Page 2 - CONTENTS; Contents; Contact us at our website:
English --- 2 115275126 Rev. 1 9/15/09 CONTENTS Contents CONTENTS Contents 2 . . . . . . . . . . . . . . . . . . . . . . . . Note the following before starting 2 . . . . KEY TO SYMBOLS Symbols 3 . . . . . . . . . . . . . . . . . . . . . . . . . SAFETY INSTRUCTIONS Personal protective equipment 4 . ....
Page 3 - KEY TO SYMBOLS; Symbols
English --- 3 115275126 Rev. 1 9/15/09 KEY TO SYMBOLS Only intended for trimmer heads. Use unleaded or quality leaded gasoline and two--stroke oil mixed at a ratio of 2% (1:50). Other symbols/decals on the machine refer to special certification requirements for certain markets. Stop the engine by pu...
Page 4 - SAFETY INSTRUCTIONS; Personal protective equipment; Stop switch
English --- 4 115275126 Rev. 1 9/15/09 SAFETY INSTRUCTIONS GLOVES Gloves should be worn when necessary, e.g., when fitting cutting attachments. HEARING PROTECTION Wear hearing protection that provides adequate noise reduction. EYE PROTECTION Always wear approved eye protection. If you use a visor th...
Page 5 - Cutting attachment guard; Checking, maintaining and
English --- 5 115275126 Rev. 1 9/15/09 SAFETY INSTRUCTIONS Cutting attachment guard This guard is intended to prevent loose ob- jects from being thrown towards the opera- tor. The guard also protects the operator from accidental contact with the cutting at- tachment. Use of incorrectly wound trimmer...
Page 7 - Trimmer head
English --- 7 115275126 Rev. 1 9/15/09 SAFETY INSTRUCTIONS Trimmer head S Only use the recommended cutting at- tachments. See the section on “Technical data”. WARNING: Never use a machine with faulty safety equipment. The machine’s safety equipment must be checked and maintained as described in this...
Page 8 - Safety instructions regarding the; General safety precautions
English --- 8 115275126 Rev. 1 9/15/09 SAFETY INSTRUCTIONS Safety instructions regarding the surroundings S Never allow children to use the machine. S Ensure no one comes closer than 50 feet (15 meters) when working. S Never allow anyone else to use the machine without first ensuring that they have ...
Page 9 - Starting; Fuel safety; Transporting and storage; General working instructions; Basic safety rules
English --- 9 115275126 Rev. 1 9/15/09 SAFETY INSTRUCTIONS S Check that the trimmer head and guard are correctly secured. S When adjusting the carburetor, make sure the lower end is supported and that no one is in the immediate vicinity. S Make sure the cutting head does not rotate when idling. S Ma...
Page 10 - Basic working techniques; Grass trimming using a trimmer head
English --- 10 115275126 Rev. 1 9/15/09 SAFETY INSTRUCTIONS 3. Make sure you can move and stand safely. Check the area around you for possible ob- stacles (roots, rocks, branches, ditches, etc.) in case you have to move suddenly. Take great care when working on sloping ground. 4. Switch off the engi...
Page 12 - KNOW YOUR TRIMMER; Know your trimmer
English --- 12 115275126 Rev. 1 9/15/09 KNOW YOUR TRIMMER 1. Trimmer head 12. Starter handle 2. Grease filler cap 13. Fuel tank 3. Bevel gear 14. Choke control 4. Cutting attachment guard 15. Primer bulb 5. Upper shaft 16. Air filter cover 6. Lower shaft 17. Handle adjustment 7. Loop handle 18. Driv...
Page 13 - ASSEMBLY; Assembling and dismantling
English --- 13 115275126 Rev. 1 9/15/09 ASSEMBLY Dismantling: S Loosen the coupling by turning the knob. S Press and hold the locking/release but- ton (A). S While securely holding the engine and upper shaft, pull the attachment straight out of the coupling. Assembling and dismantling the two--piece...
Page 14 - itting the trimmer guard and
English --- 14 115275126 Rev. 1 9/15/09 ASSEMBLY F itting the trimmer guard and trimmer head (Model 128CD) S Fit the correct trimmer guard (A) for use with the trimmer head. Hook the trimmer guard/combination guard onto the fitting on the shaft and secure with the wing nut (B). A C B S Fit the dust ...
