Page 2 - CONTENTS; Content; UNPACKING; SOUND DATA; WARNING
CONTENTS Content Page Table of contents ………………………….. 2Unpacking .................................................. 2Transporting ............................................... 2Sound Data ................................................ 2 I ntroduction, personal safety ...................... 3 Regi...
Page 4 - REGISTER THE PRODUCT; SAFETY HAZARDS; CAUTION; SAFETY DEFINITIONS
4 REGISTER THE PRODUCT Please register your new 2000 with Husqvarna Construction Products by mailing in the registration card that came with the machine or you can register on the internet site www.husqvarnawarranty.com Registration will allow us to contact in case of any critical updates or recalls...
Page 5 - SAFETY WARNINGS
5 SAFETY WARNINGS WARNING Failure to comply with the following warnings could result in serious bodily injury or death! PERSONAL SAFETY • Read and understand instructions before operating saw. • Always wear safety approved hearing, eye, head and respiratory protection. • Wear boots with non-slip sol...
Page 6 - EXCEL SERIES BLADES; BLADE AND SKID PLATE INSTALLATION
6 EXCEL SERIES BLADES The Excel Series of diamond blades have been designed specifically for the Soff-Cut Ultra Early Entry dry cutting system of green concrete. These specialty blades are designed to increase speed and life while cutting a wide range of aggregates. Choose the correct specification ...
Page 7 - WHAT IS WHAT
WHAT IS WHAT H E What is what? A. Oil fill & dipstick B. Air cleaner C. Recoil starter D. Fuel shut off lever E. Choke lever F. Oil drain hose G. Fuel cap H. Fuel tank I. Transmission oil fill cap J. Hour meter/Tachometer K. Battery box L. Saw forward speed lever M. Engine on/off switch N. Guide...
Page 8 - OPERATING INSTRUCTIONS
8 OPERATING INSTRUCTIONS Experience is very important when running the 2000 saw. A skilled worker is highly recommended. Always do an inspec- tion of the saw before starting the engine. Check the fuel (H) and oil level (A) per the enclosed engine manual. SAE 10W/30 oil and unleaded gasoline with an ...
Page 9 - The engine will not operate on gasoline; OIL HANDLING; ENGINE OIL
9 FUEL HANDLING PROPER FUEL Taking the following precautions will lessen the risk of injury and property damage: - Use extreme care in handling gasoline. It is extremely flammable and the vapors are explosive. - Extinguish all cigarettes, cigars, pipes, and other sources of ignition. - Use only appr...
Page 10 - Engine Oil; Checking, Adding and Changing Oil; ENGINE AND TRANSMISSION MAINTENANCE; NOTICE
10 Engine Oil Checking, Adding and Changing Oil Check the engine oil level (B) daily with saw fully lowered and the engine level. See the enclosed Robin manual for more details. Use SAE 10W-30 viscosity detergent automotive type with API service class SE or higher grade oil. Note: Engine holds appro...
Page 11 - OTHER MAINTENANCE
11 OTHER MAINTENANCE Guards Check all guards for damage and proper function daily espe- cially the blade block. Blade block and cover should be secure to the saw and not damaged. Lexan side covers on the blade block should move freely up and down. Diamond blade Inspect diamond blades daily for damag...
Page 12 - SAWING CONTRACTION JOINTS
12 As concrete hydrates or cures and begins to set, it develops internal stresses which may cause random cracks. Random cracks cast doubt on the quality and workmanship of the concrete. Contraction joints are cut in concrete to relieve these stresses before they seek their own relief in the form of ...
Page 13 - MAXIMIZING THE SOFF-CUT SYSTEM
13 “ The timing of concrete operations - especially finishing and jointing - is critical” , states a quote from the foreword of the American Concrete Institute (ACI) 302.1 R-96. It goes on to say that “Failure to address this issue can contribute to unde- sirable characteristics in the wearing surfa...
Page 14 - TROUBLESHOOTING
14 TROUBLESHOOTING ENGINE RUNS ROUGH, BACK FIRES OR CAN NOT REACH FULL SPEED - Check if there is fuel in the tank and it is the correct fuel. Make sure there is no water in the fuel. - Check that the spark plugs are clean and properly gapped. - Check that choke is in the “off” position after engine ...
Page 15 - TECHNICAL SPECIFICATIONS; EC DECLARATION OF CONFORMITY; TECHNICAL DATA
TECHNICAL SPECIFICATIONS Engine Model Robin EX 27 Engine oil volume, quarts/liters 1.0/1.0 Gasoline tank volume, gal/liters 1.6/6.1 Type Air cooled, 4-cycle, single slant cylinder, overhead camshaft, gasoline engine Air fi lter Cyclonic type Oil system Oil alert with auto shut down sensor Muf fl er ...
Page 16 - WARRANTY
16 WARRANTY HUSQVARNA EQUIPMENT WARRANTY New 2000 sold by Husqvarna Construction Products are warranted to be free from manufacturing defects in nor- mal service for a period of six (6) months for labor and up to one (1) year on parts from date of purchase by the original consumer purchaser or date ...
Page 17 - Original instructions
1153477-95 2009-12-29 www.husqvarnacp.com ´®z+UOo¶5N¨ ´®z+UOo¶5N¨ Original instructions