Hotpoint FZA80 - Manual
Hotpoint FZA80 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – For Your Safety; For your safety, read the following advice:; Only use this freezer for storing domestic foodstuffs.
- Page 3 – Installation; Location & Air Circulation; Prolong the life of the freezer.
- Page 5 – Electrical Supply; Earth
- Page 6 – Controls; Controlling the Temperature of the Freezer Compartment
- Page 7 – Indicator Lights
- Page 8 – Maximum freezing capacity in 24 hours:
- Page 9 – Useful Advice; Fast Freeze
- Page 10 – Avoid opening the door unnecessarily or for longer than needed.; Additional benefits of the frost free system include:
- Page 11 – Storing Food in a Freezer; Ensure food is labelled and dated before placing in freezer.
- Page 13 – Cleaning; Note : Leave the door ajar to prevent an accumulation of odours.
- Page 14 – Door Reversal; WARNING: Switch off electrical supply and pull out the mains plug.; Remove all loose fittings from inside the freezer.
- Page 15 – Note : You may require assistance to do this:
- Page 16 – Troubleshooting; There has been a power failure
- Page 18 – Recycling & Disposal Information; Hotpoint guarantee
- Page 19 – After Sales Service
- Page 20 – Key Contacts; Repair Service and Information Desk; Extended Warranties
FREEZER - MODELS FZM80, FZA80 & FZA50
INSTRUCTIONS FOR INSTALLATION & USE
GETTING STARTED:
To ensure that your freezer runs reliably and efficiently follow these steps.
Choose a location for your
freezer, away from any
heat sources and allow
adequate ventilation -
100mm (4 inches)
gap above.
Level the freezer by
adjusting the front feet.
This will stop rocking or
vibration and keep the
door aligned.
Plug in and switch on.
Allow the freezer to cool
before placing food
inside.
The high temperature
light will stay on until the
freezer has cooled down.
All food in the freezer
should be covered.
Move the freezer into
position, using the sides
of the cabinet. Take care
to avoid damaging the
refrigerant circuit pipe
work on the rear.
Before plugging in and
switching on, leave the
freezer in its final
location for at least 15
minutes to allow it to
settle.
If you are freezing fresh
food, turn on fast freeze by
pressing the switch 24
hours before placing the
food inside.
Place the fresh food
inside.
Read the rest of these instructions to get the best from your appliance
and remember to fill in your guarantee registration.
Keep this Book in a safe place for quick reference.
STEP 1
STEP 2
STEP 3
STEP 5
STEP 6
STEP 7
SAFET
Y &
INST
ALL
A
TION
C
ONTR
OLS
USEFUL AD
VICE
CLEANING &
MAINTENANCE
TR
OUBLESHOO
TING
SER
VICE &
GU
AR
ANTEE
Your freezer is now
working.
If after 24 hours your
freezer is not operating as
you want, refer to the
TROUBLESHOOTING
section.
STEP 8
Remember to turn fast freeze off
after 24 hours, however if you
forget to do so it will automatically
cancel after 48 hours.
After the front feet have
been adjusted and the
freezer is level fit the left
and right hand bottom
hinge covers supplied.
Align with the cover plate
slots and push into
position.
STEP 4
NB. The spanner is for illustration
only and is not supplied with the
freezer.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
For Your Safety For your safety, read the following advice: The freezer cooling system contains a small amount of gas which is environmentallyfriendly but flammable. To avoid any risk :- ● Install the freezer following the installation instructions and ensure that ventilation openings are kept clear...
Installation 3 Minimum space required to open doorThe freezer needs a space of 600mm (24 inches) in front to allow the door toopen.When positioning the freezer next to a unit, a gap of 30mm (1 1 / 4 inch) can be left at the hinge side of the door to allow the easy removal of furniture. If preferredt...
Installation Electrical Supply WARNING: This appliance must be earthed. The appliance must be positioned so that the plug is accessible afterinstallation. FusesYour appliance comes fitted with a plug and a 13A fuse. If you need to replace thefuse, only use those rated at 13A and ASTA approved to BS1...