Hitachi KP-FD30CL - Manual

Preliminary

The KP-FD30 is equipped with the progressive full
frame RGB output of high frame rate( approx. 60
f r a m e p e r s e c o n d ) . O p t i o n a l l y T h e K P - F D 3 0 C L
outputs Camera-Link. Both camera is equipped the
external synchronization(HD/VD), the external trigger
function, etc., it is suitable for the image-processing
equipment input.

Major feature

Suitable for the image-processing equipment input.

Small lightweight size, since adoption of multi-connector with one cable.

High resolution and high color fi delity

By adoption of the progressive scan CCD image sensor and RGB primary
color mosaic fi lters, the picture of high ver tical resolution and high color
fi delity can be acquired.

A new digital signal processor (DSP)

The clear picture of a high signal to noise ratio (S/N) is obtained by the new
digital signal processor (DSP) adoption which has improved luminance signal
processing, such as 5H enhancer processing.

CCD drive functions

.Preset electronic shutter ( settable 11 steps from 1/60 second to 1/50,000
second and
27 steps from 1/30 second to 8 second. )
.Variable electric shutter ( 1H steps from 1/60 second to Approx. 1/10,000
second )
.Auto electronic shutter[AES] ( from 1/60 second to approx. 1/50,000 second )
.Frame/fi eld on demand ( one trigger and fi xed shutter modes )

Output of NTSC system (2:1 interlace scan) (KP-FD30 only)

It can be set as the image output of NTSC system (2:1 interlace scan) by
switch change

VGA Progressive Scan CCD Color Camera

KP-FD30/KP-FD30CL

1 / 2-inch RGB primary color fi lter progressive scan CCD image sensor RGB color camera

High frame rate 60 frame per second

Standard

Optionally

For OEM

Model

KP-FD30

KP-FD30CL

KP-FD30F

KP-FD30USB

Output format

Analog RGB

Camera Link

IEEEE-1394

USB2.0

Frame rate

60 frame per sec. 60 frame per sec. 30 frame per sec. 30 frame per sec.

Imaging device

1/2-inch progressive scan interline CCD

No. of effective pixels

659(H) × 494(V)

Unit cell size

9.9(H) x 9.9(V) m ( Square pixel )

Scanning area

7.48(H) × 6.15(V) mm

Color fi lter

R, G, B primary color mosaic fi lters on chip

Scanning system

(Selectable by switch)

Progressive scan ( VGA mode )

2:1 interlace scan ( NTSC mode )

Frequency

Horizontal: 31.468 kHz Vertical: 59.94 Hz

Sync system

Internal / external ( HD/VD auto selection )

Internal sync output

:HD/VD/SYNC 2 Vp-p/75 , Negative polarity

WE: 5 Vp-p, Negative

External sync input

HD/VD 2 to 5 Vp-p, Negative polarity

EXT. Trigger input: Low 0 VDC, High 2 to 5 VDC

Video signal output

RGB output (G on SYNC)

Y/C output ( Only at the NTSC mode )

VBS output ( Only at the NTSC mode)

S/N ( Y signal )

More than 50dB ( AGC, enhancer and gamma off )

Resolution

( Y signal at center )

Horizontal: 440 TV lines

Vertical: 480 TV lines ( VGA mode ) 350 TV lines ( NTSC mode )

Standard sensitivity

2,000 lx ( F5.6, 100IRE )

Minimum illumination

10 lx ( F1.4, AGC ON, 50IRE )

Sensitivity selection

Gain Adjustable at AGC OFF and AGC Limit Gain

Electric shutter speed

PRESET

AES

VARIABLE

Selectable in 11 steps high spped shutter

OFF(1/60), 1/100, 1/250, 1/500, 1/1000, 1/2000, 1/4000

1/10000, 1/20000, 1/30000, 1/50000 second

: Approx. 1H steps from 1/60 second to 1/10,000 second

Selectable in 27 steps low speed shutter

OFF(1/60), 1/30, 1/15, 1/10, 1/7.5, 1/6, 1/5, 1/3.75, 1/3, 1/2.5, 1/2,

1/1.5, 1, 1.5, 2, 2.5, 3, 3.5, 4, 4.5, 5, 5.5, 6, 6.5, 7, 7.5, 8 second

From 1/60 second to approx. 1/50,000 second

( Response : SLOW, NORMAL, FAST )
Approx. 1H steps from 1/60 second to 1/10,000 second

Auto level ontrol [ALC] ( The auto level control system of AES, lens iris and AGC. )

AVERAGE / PEAK&AVERAGE / AREA

( Scanning area is selectable from 9 area. )

Auto-iris lens

outputs [DC/VIDEO*]

DC ( Iris control voltage input type lens, cable length over 150mm )

: Coupling coil impedance Damper : 1,150 ±10% , Drive : 190 ±10%

Power supply : 12 VDC, 60 mA

Note :. "VIDEO" is optionally.

White balance

Selectable in 3 modes

Auto-tracking[ATW]:2,500K~6,000K

preset [AWC] : (2,500K~10,000K)

R/B gain manual control [MANUAL] (2,500K~10,000K)

Text display

24 alpha-numeric characters in one line (only KP-FD30)

Picture adjustment

Modes and settings can be selected and adjusted from

on-screen menu (only KP-FD30)

Remote control

Modes and settings can be selected and adjusted from PC

by RS-232C level,

Power supply

12 VDC ± 10 %

Approx.360 mA(KP-FD30) pprox.370mA(KP-FD30CL)

(Including 60mA for auto-iris lens )

Lens mount

C/CS mount ( Frange-back adjustment )

Ambient temperature Operating : -10 to +50 C, (+14 to +122 F) 30 to 80 %RH

Storage : -20 to +60 C(-4 to +144 F), 20 to 90 %RH

Vibration endurance

68.6 m/s

2

( 10 to 200Hz, 30 minutes each on XYZ axes )

Shock endurance

490 m/s

2

( vertical, horizontal, once each face )

External dimensions

58(W) x 58(H) x 48(D) ( not including lens and protrusions )

Mass

Approx.220g ( without lens )

Note : If operated continuously, be sure to use at less than +40 C(104 F) for long term stable performance.

Please inquire detailed specifi cations of KP-FD30CL.

Main specifi cations