Page 2 - Table of contents
2 Dear customer! Thank you for purchasing our product. For safety, it is strongly recommended to read this manual carefullybefore connecting, operating and/or adjusting the product and keep the manual for reference in the future. Table of contents Table of contents .....................................
Page 3 - Important safeguards; BEFORE USING
3 Important safeguards Using the device at temperature below -10º may cause the breakage of the device. BEFORE USING PLEASE HEAT UP THE PASSENGER COMPARTMENT TO THE RECOMMENDED TEMPERATURE! Read carefully through this manual to familiarize yourself with this high-quality sound system. Disconnect the...
Page 4 - Installation/ connection; Insert fingers into the groove in the front of frame and remove it.; Removing the unit
4 Installation/ connection Attention: REMOVE THE TRANSPORT CD STOPPER (2 SCREWS)BEFORE USE. Din front-mount (method 1) After inserting the holder into the dashboard, select the appropriatetab and bend them inwards to secure the holder in place. Insert fingers into the groove in the front of frame an...
Page 5 - Detachable control panel; Detaching the control panel; Press the panel release button RELEASE.
5 Din rear-mount (method 2) Installation using the screw holes at both sides of the unit.1. Select a position where the screw holes of the main unit are fitted for aligned, and tighten the screws at 2 positions at each sides.Use either truss screws (5 x 8mm) or flush surface screws (4 x 8mm), depend...
Page 6 - Attaching the control panel; Insert the right side of the control panel into the main unit.
6 Attaching the control panel Insert the right side of the control panel into the main unit. Note: the control panel must be attached into the T-Joint. Press the control panel on to the left side of middle of it until a click sound is heard. Caution: DO NOT insert the control panel from the left sid...
Page 7 - Electrical connection
7 Electrical connection Caution: Do not interchange the connection of the wiring!!! For some car models you may need to modify wiring of the supplied power cord. Contact your authorized cardealer before installing this unit.
Page 8 - Panel controls; Front panel; Press it to detach the front panel.
8 Panel controls Front panel 1. RELEASE button Press it to detach the front panel. 2. VOL knob/ SEL button Rotate VOL knob clockwise to increase the volume level; rotate anticlockwise to decrease the volume level.Press SEL button once to enter the Audio select menu. Press it repeatedly to select the...
Page 10 - Press it to activate the TA function.
10 16. PAUSE button Use this button to pause playback. Under the pause status, press it to play. 17. PRESET STATION [1-6] buttons18. AF/REG button Press it to enter the AF mode. Press and hold for 2 seconds to enter the REG mode. 19. TA/TP button Press it to activate the TA function. 20. DIS/REC but...
Page 11 - Remote control
11 Remote control 1. DIS/REC button Press shortly to display current mode and time. Press andhold for 2 seconds to enter the Record function. 2. MODE button Press to select the mode: TUNER => CD => SD/MMC =>USB => NAND => AUX. 3. MUTE button Press it to cut down the volume output, pre...
Page 13 - Changing the battery; Press the catch and at the same time pull out the battery tray.
13 Changing the battery 1. Press the catch and at the same time pull out the battery tray. 2. Insert the 1 x lithium battery, type CR 2025 3V battery with the stamped (+) mark facing upward. Insert the battery tray into the remote control. Warning: Store the battery where children cannot reach. If a...
Page 14 - Back of the front panel; Press the OPEN button on the front panel to flip it down.
14 Back of the front panel Press the OPEN button on the front panel to flip it down. 1. MINI USB socket;2. SD CARD socket;3. Panel status indicator;4. RESET button;5. Disc slot;6. EJECT button. Note: Pressing the RESET button will erase the clock setting and stored stations. Panel status indicator l...
Page 15 - General operation; Reset the unit; unit on it will resume the stored status which you set.; Volume control; Volume adjust; If turning off the power all the settings of each mode will be saved.
15 General operation Reset the unit Operating the unit for the first time or after replacing the car battery, you must reset the unit.Press OPEN button on the panel to open the panel and press the RESET buttont to restore the unit to the originalfactory settings. Power button Press PWR button to tur...
Page 16 - Setting other characteristics; Turning the sound off
16 Setting other characteristics During FM mode, keep pressing SEL button for 2 seconds to enter another mode. Shortly and repeatedly press theSEL button to select the setting: DSP => IN VOL => STEREO => LOC => LOUD => CT => TA VOL => EON=> PTY.a. DSP mode: select the followi...
