Page 2 - Product description
Contents Introduction..................................................................... 2Safety..............................................................................4Operation........................................................................ 8Maintenance................................
Page 3 - Symbols on the product
15. Rammer shoe16. Sight glass for the oil in the spring-loaded rammer leg 17. Starter rope handle18. Engine oil indicator19. Operator's manual Hour meter When the engine is on, the hour meter shows the engine speed in rpm. When the engine is off, the hour meter shows the total operation time of the...
Page 4 - Safety; Safety definitions
Pull the starter rope handle. Choke open. Let the engine operate at idle speed. Noise emission to the environment label as per EU and UK directives and regulations, and New South Wales legislation Protection of the Environment Operations (Noise Control) Regulation 2017. The guaranteed sound power le...
Page 5 - Safety instructions for operation; Vibration safety
you must read and understand the contents of this operator’s manual. • This product is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge. • Save all warnings and instructions.• Comply with all applicable la...
Page 8 - Safety instructions for maintenance; Operation; Introduction
• Fuel is flammable and the fumes are explosive. Be careful with fuel to prevent injury, fire and explosion. • Do not breathe in the fuel fumes. The fuel fumes are poisonous and can cause injury. Make sure that the airflow is sufficient. • Do not remove the fuel tank cap or fill the fuel tank when t...
Page 10 - To stop the product; Maintenance
3. Make sure that the rammer shoe is parallel to the ground during the operation. To stop the product • Set the throttle control in the stop position. Maintenance Introduction WARNING: Read and understand the safety chapter before you do maintenance on the product. Maintenance schedule * = General m...
Page 13 - To clean or replace the air filter
To clean or replace the air filter WARNING: Use approved respiratory protection when you clean or replace the air filter. Discard used air filters correctly. The dust in the air filter is dangerous to your health. WARNING: Do not clean the air filter with compressed air. This causes damage to the ai...
Page 14 - Transportation, storage and disposal; Transportation; To move the product on the transport wheels
Note: Make sure that the rubber latch of the air filter cover is correctly attached. Transportation, storage and disposal Transportation WARNING: Be careful during transportation. The product is heavy and can cause injury or damage if it falls or moves during transportation. Transport wheels let you...
Page 15 - Storage
4. Push the handle down to tilt the product rearward. 5. Remove the transport device in the opposite sequence. WARNING: Do not use your hands to install or remove the transport device. Push it in and pull it away from the product with your foot. To lift the product WARNING: Make sure that the liftin...
Page 16 - Disposal
• Carefully pull the starter rope handle until there is a small resistance. • Put a protective cover on the product.• Keep the product in a dry and frost free area.• Keep the product in a locked area to prevent access for children or persons that are not approved. Disposal • Obey the local recycling...
Page 17 - Technical data
Technical data Technical data LT 5005 LT 6005 Rammer leg width 153 mm/6 in. Rammer leg width 230 mm/9 in. Rammer leg width 230 mm/9 in. Rammer leg width 280 mm/11 in. Weight with empty tanks, kg/lb 60/132.3 61/134 68/149 69/151 Operation weight (EN500, incl. oil, ½ fuel), kg/lb 61/134 62/136.7 69/15...
Page 18 - Noise and vibration declaration
Noise and vibration emissions LT 5005 LT 6005 Sound power level, guaranteed L WA dB (A) 3 106 106 Sound pressure level at the operator's ear, L P , dB (A) 4 92 92 Vibration level, a hv , m/s 2 5 6.4 6.4 Noise and vibration declaration statement These declared values were obtained by laboratory type ...
Page 21 - Declaration of Conformity; EC Declaration of Conformity
Declaration of Conformity EC Declaration of Conformity We, Husqvarna AB, SE-561 82 Huskvarna, Sweden, tel: +46-36-146500, declare on our sole responsibility that the product: Description Rammer Compaction Machine Brand Husqvarna Type/Model LT 5005, LT 6005 Identification Serial numbers dating from 2...