Harman Kardon HKTS 8 - Manual

SUB-TS8 SUBWOOFER AMPLIFIER PANEL CONTROLS AND CONNECTIONS 5 SUB-TS8 SUBWOOFER AMPLIFIER PANEL CONTROLS AND CONNECTIONS OFF ON AUTO ON FILTER NORMAL REVERSE PHASE IN OUT AC 120V~60Hz POWER WARNING: FOR CONTINUED PROTECTION AGAINST RISK OF FIRE, REPLACE ONLY WITH SAME TYPE T 2.5A L/250 VOLT FUSE AVER...

6 SUB-TS8 SUBWOOFER AMPLIFIER PANEL CONTROLS AND CONNECTIONS SUB-TS8 SUBWOOFER AMPLIFIER PANEL CONTROLS AND CONNECTIONS and is turned on, and the LED is lit amber toindicate that no signal is being received andthe SUB-TS8 is in Standby mode. When the Music-Sense On/Off Switch £ is in the ON position...

SPEAKER PLACEMENT 7 SPEAKER PLACEMENT Color-Coding System The HKTS 8 uses the channel color-codingsystem established by the ConsumerElectronics Association to make setting upyour home theater speaker system as easyas possible. Your system includes a set ofcolored stickers that may be placed nearthe ...

8 MOUNTING OPTIONS MOUNTING OPTIONS They may be wall-mounted using the supplied brackets. Satellites and Surrounds Wall-Mounting Unscrew the bolt that attaches the blackshelf stand to the bottom of the speaker.Store the stand and bolt in a safe place in case they are needed for a future installation...

SPEAKER CONNECTIONS 9 Speaker-Level Connection Guide IMPORTANT NOTE: Before making speaker connections, be certain that your receiver oraudio power amplifier is turned off andpreferably unplugged from its AC powersource. The SUB-TS8 subwoofer should not be connected to an AC power sourceuntil all sp...

10 SPEAKER CONNECTIONS Dolby* Digital or DTS ® (or Other Digital Surround Mode) Connection USE THIS INSTALLATION METHOD FORDOLBY DIGITAL, DTS OR OTHER DIGITALSURROUND PROCESSORS: Use the line-level input jack marked SUB ∞ for the Low-Frequency Effects channel. Connect this jack to the subwoofer outp...

SPEAKER CONNECTIONS 11 Dolby Pro Logic* (Non-Digital) – Line Level USE THIS INSTALLATION METHOD FORDOLBY PRO LOGIC APPLICATIONS (NOTDOLBY DIGITAL, DTS OR OTHER DIGITALPROCESSING), WHERE THE RECEIVER/PROCESSOR IS EQUIPPED WITH A SUB-WOOFER OUTPUT, OR A VOLUME-CONTROLLED PREAMP (LINE-) LEVEL OUTPUT: U...

12 SPEAKER CONNECTIONS SPEAKER CONNECTIONS Front Left Surround Left Center Front Right Surround Right SUB-TS8 Subwoofer Surround Right FrontRight Surround Left Front Left Center L R H I GH LEVEL Receiver Surround Back Surround Back Dolby Pro Logic (Non-Digital) – Speaker Level USE THIS INSTALLATION ...

OPERATION 13 OPERATION Move the Master Power Switch ª (marked Power ) to the “•” (On) position. The SUB-TS8 subwoofer will automaticallyturn itself on or go into Standby mode,depending on whether or not a signal isbeing sent to it by your receiver or surroundprocessor, and provided that the Music- S...

14 TROUBLESHOOTING TROUBLESHOOTING SYMPTOM SOLUTION If there is no sound from • Check that receiver/amplifier is on and a source is playing. any of the speakers: • Check that the powered subwoofer is plugged in and its Master Power Switch ª is switched on to the “•” position. • Check all wires and c...

SPECIFICATIONS 15 SPECIFICATIONS All features and specifications are subject to change without notice. Harman Kardon and Power for the Digital Revolution are registered trademarks of Harman International Industries, Incorporated. * Trademarks of Dolby Laboratories. DTS is a registered trademark of D...