Hitachi rm-ltx7000dy - Manual

Page 6 - English; Safety precautions

English -1- Safety precautions Items described here are for using the product safely and properly, and to prevent hazards and injury to the user and other persons before they occur. Items are classified as follows. All items are important descriptions related to safety, therefore make sure to obse...

Page 9 - Preparation before use; How to charge

-4- CatchAttachment/detachment buttonFan (Built-in) Charger socket Insert the plug for equipment of the power adaptor. Power adaptor : KH-187BPower plug Insert this into the outlet to its base. Plug for equipment CordCleaning brushShaver oil Pouch Charging completion lamp “ ” During c...

Page 10 - Time to charge

Caution When the switch is turned "ON," this cannot be charged. When the capacity of the battery is sufficient, the charging completion lamp may be turned off early. Charging by using an LED light dryer (Included in the RM-LTX7000DY) Connect the power adaptor to the LED light dryer and an ...

Page 11 - How to use; How to shave with the foil

-6- How to use It is recommended to use the shaver at an ambient temperature of 5°C to 35°C.Use or storage at a temperature below the recommended temperature may disable the shaver or cause a reduced number of operating times.For initial use, trim while lightly applying the shaver to skin. How to sh...

Page 13 - Maintenance

-8- How to keep a comfortable sharpness After use (especially shaving with soap), make sure to perform maintenance. Make sure to wash the foil-cutter assembly with water. Accumulation of beard clippings will cause deterioration in sharpness or scattering of beard clippings. For the main body and tri...

Page 14 - Drying with the LED light dryer

-9- 4. Press the lower part of the head holder removal button to attach the head holder. (Fig.21) Make the front face of the head holder face the switch side for attachment. Caution The head holder cannot be connected in a state where it is facing back to front. 5. After drying, turn "ON" th...

Page 15 - How to replace the foil-cutter assembly

-10- 6. After drying, apply the shaver oil, and keep it in a place free from moisture. 5. After completion, take out the main body, and disconnect the power adaptor from the outlet. Caution : Never wash the LED light dryer with water. (Cause of failures) Brush cleaning Never clean the foil-cutter as...

Page 16 - Troubleshooting

-11- 1. Turn "OFF" the switch to remove the cap and head holder. (Fig.17) Press the head holder removal button (1) to remove the head holder in the arrow (2) direction. 2. Detach the foil-cutter assembly. (Fig.28) Slide the foil-cutter assembly detaching knob to the right (1),pick up and pul...

Page 17 - How to remove the lithium-ion battery

-12- - Failure of drying with the LED light dryer Check for accumulation of dust, etc., inside the LED light dryer. Periodically perform maintenance. Check to see if water drops on the main body and blade surface have been wiped off after washing with water. Wipe off water drops on the main body and...

Hitachi rm-ltx7000dy - Manual

Table of Contents:

Summary

Other Hitachi Models