Husqvarna 135 Mark II - User Manual

Page 10 - Overview

Contents Introduction................................................................... 10Safety............................................................................11Assembly...................................................................... 15Operation......................................

Page 11 - Safety; Safety definitions

(Fig. 16) Do not use with one hand (Fig. 17) Do not let the guide bar tip touch an object. Note: Other symbols/decals on the product refer to certification requirements for other commercial areas. California Proposition 65 (Fig. 18) Euro V Emissions WARNING: Tampering with the engine voids the EU ty...

Page 12 - Safety instructions for operation

• The product can eject objects and cause injuries. Obey the safety instructions to decrease the risk of injury or death. • Do not go away from the product when the engine is on. Stop the engine and make sure that the chain does not rotate. • The operator of the product is responsible if an accident...

Page 14 - Safety instructions for maintenance

To examine the stop switch1. Start the engine. See Before you start the engine on page 16. 2. Make sure that the engine stops when you move the stop switch to the stop position. To examine the throttle trigger lockout1. Make sure that the throttle trigger (B) is locked at idle speed when you release...

Page 15 - Assembly; To assemble the guide bar and saw; Operation; To use fuel

• During transportation or storage of the product, use a transportation guard or case to move the product. • Do not use waste oil. Waste oil can be dangerous to you and can cause damage to the product and environment. Assembly WARNING: Read and understand the safety chapter before you assemble the p...

Page 16 - Before you start the engine

CAUTION: Always use air-cooled two-cycled engine oil of high quality. Other oils can cause damage to the product. 4. Shake the fuel mixture to mix the contents.5. Add the remaining gasoline quantity to the fuel container. 6. Shake the fuel mixture to mix the contents.7. Fill the fuel tank of the pro...

Page 18 - Maintenance

• If the log has support on the two ends, cut 1/3 the diameter from the top. Complete the cut by underbucking the lower 2/3 of the log to touch the first cut. (Fig. 51) • If you buck a log on a slope, always stay on the uphill side of the log. Cut through the log while you keep complete control of t...

Page 20 - To lubricate the cutting equipment; Transportation

Use a flat file and depth gauge tool to adjust the depth gauge.1. Put the depth gauge tool above the saw chain. Detailed information regarding how to use the depth gauge tool will be found on the package of the depth gauge tool. 2. Use the flat file to file off the tip of the depth gauge that protru...

Page 22 - Accessories; Guide bar and saw chain combinations

unit 130 (H13038HV) 135 Mark II (H13038HV) Number of drive sprocket teeth — 6 6 Accessories Guide bar and saw chain combinations Guide bar Saw chain Length Pitch Gauge Max. nose radius Type Drive link count 14 inch 3/8 inch 0.050 inch 7T Husqvarna H37 Husqvarna S93G 52 16 inch 56 Saw chain filing an...

Page 23 - Declaration of Conformity; EU Declaration of Conformity

Declaration of Conformity EU Declaration of Conformity We, Husqvarna AB, SE 561 82 Huskvarna, Sweden, tel: +46-36-146500, declare under our sole responsibility that the product: Description Gasoline Chainsaw Brand Husqvarna Platform / Type / Model Platform H13038HV, representing model 130 Identifica...

Husqvarna 135 Mark II - User Manual

Table of Contents:

Summary

Other Husqvarna Models