exĆ

haust port to reduce noise to acceptable OSHA standards.

Filtered and oiled air will allow the air motor to operate more efficiently

and yield a longer life to operating parts and mechanisms. A filter capaĆ

ble of filtering particles larger than 50 microns should be used with an

oiler. Keep the oiler supplied with a good grade of S.A.E. no. 90W nonĆ

detergent gear oil, set at a rate not to exceed 1 or 2 drops per minute.

NOTICE

DO NOT OPERATE AIR MOTOR ABOVE RECOMMENDED

AIR PRESSURE OF 150 P.S.I. (10.3 BAR) OR 75 CYCLES PER

MINUTE.

Air motor may be rated differently in the next assembly.

Check model plate.

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - AIR MOTOR PARTS LIST; DISASSEMBLY OF AIR MOTOR

PAGE 2 OF 8 6564XĆX AIR MOTOR PARTS LIST PARTS SO MARKED ARE INCLUDED IN 61355 SERVICE KIT. REF. DESCRIPTION (SIZE IN INCHES) QTY PART NO. REF. DESCRIPTION (SIZE IN INCHES) QTY PART NO. 1 Machine Screw (#8 Ć 32 x 7/8") 4 Y136Ć90ĆS 2 Deflector 1 90409 Deflector (model 65665Ć2B) 1 90409Ć1 3 Screw ...

Page 3 - AIR MOTOR HEAD

31 8 9 10 11 12 13 14 15 16 17 18 19 23 21 22 24 32 33 34 35 36 38 42 43 44 40 3 1 2 6 7 FIGURE 2 NOTE: LUBRICATE WITH PARKER‘‘O” RING LUBE (ARO P/N 36460). FIGURE 3 5 4 25 37 39 45 20 41 31 42 PAGE 3 OF 8 6564XĆX AIR MOTOR HEAD PART NUMBERS LISTED BELOW AND ON PARTS LIST (OPPOSITE PAGE) ARE TYPICAL...

Page 5 - AIR MOTOR PISTON ROD AND BASE

FIGURE 4 NOTE: LUBRICATE WITH PARKER‘‘O” RING LUBE (ARO P/N 36460). 46 26 27 28 17 30 29 47 20 50 51 52 48 49 PAGE 5 OF 8 6564XĆX AIR MOTOR PISTON ROD AND BASE SEE CHART ON OPPOSITE PAGE FOR EACH MODEL. DISASSEMBLY OF AIR MOTOR (CONTINUED) 16. Remove the (37) upper gland. 17. Remove the (38) seal an...

Other Ingersoll Rand Models