Page 2 - Model; 7-Inch High Definition Plasma Display; Signal mode; External dimensions
Model CMP307XU General Power supply Frequency Power consumption Dimensions Weight Display characteristics Effective display area Aspect ratio Number of pixels Pixel pitch Number of colors (gray levels) Brightness Contrast ratio Viewing angle Signal input and terminals Video Analog (PC) RGB 1 Analog ...
Page 3 - ENGLISH; FEATURES; Notes about This Manual; Multimedia input support; guaranteed, as they appear in a simplified display mode.; Easy-to-use remote controller and EasyMenu
ENGLISH FEATURES Notes about This Manual • The information in this manual is subject to change without notice. • While meticulous care has been taken in the preparation of this manual, you arerequested to notify your dealer or us should you have any comments, views orquestions about our product. • F...
Page 4 - CONTENTS
FEATURES 1 CONTENTS 2 SAFETY GUIDELINES 3 INSTALLATION INSTRUCTIONS 7 Standard accessories 7 Installation 7 Anti-tumble measures 7 Component Names 8 Installation and Cabling 10 Handling the Remote Controller 12 OPERATING INSTRUCTIONS 13 Turning Power On and Off 13 Input Selection 14 Volume Adjustmen...
Page 5 - SAFETY GUIDELINES; Keep the safety guideline; If there is a strange smell,; Warning
ENGLISH SAFETY GUIDELINES This monitor is designed to be safe to use. However, due to high voltage of about 400 V,fire or serious injury may occur unless you use this monitor in correct way.You are strongly suggested to follow the instruction shown below in order to avoid suchinjury. Keep the safety...
Page 6 - The enclosed power cord must be used!; Failure to do so may cause electric shock hazard or fire hazard.; Be careful of power cord connection!; Do not touch the power plug with wet hands.; You may receive an electric shock.; Do not obstruct a ventilation hole.
ENGLISH Fire or electric shock may cause death or serious injury unless youfollow the instruction. Warning ● If something smells strange or smoke comes from the monitor: Turn off the monitor and disconnect the power plug from the power point immediately.Contact service center after confirming that t...
Page 7 - When you disconnect the power plug.; This is just for your safety.; Do not put the monitor in high temperature atmosphere.; Caution; Do not bundle the power cord.; It will be heated up or it may cause a fire.; INFORMATIVE EXAMPLES OF PROTECTIVE DEVICES IN SINGLE - PHASE; Remove the power cord for complete isolation!
ENGLISH Electric shock or other accidents may cause serious injury or damage toyour property. Caution ● You must to check the user manual of the computer when you connect to the monitor. The weight of the monitor or obstructing the ventilation hole of the computer equipment may causedistortion or da...
Page 8 - Precautions; Installation environment; FCC (Federal Communications Commission) Statement Warning
6 ENGLISH Precautions SAFETY GUIDELINES(continued) ● Installation environment Do not obstruct a ventilation hole.Do not put the monitor on carpet or blanket, or near a curtain which has a possibility of obstructing a ventilation hole of the monitor. Do not put the monitor in the following places. ◆ ...
Page 9 - INSTALLATION INSTRUCTIONS; If any of these accessories is missing, please contact your dealer.; Securing to a wall or post; Standard accessories
7 ENGLISH ● To preserve the performance of this product and to maintain safety, always use one of the special mountunits for installation. Special mount units (options): Wall Mount Unit (CMPAK04), Ceiling Mount Unit (CMPAT04) ■ Use one of the special mount units to install this product. A mount of i...
Page 10 - Front; Control panel; Component Names
8 ENGLISH INSTALLATION INSTRUCTIONS (continued) Remote-control sensor STANDBY(RED)ON (GRN) Front Cabinet (front frame) Stand 12 Panel Indicating lamp 13 Control panel RGB/VIDEO [VOLUME] SELECT MENU VOLUME button 14 MENU button 16 RGB/VIDEO button 14 SELECT button 16 ■ The Adjustmentbutton is located...
Page 11 - Remote controller; External device connection terminals; Main power switch
9 ENGLISH Remote controller POWER RECALL RGB/VIDEO MUTE VOLUME MENU SELECT RGB/VIDEO button 14 POWER button 13 RECALL button 15 MUTE button 15 MENU button 16 VOLUME button 14 SELECT button 15 External device connection terminals Rear RGB input terminals 10 S-VIDEO VIDEO1 INPUT VIDEO VIDEO2 INPUT [CO...
Page 12 - Connecting to the PC; Install the monitor to have ready access to a power socket.; the other end into a power socket.; Installation and Cabling
10 ENGLISH INSTALLATION INSTRUCTIONS (continued) Connecting to the PC Read Usage Notes ( to ) carefully to ensure maximum safety before proceeding tothese steps: (1) Make sure that the display signals produced by your PC meet the specifications of this product. For the specifications of this product...
Page 13 - Connecting to Video Equipment; The monitor is shipped with the power switch off.; signal output terminal to each other using an optional cable.
11 ENGLISH Connecting to Video Equipment (such as a video disc player, a DVD player, or a video camera) S-VIDEO VIDEO1 INPUT VIDEO VIDEO2 INPUT [COMPONENT] P R /C R P B /C B Y R L (MONO) AUDIO R L (MONO) AUDIO Power cableconnector Video equipment (such as a video disc player, a DVD player, and a vid...
