Page 2 - Quick User Manual; Material / Level of Soiling; D J; “Favourite” button; : Optional Fu
14 00 600 1 4 00 A. B. C. “Options” button “Delay End” button D. E. Quick User Manual F. G. Program selector Program and function status display window “Temp.” button “Spin” button Program Care Label Maximum spin speed rpm Wash Program Functions Detergent Compartment Cotton --,20ºC, 30ºC, 40ºC, 60ºC...
Page 3 - Spin program selection button to required program, “off”; Delay End Function; rotating; To Cancel the Program or Reselect the Options; “End”; mute function fault icon. All the buzzing will be; Extra Rinse; “Off”; PARAMETER; Fault codes; This clothes washer is equipped with automatic detection of
Load the clothes to be washed in the drum and close the door. Add the detergent into the relevant compartments for the type of program you are going to select, Add detergent as described in Detergent and Additives section of User's Operation Manual . Add Detergent, Close the Door and Set the Program...
Page 4 - 说明书; g胶版纸,正反面印刷; 王婷
说明书 80g 2256485 HWF Y 英文 X08061280 X08061280 A 1.材料: 80 g胶版纸,正反面印刷; 2.印刷为黑白色单色印刷;3.所有印刷内容正确、清晰,不得有漏印、误印,无印刷缺陷;4.幅面:(210 ±3 )X(145 ±3 ),(单位:mm); 5.未注公差按照 GB/T 1804-m; 6.颜色及整体效果必须经过研发部确认后方能生产,产品检验以封样件为准;7.符合RoHS现行标准要求和REACH指令。 8. 说明书警示语部分的文字大写字母高度必须大于3mm。 王婷 20 2 2.1.11 刘松 202 2.1.11 刘泽旺 202 2.1.11 程⽊...
Page 8 - SAFETY INFORMATION
The manufacturer reserves the right for any modifications on the product which might be deemed necessary or useful without informing about it in this IFU. Before operating your new washing machine, please read this instruction carefully, and keep it for future reference. If you have lost it accident...
Page 10 - ensure; the; Push
3 ensure Important: Transport bolts which are not removed can cause damage to the appliance. Screw off all transportation bolts for approx. 30mm with wrench following the direction of arrow shown (not fully screw it off). Push four transportation bolts on horizontal direction inward and loose transp...
Page 11 - direction until it clicks.; thickness; Adjustment of the feet
Pull out transportation bolt together with rubber part and plastic part. To ensure safety and reduce noise, you should install the transportation bolt cover supplied with the unit (see the annex accompanying the unit). Lean and place the transportation bolt into hole and press it following the shown...
Page 12 - machine can be used without the bottom cover.; Noise-Reduction Bottom Plate Installation Instructions; Install bottom cover
To realize quieter operation, a bottom cover is supplied with the unit (only applies to some of the Hisense washers). After installing the cover at the bottom of the washer, the noise level will be greatly reduced. Please ask for advice from specialists before installing the cover, nevertheless, the...
Page 13 - the hot water
Double sided tape Right-angle impression Before installing the noise-reduction bottom plate, align and paste the acoustic absorption wool with and along the right-angle impression on bottom plate (this procedure is unnecessary for some of the models without acoustic absorption wool). Remove surface ...
Page 14 - In case the drain hose is installed as shown below:; Drain; Connect the
In case the drain hose is installed as shown below: Unhook it only from the right clip (see arrow) Connect the drain hose to the Drain or hook it over the edge of a sink by means of the "U" bend. Fit the “U” bend show in E, if not already installed, if it at the end of the drain hose. Ensure...
Page 16 - that
9 en the from the mains supply, , the mains. The symbol on the product, or on the documents accompanying the product, indicates that this appliance may not be treated as household waste. Instead it shall be handed over to the applicable collection point for there cyclingof electrical and electronic ...
Page 17 - Never open the door forcibly or use it as a step.; DESCRIPTION OF THE WASHING MACHINE
Control panel layout and appearance will depend on the model. 10 Clean the outside of the washing machine with a damp cloth. Do not use abrasive detergents. Never open the door forcibly or use it as a step. DESCRIPTION OF THE WASHING MACHINE EMERGENCY DOOR OPENING In case of failure to open the door...
Page 21 - unds; or D
1 4 unds Press the release lever in the main wash compartment downward and remove the drawer(fig.“B or D ”). Remove siphon in softener slot. (fig.“C or E ”). Refit the siphon in the detergent drawer and fit the drawer back inside its housing. B C D E
Page 22 - if it fails to perform spin cycles.; Ensure that the water has
1 5 2 Insert removal tool like slotted screwdriver into the small opening of bottom baffle, press the bottom baffle downward with much strength and open it. 1 if it fails to perform spin cycles. Ensure that the water has We recommend that you check and clean the filter regularly, at least two or thr...
Page 24 - solv; too
Page 25 - remove some
Page 26 - Hot / Cold fill fault - For Models with Dual Inlets; filter on the rear side of machine.; For Models with Single Inlet
19 Hot / Cold fill fault - For Models with Dual Inlets If you wish to connect hot and cold water supply (Fig.1): 1. Fix the red marked inlet hose to the hot water tap and to the inlet valve with the red filter on the rear side of machine. 2. Fix the other inlet hose to the cold water tap and to the ...
Page 27 - a. “F01” displayed on screen; The machine is not fed with water or insufficient water. Check:; b. “F03” displayed on screen; Spin
2 0 Fault Code List Displayed on Display Window Fault Description “F01” Water inflow fault “F03” Drainage fault Electronic module fault. “F13” Door lock fault “F14” Door unlock fault “Unb” Unbalance alarm Overflow or too much foam. “F24” else fault code, “F04-F98” Ensure that a. “F01” displayed on s...
Page 28 - nb” is shown; Fault code; power supply and contact after-sale service.; If
2 1 nb” is shown Unbalance alarm shall be solved by the following methods 1.Laundry winding Turn the knob to “off” for 3 seconds for shutdown, open the door, shake the clothes and put them back into the washing machine, then select the single dewatering program to dry again. 2.Too light-weighted lau...