Harman Kardon Car Stereo System - Manual

Page 2 - iPod; INTRODUCTION; Model Description and

INTRODUCTION Thank you for purchasing Harman Kardon’s Drive + Play™, an elegant mobile audio solution that provides the driver withtotal iPod ® control, including full music browsing capability. We’ve organized this manual to make installation and operationas simple and trouble-free as possible. Ple...

Page 3 - Parts List; Drive + Play Components; INSTALLATION 3; INSTALLATION

INSTALLATION Parts List Drive + Play includes the following components and parts: • Text Display With Universal Mounting Base and AttachedCable (3m) • Control Knob With 30° Mounting Base and Attached Cable (3m) • Electronics Enclosure (the Brain) • 12-Volt Accessory Power Cable (2m) With Cigarette L...

Page 4 - INSTALLATION

Choosing Installation Locations (continued) Electronics Enclosure Location The Electronics Enclosure contains the wireless FM transmitterand the power supply for the three components. You can installit under a seat, in the center console compartment, or in theglove box. If possible, select a site th...

Page 5 - Wiring Diagram; INSTALLATION 5; Audio Input/Output Jacks

Wiring Diagram Direct Connection of the 12-Volt Power Harness With In-Line Fuse Holder Use this method when you want a permanent power connec-tion to the vehicle. Also, by connecting the harness’s red wireto the ignition switch’s ACC terminal, Drive + Play will turn on or off with the vehicle’s igni...

Page 6 - Installing Components; Installing the Electronics Enclosure; INSTALLATION

Installing Components Installing the Electronics Enclosure At the selected site, install the Electronics Enclosure. Use either theenclosed cable ties or mounting screws, as shown below. Installing the Text Display 1. Temporarily place the Text Display at the proposed site and check the default viewi...

Page 7 - Installing the Control Knob; INSTALLATION 7

b. At the proposed site, wipe the surface and exposed mounting plate with one of the enclosed alcohol pads.Allow both to dry. c. Remove the protective tape from one side of one of the enclosed adhesive pads, and press the pad against themounting plate. d. Remove the remaining protective tape, and pr...

Page 8 - Installing the iPod Cable; OPERATING DRIVE + PLAY; Distraction Warning; INSTALLATION/OPERATION

Installing Components Installing the Control Knob (continued) 2. At the base (below the cable), using the 1.5mm hex key, loosen (but do not remove) the hex setscrew. 3. To install the Control Knob with adhesive tape, perform the following steps or skip to step 4: a. Insert the mounting plate, rotate...

Page 9 - Initial Setup; Power On; OPERATION 9; OPERATION

Drive + Play operates much like the iPod itself. The ControlKnob mimics the iPod’s Click Wheel, and its software uses asimilar menu-select system. Before you use Drive + Play,you’ll need to set it up for the first time. After you performthe Initial Setup using the Settings Menu, controlling youriPod...

Page 11 - Browsing and Playing Songs

Setting the Sleep Timer Drive + Play is equipped with a sleep timer that delays itspower off by a default of 2 seconds after the ignition isturned off. You can set a different delay time as follows: NOTE: Sleep Timer only works when the Drive + Play’s ACCwire is connected to the ignition switch’s ac...

Page 12 - TROUBLESHOOTING; Message = iPod Disconnected; Technical Support; TECHNICAL SPECIFICATIONS; Information for the User

TROUBLESHOOTING Problem: Message = iPod Disconnected Solution: • Check that the iPod Connection Cable is connectedbetween the Electronics Enclosure and the iPod. Problem: Message = AUX is Disabled Solution: • Check AUX Input (see page 10). • Check the connection between the Electronics Enclosureand ...

Harman Kardon Car Stereo System - Manual

Table of Contents:

Summary

Other Harman Kardon Models