Page 14 - Loading Batteries; Slide the battery cover towards the arrow mark while pressing it.; CAUTIONS; Handling the Remote Controller
12 ENGLISH INSTALLATION INSTRUCTIONS (continued) Loading Batteries (1) Open the battery cover. Slide the battery cover towards the arrow mark while pressing it. (2) Load batteries. Load two Size AA batteries included observing the correct polarities.When replacing the batteries, always use the R6P A...
Page 15 - OPERATING INSTRUCTIONS; button; or; TIPS; Failures might result from such operation.; Lit in red; Turning Power On and Off
13 ENGLISH When the indicating lamp blinks in green or the message “POWERSAVE” or “OUT OF FREQUENCY” appears on the screen, there issomething unusual about the status of reception. See “SymptomsThat Seemingly Appear to be Failures.” OPERATING INSTRUCTIONS To turn on the set power supply, set the MAI...
Page 16 - Input Selection
14 ENGLISH OPERATING INSTRUCTIONS (continued) The adjustment status will be displayed as guidancewhile you press these buttons. While the guidance is on display, press or ▲ to turn up the volume.While the guidance is on display, press or ▼ to turn down the volume. You can also adjust the sound volum...
Page 17 - The set itself does not have a RECALL button.; Adjustment status guidance; Contrast Adjustment
15 ENGLISH Press the remote controller MUTE button once again and the mute will be canceled and theguidance will change to VOLUME (blue), enabling the volume to be heard. When MUTE is used, the guide display will continue for 5 sec. and then turn off.The set itself does not have a MUTE button. MUTE ...
Page 18 - Press the MENU button once again to exit the adjustment menu.; HINTS
16 ENGLISH OPERATING INSTRUCTIONS (continued) Press the SELECT buttons (remote controller and keys) to move the pink marker to select an item.Press the VOLUME button and the ▲ and ▼ keys of the main unit ( or key of the remote control) to adjust or set the selecteditem, or to switch the menu. When a...
Page 19 - Adjustment Item List
17 ENGLISH Adjustment Item List Menu item Selected characters Adjustment item Setup hint M A I N PICTURE (in RGB is selected) CONTRAST Contrast Narrows the gapbetweenbrightness anddarkness. Broadens the gapbetweenbrightness anddarkness. Adjust formaximum visibilityto suit theambientbrightness. BRIGH...
Page 24 - OTHER FEATURES; Automatic Store
22 ENGLISH OTHER FEATURES Approximately 1 sec. after adjustment is completed, the adjustments will be recorded as shownin the table below. The previously recorded items will be lost.The signal mode can be identified by the horizontal/vertical sync frequency and the sync signalpolarity. Different sig...
Page 25 - Pressing the; Signal Check
23 ENGLISH The status of signal reception is checked automatically and the result is displayed on thescreen. Status Display Example Signals are receivednormally. •The input terminal and the horizontal and vertical frequenciesare displayed in a guidance image. A sync signal could not bedetected. ❋ Al...
Page 26 - Switching the Display Method
24 ENGLISH OTHERFEATURES (continued) 1) The video signal when a screen with an aspect ratio (the ratio between the sides and widthof the screen) of 16: 9 is compressed to 4: 3. * indicates signals and indicates screens in the chart above ● The display method can be switched by changing the settings ...
Page 27 - Press the MENU button to cancel sound mode.; When the RGB input jack is selected; ) Press the MENU or SELECT button to enter sound mode.; Power Save Mode
25 ENGLISH Press the MENU button to cancel sound mode. The power save mode is activated when thismode is canceled.When an input signal is present, the sound mode iscanceled automatically, the On mode is activatedand the input signal is displayed. RGB sync signal Horizontal Yes No Yes No Vertical Yes...
Page 28 - TROUBLESHOOTING; Symptom; Customer servicing can be hazardous.; Symptoms That Seemingly Appear to be Failures
26 ENGLISH TROUBLESHOOTING ● Make the checks suggested below depending on the symptoms observed. If the symptoms remainuncorrected, contact your dealer. Symptom Point to check See page ● The screen appears blankwith the power-indicatinglamp off. → Check the way the power cable is connected. → Make s...
Page 29 - Actions to Correct Abnormal Displays; Display 1; ABC; ABC; ABC
27 ENGLISH When RGB input is selected, the display screen may not be normal in some cases, depending on the system devices connected. When this happens, always make the following adjustments. Actions to Correct Abnormal Displays ■ The display image may be momentarily disturbed during clock adjustmen...
Page 30 - PRODUCT SPECIFICATIONS; General Specifications
28 ENGLISH PRODUCT SPECIFICATIONS Product specifications and designs are subject to change without notice. The monitor takes at least 30 minutes to attain the status of optimal picture quality.Use RGB input signals in non-interlaced mode. 2,090,000 colors / 16,700,000 colors Display color adjustment...
Page 31 - Signal Input
29 ENGLISH RGB terminal (D-sub 15-pin connector) Pin Input signal 1 R. video 2 G. video or SYNC. on Green 3 B. video 4 No connection 5 No connection 6 R.GND 7 G.GND 8 B.GND 9 No connection 10 GND 11 No connection 12 Bi-directional Data (SDA) 13 H. sync or H/V composite sync 14 V.sync. 15 Data Clock ...
Page 32 - Recommended Signal List
30 ENGLISH Screen controls are factory-preset for the following signal modes (RGB input): Front porch Sync width Back porch Blanking width Horizontal timing Horizontal frequency24 kHz to 52 kHz 0.1 µs or more 2.0-3.8 µs 1.2 µs or more 3.5 µs or more Horizontal frequency52 kHz to 64 kHz 0.1 µs or mor...
