Page 2 - I. GENERAL OPERATION; SAFETY RULES; Safe Operation Practices for Ride-On Mowers
2 I. GENERAL OPERATION • Read, understand, and follow all instructions on the machine and in the manual before starting. • Do not put hands or feet near rotating parts or under the machine. Keep clear of the discharge opening at all times. • Only allow responsible adults, who are familiar with the i...
Page 4 - PRODUCT SPECIFICATIONS; CUSTOMER RESPONSIBILITIES; TABLE OF CONTENTS
4 PRODUCT SPECIFICATIONS Gasoline Capacity 1.5 Gallons and type: Unleaded Regular Oil Type (API-SG-SL): SAE 30 (above 32°F) SAE 5W-30 (below 32°F) Oil Capacity: W/Filter: 60.8 oz W/O Filter: 50.7 oz Spark Plug: Champion QC12YC (Gap: .040") Ground Speed (MPH): Forward: 5.5 Reverse: 2.4 Charging S...
Page 5 - UNASSEMBLED PARTS; Steering Wheel
5 UNASSEMBLED PARTS Steering Wheel (1) Washer Seat (1) Seat Steering Boot SteeringExtensionShaft Steering Wheel Adapter Keys (2) Keys Slope Sheet (1) Oil Drain Tube For Future Use (1) Hex Bolt (1) Hex Bolt (1) 5/16 Lock Washer (1) Large Flat Washer Steering Wheel Insert (1) Hood Scoop
Page 6 - ASSEMBLY; TOOLS REQUIRED FOR ASSEMBLY; UNPACK CARTON; BEFORE REMOVING TRACTOR FROM
6 ASSEMBLY TOOLS REQUIRED FOR ASSEMBLY A socket wrench set will make assembly easier. Stan dard wrench sizes are listed.(1) 3/4" wrench Pliers (2) 7/16" wrenches Tire pressure gauge Utility knife When right or left hand is mentioned in this man ual, it means when you are in the operating po ...
Page 8 - CHECKLIST
8 ASSEMBLY CHECK TIRE PRESSURE The tires on your tractor were overinflated at the factory for shipping purposes. Correct tire pressure is important for best cutting performance.• Reduce tire pressure to PSI shown on tires. CHECK DECK LEVELNESS For best cutting results, mower housing should be prop- ...
Page 9 - OPERATION
9 OPERATION These symbols may appear on your tractor or in literature supplied with the product. Learn and understand their mean- ing. DANGER, KEEP HANDS AND FEET AWAY FREE WHEEL (Automatic Models only) KEEP AREA CLEAR SLOPE HAZARDS 15 15 (SEE SAFETY RULES SECTION) BATTERY REVERSE FORWARD FAST SLOW ...
Page 10 - KNOW YOUR TRACTOR
10 OPERATION KNOW YOUR TRACTOR READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR Compare the illustrations with your tractor to familiarize yourself with the locations of various controls and ad just ments. Save this manual for future reference. Our tractors conform to the safe...
Page 11 - TO MOVE FORWARD AND BACKWARD; HOW TO USE YOUR TRACTOR
11 OPERATION 00155 The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye dam age. Always wear safety glass es or eye shields while op- erating your tractor or per form ing any adjustments or repairs. We rec om mend a wide vision safety mask o...
Page 12 - TO OPERATE ON HILLS
12 OPERATION FIG. 7 TO OPERATE MOWER (See Fig. 7) Your tractor is equipped with an operator presence sensing switch. Any attempt by the operator to leave the seat with the engine running and the attachment clutch engaged will shut off the engine. You must remain fully and centrally positioned in the...
Page 13 - ADD GASOLINE; TOWING CARTS AND OTHER AT TACH MENTS; BEFORE STARTING THE ENGINE; CHECK ENGINE OIL LEVEL
13 OPERATION ADD GASOLINE • Fill fuel tank to bottom of filler neck. Do not overfill. Use fresh, clean, regular un lead ed gasoline with a minimum of 87 octane. (Use of leaded gasoline will increase carbon and lead oxide deposits and reduce valve life). Do not mix oil with gasoline. Purchase fuel in...
Page 14 - MOWING TIPS; PURGE TRANSMISSION
14 00272 FIG. 10 OPERATION MOWING TIPS • Mower should be properly leveled for best mowing per- formance. See “TO LEVEL MOWER HOUSING” in the Service and Adjustments section of this manual. • The left hand side of mower should be used for trim- ming. • Drive so that clippings are discharged onto the ...
