Hotpoint RLM80 - Manual
Hotpoint RLM80 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – For Your Safety; For your safety, read the following advice:; Only use this fridge for storing domestic foodstuffs.
- Page 3 – Installation; Location & Air Circulation; Prolong the life of the fridge.; Minimum space required to open door
- Page 4 – Position the fridge in its chosen; get clear access to the back wall.; In order to clear components on the; Note: The fridge is heavy so care must be taken when moving it.; locates into the stability bracket.
- Page 6 – Electrical Supply; Earth
- Page 7 – Controls; Controlling the Temperature of the Fridge Compartment
- Page 8 – Useful Advice; STORAGE ZONES
- Page 9 – Avoid opening the doors unnecessarily or for longer than needed.; Storing Food in a Fridge; Pack and store cooked and fresh food separately.
- Page 10 – Sealbreaker Grab Handle
- Page 12 – No manual defrosting required; Defrosting
- Page 13 – Cleaning
- Page 14 – Note : Leave the door ajar to prevent an accumulation of odours.; Changing the Light Bulb; Remove old bulb and fit new one.; Maintenance
- Page 15 – WARNING: Switch off electrical supply and pull out the mains plug.; Door Reversal
- Page 16 – Note : You may require assistance to do this:; Remove the hole plugs from the right hand side of the door.
- Page 17 – Troubleshooting
- Page 18 – Recycling & Disposal Information; Hotpoint guarantee
- Page 19 – After Sales Service
- Page 20 – Key Contacts; Repair Service and Information Desk; Extended Warranties
LARDER FRIDGE - MODEL RLA80, RLM80, RLS80
INSTRUCTIONS FOR INSTALLATION & USE
GETTING STARTED:
To ensure that your fridge runs reliably and efficiently follow these steps.
SAFET
Y &
INST
ALL
A
TION
C
ONTR
OLS
USEFUL AD
VICE
CLEANING &
MAINTENANCE
SER
VICE &
GU
AR
ANTEE
TR
OUBLESHOO
TING
Choose a location for
your fridge, away from
any heat sources and
allow adequate
ventilation - 100mm
(4 inches) gap above.
To prevent the fridge
tilting forwards it must be
held in place with the
stability bracket supplied.
NB. This is the responsibility of
the customer.
Level the fridge by
adjusting the front feet.
This will stop rocking or
vibration and keep the
door aligned.
NB. The spanner is for illustration
only and is not supplied with the
fridge.
Plug in and switch on.
Allow the fridge to cool
before placing food
inside.
All food in the fridge
should be covered.
Move the fridge into
position, using the sides
of the cabinet. Take care
to avoid damaging the
refrigerant circuit pipe
work on the rear.
Before plugging in and
switching on, leave the
fridge in its final
location for at least 15
minutes to allow it to
settle.
STEP 1
STEP 2
STEP 3
After the front feet have
been adjusted and the
fridge is level, fit the left
and right hand bottom
hinge covers supplied.
Align with the cover plate
slots and push into
position.
STEP 5
STEP 4
STEP 6
STEP 7
Your fridge is now
working.
If after 24 hours your
fridge is not operating as
you want, refer to the
TROUBLESHOOTING
section.
STEP 8
Read the rest of these instructions to get the best from your appliance
and remember to fill in your guarantee registration.
Keep this Book in a safe place for quick reference.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Was this manual helpful?
About this manual
- Brand
- Hotpoint
- Model
- RLM80
- Document type
- Manual
- Language(s)
- English
- Pages
- 20
- File size
- 240.8 KB
- Format
Summary
For Your Safety For your safety, read the following advice: The fridge cooling system contains a small amount of gas which is environmentallyfriendly but flammable. To avoid any risk :- ● Install the fridge following the installation instructions and ensure that ventilation openings are kept clear o...
Installation Location & Air Circulation Locate your fridge away from sources of heat e.g. cookers,radiators, direct sunlight as extreme temperature willaffect its performance. Allow a minimum 100mm (4 inches) between the top ofthe fridge and the ceiling or the underside of a wallcupboard. Provid...
Installation Stability bracket: WARNING: To prevent the fridge from tilting forwards, it must be held in place with the stability bracket supplied. This is the responsibility of the customer. 4 SAFET Y & INST ALL A TION 1. Position the fridge in its chosen location. 2. Looking from the front of ...