Ingersoll Rand 651747-2-M - Manual
Ingersoll Rand 651747-2-M – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
OPERATOR’S MANUAL
651747-2-M
RELEASED:
4-1-03
REVISED:
1-24-11
(REV. E)
INCLUDING: OPERATION, INSTALLATION & MAINTENANCE
STAINLESS STEEL FLUID HEATER
READ THIS MANUAL CAREFULLY BEFORE INSTALLING,
OPERATING OR SERVICING THIS EQUIPMENT.
It is the responsibility of the employer to place this information in the hands of the operator. Keep for future reference.
GENERAL DESCRIPTION
The Aro stainless steel fluid heater models are wired for 220 volt AC ap-
plications. The heating element is a 2000 watt cartridge type and is ther-
mostatically controlled. The wiring, heating element and thermostat are
protected by a preset heat limiter.
The thermostat is adjustable up to approximately 121
_
C (250
_
F). The
heater is off when the thermostat knob is turned counterclockwise as far
as possible. The heater will not switch on until the knob is rotated to at
least ambient room temperature.
Fluid heaters have been tested in water soluble oil. Some of this fluid
may be left within the heater, therefore flush out this fluid with a solvent
compatible with the material to be pumped.
•
This unit utilizes an explosion-proof electrical section and internally
spiraling material section. The material enters the base under line
pressure from the pump and is heated and delivered thru to the ma-
terial outlet at the top.
•
Two or more paint heaters may be coupled together by plumbing the
material outlet of the first heater to the material inlet of the next, etc.
However, the distance of piping run between the units should be lim-
ited to no more than three feet (see figure 4, page 4).
TYPICAL INSTALLATION
The heater inlet and outlet should be plumbed (up flow) as shown (see
figure 4, page 4), to minimize chances of trapped air inside the heater. If
the inlet and outlet are reversed (down flow), the temperature rise will be
different.
DIMENSIONAL DATA
651747-2-M FLUID HEATER
Figure 1
16-1/16”
(408.0 mm)
4-3/16”
(105.6 mm)
8-13/16”
(223.8 mm)
3-3/4”
(95.3 mm)
7-1/2”
(190.5 mm)
4-3/4”
(120.7 mm)
3/4 - 14 N.P.T.F.
1/2 - 14 N.P.T.F.
(Outlet)
1/2 - 14 N.P.T.F.
(Inlet)
Mounting holes
(hidden)
Thermometer - Do not over-
tighten. For orientation only.
0891
OPERATING PRECAUTIONS
•
Heed all warnings.
WARNING
Do not exceed 35 MPa (5000 p.s.i.) maximum.
WARNING
HIGH PRESSURE DEVICE. Improper usage of
this equipment could result in serious injury. The possibility of
injection into the flesh is a potential hazard. Never allow any
part of the human body to come in front of, or in direct contact
with, the material outlet. An injection injury can be serious. If
injection should occur, contact a qualified physician for imme-
diate treatment.
CAUTION
Electrical supply power to the heater must be off
during flushing operation.
CAUTION
Use only genuine Aro replacement parts to as-
sure compatible pressure rating and longest service life.
CAUTION
Do not remove cover when energized.
INGERSOLL RAND COMPANY LTD
209 NORTH MAIN STREET – BRYAN, OHIO 43506
(800) 495-0276
FAX(800) 892-6276
©
2010 CCN 1520
0561
www.ingersollrandproducts.com
FLUID HEATER DATA
Models
651747-2-M
. . . . . . . . . . . . . . . . . . . . . . .
Wetted Parts Material
Stainless Steel
. . . . . . . . . . . .
Volts AC
220
. . . . . . . . . . . . . . . . . . . . . .
Amperes
8.3
. . . . . . . . . . . . . . . . . . . . . .
Watts
2000
. . . . . . . . . . . . . . . . . . . . . . . . .
Accuracy
±
1.9
_
C (3-1/2
_
F)
. . . . . . . . . . . . . . . . . . . . . .
Temperature Rise Above Ambient
38
_
C (100
_
F)
. . .
Recovery Rate per Hour
56.8 liters (15 gallons)
. . . . . . . . . .
Maximum Working Pressure
35 MPa (5000 p.s.i.)
. . . . . . .
Maximum Temperature Range
16 - 121
_
C (60 - 250
_
F)
. . . . . .
Surface Temperature Code
T3 (200
_
C / 392
_
F)
. . . . . . . .
Fluid Passage Diameter
9.4 mm (0.370”)
. . . . . . . . . . .
Fluid Passage Length
232.9 cm (91.7”)
. . . . . . . . . . . .
Fluid Passage Volume
0.162 lit. (9.86 in.
3
)
. . . . . . . . . . . .
Inlet / Outlet Port Size (female)
1/2 - 14 N.P.T.F. - 1
. . . . .
Weight
8.2 kg (18 lbs)
. . . . . . . . . . . . . . . . . . . . . . . .
Environment Approval
Group II 2 G Ex dII B T3
. . . . . . . . . . . .
CENELEC Standard
EN 60079
-
0 & EN 670079
-
1
. . . . . . . . . . . . . .
Notified Body Certification
TRL04ATEX11052
. . . . . . . .
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