Page 15 - MAINTENANCE; LUBRICATION CHART; MAINTENANCE SCHEDULE; GENERAL RECOMMENDATIONS; BEFORE EACH USE
15 MAINTENANCE LUBRICATION CHART 01964 ➀ FRONT WHEEL BEARING ZERK ➀ FRONT WHEEL BEARING ZERK ➁ ENGINE ➀ SPINDLE ZERK ➀ SPINDLE ZERK ➀ GENERAL PURPOSE GREASE ➁ REFER TO MAINTENANCE “ENGINE” SECTION IMPORTANT: DO NOT OIL OR GREASE THE PIVOT POINTS WHICH HAVE SPECIAL NYLON BEARINGS. VISCOUS LU BRI CANT...
Page 16 - TRACTOR
16 MAINTENANCE FIG. 12A TRACTOR Always observe safety rules when per form ing any main- te nance. BRAKE OPERATION If tractor requires more than five (5) feet to stop at highest speed in high est gear on a level, dry concrete or paved surface, then brake must be checked and ad just ed. (See “TO CHECK...
Page 17 - TRANSAXLE COOLING; ENGINE; LUBRICATION
17 MAINTENANCE V-BELTS Check V-belts for deterioration and wear after 100 hours of operation and replace if necessary. The belts are not ad just able. Re place belts if they begin to slip from wear. TRANSAXLE COOLING The transmission fan and cooling fins should be kept clean to assure proper cooling...
Page 18 - CLEANING
18 CLEANING • Clean engine, battery, seat, finish, etc. of all foreign matter. • Keep finished surfaces and wheels free of all gasoline, oil, etc. • Protect painted surfaces with automotive type wax.We do not recommend using a garden hose or pressure washer to clean your tractor unless the engine an...
Page 19 - SERVICE AND ADJUSTMENTS
19 SERVICE AND ADJUSTMENTS WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SER VICE OR AD JUST MENTS: • Depress brake pedal fully and set parking brake. • Place attachment clutch in “DISENGAGED” position. • Turn ignition key to “STOP” and remove key. • Make sure the blades and all moving par...
Page 21 - TO REPLACE MOWER BLADE DRIVE BELT; TO REPLACE MOTION DRIVE BELT(See
21 SERVICE AND ADJUSTMENTS FIG. 21 TO REPLACE MOWER BLADE DRIVE BELT (See Fig. 20) The mower blade drive belt may be replaced without tools. Park the tractor on level surface. Engage parking brake. BELT REMOVAL - • Remove mower from tractor (See “TO REMOVE MOW ER” in this section of this manual). • ...
Page 22 - TO ADJUST STEERING WHEEL
22 FIG. 23 SERVICE AND ADJUSTMENTS FIG. 22 00663 RE TAIN ING RING WASH ERS SQUARE KEY (REAR WHEEL ONLY) AXLE COVER TO ADJUST STEERING WHEEL ALIGNMENT If steering wheel crossbars are not horizontal (left to right) when wheels are positioned straight forward, remove steer- ing wheel and reassemble per...
Page 24 - STORAGE; BATTERY; FUEL SYSTEM; ENGINE OIL; OTHER
24 STORAGE Immediately prepare your tractor for storage at the end of the season or if the tractor will not be used for 30 days or more. WARNING: Never store the trac tor with gas o line in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before stori...
Page 25 - TROUBLESHOOTING POINTS
25 TROUBLESHOOTING POINTS Will not start 1. Out of fuel. 1. Fill fuel tank. 2. Engine not “CHOKED” properly. 2. See “TO START ENGINE” in Operation section. 3. Engine flooded. 3. Wait several minutes before attempting to start. 4. Bad spark plug. 4. Replace spark plug. 5. Dirty air filter. 5. Clean/r...
Page 27 - SUGGESTED GUIDE FOR SIGHTING SLOPES FOR SAFE OPERATION; WARNING: To avoid serious injury, operate your tractor up and
27 15 DEGREES MAX. FOLD ALONG DOTTED LINE THIS IS A 15 DEGREE SLOPE ONLY RIDE UP AND DOWN HILL, NOT ACROSS HILL SUGGESTED GUIDE FOR SIGHTING SLOPES FOR SAFE OPERATION WARNING: To avoid serious injury, operate your tractor up and down the face of slopes, never across the face. Do not mow slopes great...