Page 15 - FUEL HANDLING; Fuel mixture; Gasoline; Fueling; Mixing
English --- 15 115275126 Rev. 1 9/15/09 FUEL HANDLING Fuel mixture CAUTION! The machine is equipped with a two-- stroke engine and must always be run using a mixture of gasoline and two-- stroke engine oil. It is important to accu- rately measure the amount of oil to be mixed to ensure that the corr...
Page 16 - STARTING AND STOPPING; Check before starting; Cold engine
English --- 16 115275126 Rev. 1 9/15/09 STARTING AND STOPPING Check before starting S Inspect the unit before each use. Re- place damaged parts. Check for fuel leaks. Make sure all fasteners are in place and secure. Make sure the cutting attachment is properly installed and se- curely fastened. Use ...
Page 17 - Warm engine
English --- 17 115275126 Rev. 1 9/15/09 STARTING AND STOPPING Warm engine With a warm engine, move the blue engine choke lever to the ½ position. Pull starter rope until engine runs. Move the blue engine choke lever to the opened position. Stopping Stop the engine by pushing and holding the stop swi...
Page 18 - MAINTENANCE; Carburetor; Function; Unit/Maintenance Safety
English --- 18 115275126 Rev. 1 9/15/09 MAINTENANCE The idle speed is correctly adjusted when the engine will run smoothly in every posi- tion. The idle speed should also be well below the speed at which the cutting at- tachment starts to rotate. Carburetor Your Husqvarna product has been designed a...
Page 19 - Air filter; Cleaning the air filter; Spark plug
English --- 19 115275126 Rev. 1 9/15/09 MAINTENANCE Two--piece shaft The drive shaft end in the lower shaft should be lubricated with grease every 30 hours. There is a risk that the drive shaft ends (splined coupling) will seize if they are not lubricated regularly. Air filter The air filter must be...
Page 20 - Maintenance schedule; Daily maintenance
English --- 20 115275126 Rev. 1 9/15/09 MAINTENANCE Maintenance schedule Below you will find some general mainte- nance instructions. Daily maintenance S Check throttle trigger and throttle trigger lockout function. S Check that the stop switch works correctly. S Check that there are no fuel leaks f...
Page 21 - Trimmer Head Line Loading Instructions
English --- 21 115275126 Rev. 1 9/15/09 Trimmer Head Line Loading Instructions 20 i 10 i 3 m 6 m
Page 22 - TECHNICAL DATA; Technical data
English --- 22 115275126 Rev. 1 9/15/09 TECHNICAL DATA Attachments Part. no. Edger attachment with shaft 952 711 607 Cultivator attachment with shaft 952 711 608 Blower attachment with shaft 952 711 609 Brushcutter attachment with shaft 952 711 610 Pruner attachment with shaft 952 711 612 Technical ...
Page 23 - WARRANTY STATEMENT
English --- 23 115275126 Rev. 1 9/15/09 WARRANTY STATEMENT SECTION 1: LIMITED WARRANTY Husqvarna warrants Husqvarna product to the original purchaser to be free from defects in material and workmanship from the date of purchase for the “Warranty Period” of the products as set forth below: Lifetime W...
Page 24 - EMISSION CONTROL WARRANTY STATEMENT
English --- 24 115275126 Rev. 1 9/15/09 U.S. EPA / CALIFORNIA / ENVIRONMENT CANADA EMISSION CONTROL WARRANTY STATEMENT YOUR WARRANTY RIGHTS AND OBLIGATIONS: The U.S. Environmental Protection Agency, California Air Resources Board, Environment Canada and HUSQVARNA are pleased to explain the emissions...
Page 25 - MAINTENANCE, REPLACEMENT
English --- 25 115275126 Rev. 1 9/15/09 U.S. EPA / CALIFORNIA / ENVIRONMENT CANADA EMISSION CONTROL WARRANTY STATEMENT MAINTENANCE, REPLACEMENT AND REPAIR OF EMISSION RE- LATED PARTS: Any HUSQVARNA approved replacement part used in the performance of any warran- ty maintenance or repair on emission ...
