Igenix IG9909 - User Manual

6 APPLIANCE OVERVIEW Front Back Accessories Parts Parts Name Quantity Exhaust hose connector Exhaust hose Exhaust hose adapter 1 set Window slider kit 1 set Window slider without hole 1 set Remote control 1 set Drainage hose 1 set 1. Control panel2. Handle (both sides)3. Castors4. Louvres 5. Intake ...

7 INSTALLATION Warning: Leave the unit to stand for 12 hours before connecting to the mains electricity supply after transport or when it has been tilted (e.g. cleaning), to allow the coolant gases time to settle. Unpacking • Open the box and remove all of the packaging and the exhaust assembly• Gri...

9 Window Slider Kit Installation A. PanelB. Panel with one holeC. Screw to lock window kit in place Assembly:• Slide panel B into Panel A and size to window width. Ensure that the window kit assembly is free from gaps from gaps and/or air pockets when taking measurements. • Lock the screw into the h...

10 OPERATING INSTRUCTIONS When box is lit up, this shows: A. Timer enabledB. Low speed fan selectedC. High speed fan selectedD. Dehumidify mode selectedE. Cooling mode selectedF. Fan mode selected 1. Timer button2. Fan button3. Increase temperature button4. Display screen5. Decrease temperature butt...

14 Tips For Correct Use To get the best from your appliance, follow the below recommendations: • Close the windows (that aren’t being used for venting) and doors in the room to be air conditioned (Fig.9). When installing the appliance semi-permanently, you should leave a door slightly open (as littl...

15 WATER DRAINAGE With daily use, it is recommended to empty the unit approximately once a week. The unit can be drained manually or continuously, as explained below: Manual Draining (Fig.12) • Unplug the unit from power source.• Place a suitable container (not supplied with unit) under the lower dr...

16 Middle Drainage When unit running in Dry mode, you can choose to drain the system from the middle drainage outlet as below: 1. Unplug the unit from the power source.2. Remove the drain plug (Fig.16). While doing this, some residual water may spill so ensure you have a pan ready to collect the wat...

17 CLEANING & MAINTENANCE Cleaning the Cabinet Before any cleaning or maintenance, turn the appliance off by pressing the “ ” button on thecontrol panel or remote control. Wait for a few minutes then unplug from the mains socket. You should clean the outer cabinet of the appliance with a slightl...

18 TROUBLE SHOOTING GUIDE If you experience difficulties with the appliance, please check the suggestions below before contacting customer services: Problem Solution The unit will not switch on • Check Trip Switch / Fuse • Wait for 3 minutes and start again, protective device may be preventing unit ...

19 ERROR CODES Error Code Solution PROBE FAILURE (sensor damaged) • If this is displayed, contact your local authorised service centre. FULL TANK (safety tank full) • Empty the internal safety tank, following the instructions in the “End of Season Operations” paragraph.

22 Igenix Warranty Terms & Conditions This product is guaranteed for a period of 12 months as standard from the date of purchase against mechanical and electrical defects. You can extend your warranty for a further 12 months by registering your product. Upon registration we will cover your produ...

23 Thank you for choosing lgenix As a valued customer we would like to offer you a FREE 2 year warranty to cover your product against any electrical or mechanical defects. This means that in the unlikely event you develop a fault or problem with your product we will happily repair or replace the ite...