Page 17 - Display operations; Press and hold for 2 seconds to enter the RECORD mode.; Setting the time; Digital tuner; Band selection
17 Display operations 1. Press the DIS/ REC button to show the following current tuning information and time in any play mode: PS (Default) => PTY => Radio frequency => CT. 2. Press and hold for 2 seconds to enter the RECORD mode. Setting the time 1. Enter the CT mode (by pressing the SEL b...
Page 18 - Programming tuner stations; AF will be flashing.
18 Programming tuner stations You can store up to a total of 30 radio stations in the memory (18 FM, 12 MW), manually or automatically. To store a station: - Select a band (if needed)- Select a station by T-UP/ T-DN buttons- Hold a Preset button (1-6) which you want store the station for at least 2 ...
Page 19 - Press PTY button for the 3; time to switch the PTY function off.
19 The RDS program will be automatically searched and received. After turning on, if the RDS signal is week oreven no signal, the unit will search another frequency with this RDS program.Default setting is ON. Region mode: Press and hold AF/REG button for 2 seconds, the unit will be under REGION ON ...
Page 20 - Loading a disc; mode will be changed into the mode of the latter one.
20 CD/ NAND/ SD/ MMC/ USB operations Loading a disc 1. Turn the power on.2. Press the OPEN button on the panel.3. Insert the disc with the printed side facing upward into the slot.4. Press EJECT button on the inner side to eject the disc. Inserting the SD/ MMC card/ USB device Insert the MMC/ SD car...
Page 21 - Playing the previous/ next track; During playback press the T-DN button on the panel or; Inserting the number of track
21 Note:USB format supports 2.0. Capacity: 8 MB ~ 1 GB. SD cards brands: Cannon, Fuji film, Palm, Motorola, Microsoft, IBM, HP, Compaq, Sharp, Samsung, etc. Capacity: 8 MB ~ 1 GB. MMC cards brands: Ericsson, Nokia, Motorola, HP, Palm, Sanyo, Microsystems, etc. Capacity: 16 MB ~ 1 GB. Playing/ pausin...
Page 22 - Scanning forward and backward; it resumes normal playback.; Repeat playback
22 3. Use the T-DN or T-UP / or buttons to go to the previous/ next track by one. Scanning forward and backward Press and hold for 2 seconds the T-DN or T-UP buttons to fast the playing in backward or forward direction. Note: During the disc playback when Fast/ Reverse Playback gets to the beginning...
Page 23 - Search function; File number search; if there is no such file the display will show NO MATCH .; Folder search; button to enter the folder.; MINI USB port operating
23 Search function In CD/ NAND/ MMC/ SD/ USB mode, press AS/PS button to enter the Music file search menu. Press again toselect the search mode: FILE NUMBER SEARCH => FILE NAME SEARCH => FOLDER SEARCH.Audio CD supports the FILE NUMBER SEARCH only. File number search 1. Press AS/PS button once ...
Page 24 - File managing; Default recoding location is NAND flash memory.; Recording at audio CD mode
24 File managing Encoding (recording) function Encoding (Recoding) function enables sound source from Tuner, CD, AUX-in, NAND flash memory, USBdevice, SD socket to record directly to NAND flash memory, USB device or SD/MMC card. Note: Default recoding location is NAND flash memory. Recoding at tuner...
Page 25 - Recording at MP3 CD mode
25 NAND ALL: Recording all tracks from disc to NAND Flash memory. MMC ALL: Record all tracks from disc to SD/MMC card. USB ALL: Record all tracks from disc to USB storage device. NAND ONE: Recording current track to NAND flash memory. MMC ONE: Record current track to SD/MMC card. USB ONE: Record cur...
Page 26 - File delete; Tuner AUX-IN CD NAND
26 Select intended location by pressing DIS/REC button in the sequence of MMC => USB.To exit recording mode, press DIS/REC more than 2 seconds. To start recording, press BAND. Press againto stop recording. 2. In SD/MMC mode: encoding to NAND flash memory or USB socket is available. In USB mode, e...
Page 27 - File download to front panel
27 File download to front panel You can enjoy the music from pre-recorded memory on flash memory of the front panel. Copy music files fromcomputer using USB cable provided.1. Check your operation system of your computer - supporting operation system is Windows 98, 2000, XP. Note: Windows XP supports...
