iHome iH7 - Manual - manualsarea.com

Page 2 - Table of Contents; Replacing iH7 Backup Batteries; A Consumer Guide to Product Safety

Table of Contents Quick Start ........................................................................................................................................................................ 1 Controls and Indicators / iH7 Display ................................................................

Page 3 - quick start; Never dock an iPod without

quick start Attach AC adaptor cable to jack on back of the iH7 and plug the other end into a wall socket. Snap AM antenna into provided stand, then plug antenna cable into socket on back of iH7. Move antenna 12” away. Press the Radio button and press again to select AM/FM band. Turn the Set Wheel to...

Page 5 - Using the iH7; Connect iH7 to Power Source; Setting the Clock

3 Using the iH7 Connect iH7 to Power Source a) Plug the AC adaptor cable into the P AC Adaptor Jack and the other end into a standard 120v wall socket. Adaptor must be plugged in to operate. The iH7 does not operate on batteries . Setting the Clock a) Press and hold the S Time Zone Button until the ...

Page 6 - Radio; Using Sleep Mode

Install/Replace Backup Battery The iH7 uses a backup battery system to provide continuous alarm operation and clock settings in the event of a power failure. If the Battery Low Icon located on the left of the display is flashing, it is time to replace the backup batteries. Please make sure the AC ad...

Page 7 - Install/Replace the Remote Control Batteries; NOTE: PLEASE DISCARD BATTERIES PROPERLY; Using The Remote Control Unit; CHANGING THE REMOTE CONTROL CODE

Install/Replace the Remote Control Batteries The remote control batteries are already installed at the factory. When the remote control stops operating or its range seems reduced, replace the batteries with new ones.1. The battery door is located on the back end of the unit.2. Press to release the b...

Page 9 - Troubleshooting; Solution

iH7 does not turn on AC adaptor isn't plugged into a working wall socket or not plugged into the power supply jack on back of the unit Plug the AC adaptor into a working wall socket and plug the connector into the supply jack on the unit iH7 requires a reset If unit is plugged in and doesn't respond...

Page 11 - Solucionando problemas

Síntoma El adaptador de corriente AC no está conectado a un tomacorriente que funcione o no está conectado en la parte posterior de la unidad Conecte el adaptador de corriente a un tomacorriente que funcione y a la parte posterior de la unidad La unidad debe ser reprogramada Si la unidad está conect...

Page 13 - Limited 90-Day Warranty Information

Home Products, a division of SDI Technologies Inc. (hereafter referred to as SDI Technologies), warrants this product to be free from defects in workmanship and materials, under normal use and conditions, for a period of 90 days from the date of original purchase.Should this product fail to function...

iHome iH7 - Manual

Table of Contents:

Summary

Other iHome Models