Hifonics HS300.4 - Manual - manualsarea.com

Page 2 - INDEX PAGE; Basic mono amplifier application; SAMSON HIGH PERFORMANCE AMPLIFIERS

INDEX PAGE General Installation Procedure..........................................................................................................................................................................................1 Amplifier Feature Descriptions............................................

Page 3 - GENERAL INSTALLATION PROCEDURE; System Design; Power and ground connections

GENERAL INSTALLATION PROCEDURE 1 System Design Installation The success of any car stereo system relies on several factors, such as the system design, execution of the installation, and system setup. Please remember that any system is only as good as its weakest link. Please remember that higher pow...

Page 4 - AMPLIFIER FEATURE DESCRIPTIONS

AMPLIFIER FEATURE DESCRIPTIONS SAMSON AMPLIFIERS: - CAUTION: DO NOT OPERATE ANY AMPLIFIER BELOW THE INTENDED IMPEDANCE. YOU - Each model is capable of 4 & 2-Ohms stereo per channel, or 4-Ohms mono bridged operation WILL CAUSE DAMAGE TO THE AMPLIFIER THAT WILL NOT BE COVERED UNDER THE except the ...

Page 6 - Front/Rear high pass, using a mono amplifier for mono sub bass

HS300.4 / HS500.4 / HS800.4 4-CHANNEL AMPLIFIER APPLICATIONS Front/Rear high pass, using a mono amplifier for mono sub bass The combination of a 1 and a 4 channel amplifier, utilizing their built in Channels 3/4: crossovers, makes it a snap to put together a full system with front and rear highs, wi...

Page 7 - Basic application; FULL RANGE

Basic application Interconnect cable checklist: Crossover frequency control checklist: Connect the inputs to a suitable source, e.g. a head unit with good quality RCA cables. LOW PASS: 40Hz to 150Hz Connect the LINE OUT to the inputs of the system highs amplifier. SUBSONIC:15 Hz to 55 HzBASS EQ: 0 t...

Page 9 - SETTING UP SYSTEMS AFTER INSTALLATION FOR BEST PERFORMANCE

SETTING UP SYSTEMS AFTER INSTALLATION FOR BEST PERFORMANCE HS1500.1D / HS2500.1D General: At this point you are ready to get more specific on the settings for your amplifier. SUBSONIC: This setting acts as a low frequency cut off for your system bass reproduction. The point that you set it at cuts o...

Page 10 - TROUBLESHOOTING A SYSTEM

TROUBLESHOOTING A SYSTEM The key to finding the problem in a misbehaving sound system is to isolate parts of that system in a logical fashion to track down the fault. Description of the PROTECT system built into all Hifonics amplifiers The diagnostic system will shut down the amplifier, until reset ...

Page 11 - Maxxsonics Limited Warranty

As the manufacturer of Maxxsonics, MB Quart, Autotek, Crunch and Hifonics car audioproducts, Maxxsonics USA Inc. Warrants to the original consumer purchaser the amplifierto be free from defects in material and workmanship for one (1) Year from date of purchase. All other parts and accessories of the...

Hifonics HS300.4 - Manual

Table of Contents:

Summary

Other Hifonics Models