Page 28 - MP3 overview; The unit may not play tracks in the order of Track numbers.; Notes on creating your own CD-R or CD-RW containing MP3 files:; DO NOT store more than 256 MP3 files per disc.
28 MP3 overview Notes on MP3: MP3 is short for MPEG Audio Layer 3 and refers to an audio compression technology standard. This product allows playback of MP3 files on CD-ROM, CD-R or CD-RW discs. The unit can read MP3 files written in the format compliant with ISO 9660. However it does not support t...
Page 30 - Handling discs; Dirty, scratched or warped discs may cause skip ping or noise.; Cleaning; Cleaning the cabinet
30 Handling discs Dirty, scratched or warped discs may cause skip ping or noise. Handle the disc only by the edges. To keep clean do not touch its surface. Discs should be stored in their cases after use to avoid scratches. Do not expose discs to direct sunlight, high humidity, high temperature or d...
Page 31 - Troubleshooting guide; Symptom
31 Troubleshooting guide Symptom Cause Solution GeneralNo power The car ignition is not on.The fuse is blown. If the power supply is properly connected to the caraccessory switch the ignition key to ACC .Replace the fuse. DiscDisc cannot be loaded. Presence of disc inside the player. Remove the disc...
Page 32 - Specification; General; Current consumption:; FM Stereo Radio; MW section; Preset memory stations:; Audio specification
32 Specification Specifications are subject to change without notice. Mass and dimension are approximate. General Power supply: 11-16 V DC Current consumption: max. 10 A Maximum power output: 50 W x 4 channels Dimensions (L x W x H): 178 x 175 x 50 mm Working temperature range: -10º - +60º Built-in ...
Page 35 - CD
35 / : CD . , , , . 1. 2. (5 ) 3. 4. (5 x 25 ) 5. 6. 7. . ( .) , , , , . , , .
Page 37 - RELEASE
37 . RELEASE . 1). ( . 2). 1. , , ( .3). 2. , ( . 4). 3. , . , . : . . : , . . . , , . , . , . . 1 . 2 . 3 . 4
Page 49 - RDS
49 : RDS ( ) . , RDS , . PWR, . MOD , - TUNER. B ND, : FM 1, FM 2, FM 3, MW 1, MW 2. / : T-UP T-DN, . T-UP/ T-DN, . : T-UP T-DN, . , . , . 6 5 . : - ( ). - T-UP/ T-DN. - 1~6, . : - ( ). - 1~6.
Page 55 - Intro
55 Intro 10 . INT, . CD/ NAND/ SD/ MMC/ USB AS/PS, . , : FILE NUMBER SEARCH ( ) => FILE NAME SEARCH ( ) => FOLDER SEARCH ( ) => . CD FILE NUMBER SEARCH ( ). (File number search) 1. AS/PS, . «001». . 2. T-UP T-DN, (0-9). 3. SEL, . 4. BAND, . (File name search) 1. AS/PS, . **». . 2. T-UP T-DN...
Page 56 - MINI USB; MODE
56 2. T-UP T-DN, , SEL, . MINI USB Mini USB ( ). . MODE NAND. SD/ MMC/ USB : (TUNER), CD, AUX-in, (NAND), USB, SD/ MMC . / AUX-in 1. , SD/MMC USB : DIS/REC 2 . . «R». , BAND. 2. , SD/MMC USB : DIS/REC 2 . «REC NAND» - , . DIS/REC, , : NAND => SD/MMC => USB. DIS/REC.
Page 57 - USB; MP3 CD
57 BAND, . «R». , BAND. CD DIS/REC 2 . «NAND ALL» - , . DIS/REC, , : NAND ALL => MMC ALL* => USB ALL* => NAND ONE => MMC ONE* => USB ONE*.* , SD/MMC USB . NAND ALL: . MMC ALL: SD/MMC. USB ALL: USB. NAND ONE: . MMC ONE: SD/MMC. USB ONE: USB. DIS/REC, . , BAND. , . DIS/REC 2 . : , «R». ...
Page 66 - DSP
66 . . : 11-16 : 10 : 50 4 ( ): 178 175 50 : -10º - +60º : 1 FM : 87.5 - 108.0 / : 30 18 MW : 522-1620 12 : 2 RMS (+/-3 ) : 20 20 (A-vtd): 60 DSP Classic, Rock, Pop, FlatCD . 2000
