Ingersoll Rand 651418-40-B - Manual

INGERSOLL RAND COMPANY LTD

P.O. BOX 151

y

ONE ARO CENTER

y

BRYAN, OHIO 43506-0151

(800) 276-4658

y

FAX (800) 266-7016

© 2007

CCN 81516684

OPERATOR’S MANUAL

651418-XX-B

INCLUDING: OPERATION, INSTALLATION & MAINTENANCE

RELEASED: 1-17-79
REVISED: 12-10-07
(REV. E)

MATERIAL FILTER

MAXIMUM INLET PRESSURE 6,000 P.S.I. (414 Bar)

READ THIS MANUAL CAREFULLY BEFORE INSTALLING,

OPERATING OR SERVICING THIS EQUIPMENT.

It is the responsibility of the employer to place this information in the hands of the operator. Keep for future reference.

SERVICE KITS

Use only genuine ARO replacement parts to assure compatible
pressure rating and longest service life.
Refer to fi gure 3 to order replacement parts.

MATERIAL FILTER DATA

Models

. . . . . . . . . . . . . . . . . . . . . . . . . . . . see Model Description Chart

for “-XXX” (optional screen)

Material

. . . . . . . . . . . . . . . . . . . . . . . . . . . see Model Description Chart

Maximum Fluid Pressure

. . . . . . . . . 6,000 p.s.i.g. (414 bar)

OPERATING AND SAFETY PRECAUTIONS

Read and heed all warnings, cautions and safety precau-
tions before operating this pump.

WARNING

HAZARDOUS PRESSURE. Can result in serious

injury or property damage. Do not service or clean pump,
hoses or dispensing valve while the system is pressurized.

CAUTION

Be certain all operators of this equipment have

been trained for safe working practices, understand it’s
limitations, and wear safety goggles / equipment when re-
quired.

WARNING

Do not exceed the maximum inlet air pressure

as stated on the air motor model plate. Operating pump at
higher pressure may cause pump damage.

WARNING

HAZARDOUS MATERIALS. Can cause serious in-

jury or property damage. Do not attempt to return a pump
to the factory or service center that contains hazardous
material. Safe handling practices must comply with local
and national laws and safety code requirements. Obtain
Material Safety Data Sheets on all materials from the sup-
plier for proper handling instructions.

GENERAL DESCRIPTION

The ARO model 651418-XX-B material filter is used to separate
foreign materials, like dirt, stones and sweeping compound, from
the material handling section. Material fi lters and strainers can be
installed in a system to combat this problem, thereby achieving
longer service life. Filters and strainers are normally located in one
of two places in the pumping system. At this point, where the fl uid
enters the material handling section, the strainer prevents foreign
material from entering the system.

y

y

y

DISASSEMBLY

Unscrew and remove (1) cap from the (8) fi lter body.
Remove (2) gasket from (1) cap.
Remove (3) spring and (4) button guide from the (8) fi lter body.
Pull the (6) cartridge and (5) ball from the (8) fi lter body.
Unscrew the (8) filter body from the (7) body and remove (2)
gasket.

Replace worn seal and parts with new parts. Reverse disassembly
instructions for assembly.

1.
2.
3.
4.
5.

THIS MANUAL COVERS THE FOLLOWING MODELS:

MODEL

MATERIAL TYPE

SCREEN MESH SIZE (optional)

651418-40-B

Carbon Steel

93945-40 - 40 mesh

651418-70-B

Carbon Steel

93945-70 - 70 mesh

651418-100-B

Carbon Steel

93945-100 - 100 mesh

Figure 1