Page 2 - TABLE OF CONTENTS; Audio/ Video Receiver; Typographical Conventions; EXAMPLE
2 TABLE OF CONTENTS 3 Introduction 4 Safety Information 4 Unpacking 5 Front Panel Controls 7 Front Panel Information Display 9 Rear Panel Connections 11 Main Remote Control Functions 14 Zone II Remote Control Functions 15 Installation and Connections 18 System Configuration 20 Input Setup 20 Surroun...
Page 3 - INTRODUCTION; Introduction; CAUTION; RISK OF ELECTRIC SHOCK
3 INTRODUCTION Introduction Thank you for choosing Harman Kardon! With the purchase of a Harman Kardon AVR 7000 you are about to begin many yearsof listening enjoyment. The AVR 7000 has beencustom designed to provide all the excitementand detail of movie sound tracks and everynuance of musical selec...
Page 4 - SAFETY INFORMATION; Safety Information; Important Safety Information
4 SAFETY INFORMATION Safety Information Important Safety Information Verify Line Voltage Before Use Your AVR 7000 has been designed for use with120-volt AC current. Connection to a line volt-age other than that for which it is intended can create a safety and fire hazard and maydamage the unit. If y...
Page 5 - FRONT PANEL CONTROLS; Front Panel Controls
5 FRONT PANEL CONTROLS 1 Main Power Switch: Press this button to apply power to the AVR 7000. When theswitch is pressed in, the unit is placed in aStandby mode, as indicated by the amber LED 3 surrounding the System Power Control 2 . This button MUST be pressed in to oper- ate the unit. To turn the ...
Page 6 - TUNED
6 FRONT PANEL CONTROLS Front Panel Controls 7 Surround Mode Selector: Press this but- ton to change the surround mode by scrollingthrough the list of available modes. Note thatdepending on the type of input, some modesare not always available. (See page 25 for moreinformation about surround modes.) ...
Page 7 - FRONT PANEL INFORMATION DISPLAY; Front Panel Information Display; G H I
7 FRONT PANEL INFORMATION DISPLAY Front Panel Information Display A B C D F M N J L K P Q R S T U W V O E G H I X A Bitstream Indicators B Dolby Digital Indicator C Coaxial Source Indicators D Analog Dolby Surround Mode Indicators E Optical Source Indicators F Analog Input Indicator G Hall Mode Indi...
Page 8 - Main Information Display:
8 FRONT PANEL INFORMATION DISPLAY Front Panel Information Display T Stereo Indicator: This indicator illuminates when an FM station is being tuned in stereo. U Tuned Indicator: This indicator illuminates when a station is being received with sufficient sig-nal strength to provide acceptable listenin...
Page 9 - REAR PANEL CONNECTIONS; Rear Panel Connections; fl
9 REAR PANEL CONNECTIONS Rear Panel Connections fl ‡ ° ‹ ¤ › ‚ ¶ § fi ⁄ • · a b c d e f g h i j ª £ ™ ¢ ¡ ∞ - NOTE: For all video inputs and outputs f g h i j , the same number is used to indicate the audio, composite-video and S-Video connec-tions related to that input. This accounts for thesame nu...
Page 11 - MAIN REMOTE CONTROL FUNCTIONS; Main Remote Control Functions; kardon; harman
11 MAIN REMOTE CONTROL FUNCTIONS ● ● ● ● ● ● ● ● Main Remote Control Functions AVR 7000 MULTI-ROOM NIGHT kardon SLEEP SURR. CH. SET SPKR MENU SAT AVR ON POWER CH. TEST harman CD PREV.CH. DELAY 5 0 4 3 9 DIRECT 8 LIGHT M3 M4 CLEAR DWN-PRESET-UP DIGITAL 2 1 6 CH. 7 6 OSD M1 MEMORY M2 a k m o b l np s ...
Page 14 - ZONE II REMOTE CONTROL FUNCTIONS; Zone II Remote Control Functions; Multi IR
14 ZONE II REMOTE CONTROL FUNCTIONS Zone II Remote Control Functions å Power Off ∫ AVR Selector ç Input Selectors ∂ Transport Controls ≠ Tuning Up/Down – Fast Play ƒ Preset Up/Down – Track Skip © Disk Skip ˙ Volume Up/Down Mute NOTE: The Zone II remote may be used in either the same room where the A...
Page 15 - INSTALLATION AND CONNECTIONS; Installation and Connections
System Installation After unpacking the unit, and placing it on a solidsurface capable of supporting its weight, you willneed to make the connections to your audio andvideo equipment. Audio Equipment Connections We recommend that you use high-quality inter-connect cables when making connections toso...
Page 16 - System and Power Connections
16 INSTALLATION AND CONNECTIONS Installation and Connections 6. If your DVD player and monitor both havecomponent video connections, connect thecomponent outputs of the DVD player to the DVD Component Video Inputs ¶ . Note that even when component video connectionsare used the audio connections shou...
Page 18 - SYSTEM CONFIGURATION; System Configuration; Speaker Selection and Placement
18 SYSTEM CONFIGURATION System Configuration When all audio, video and system connectionshave been made, there are a few configurationadjustments that must be made. A few minutesspent to correctly configure and calibrate theunit will greatly add to your listening experience. Speaker Selection and Pl...
Page 23 - LS
23 SYSTEM CONFIGURATION System Configuration Press the ‹ / › buttons j on the remote to select the option that best describes yoursystem. Select YES if a subwoofer is connected to your system. Select NO if a subwoofer is NOT connected to your system. Note that when no subwoofer isselected, low frequ...
Page 25 - OPERATION; Operation; Basic Operation; MUTE; Surround Mode Selection
25 OPERATION Operation Basic Operation Once you have completed the setup and config-uration of the AVR 7000, it is simple to operateand enjoy. The following instructions should befollowed for you to maximize your enjoyment ofyour new receiver: • When using the AVR 7000 for the first time,you must pr...
Page 26 - Surround Mode Chart; MODE
26 OPERATION Operation Surround Mode Chart MODE FEATURES DELAY TIME RANGE DOLBY DIGITAL Available only with digital input sources encoded with Dolby Digital data. It provides Center: 0 ms – 5 ms up to five separate main audio channels and a special dedicated Low Frequency Effects Initial Setting – 0...
Page 27 - Digital Audio Playback
27 OPERATION Operation programs and standard stereo programs. In all,a total of ten listening modes are available onthe AVR 7000. Selection of a surround mode is based on per-sonal taste, as well as the type of programsource material being used. For example, motionpictures or TV programs bearing the...
Page 29 - PCM; Tuner Operation; Tape Recording
29 OPERATION Operation 5. When a Dolby Digital or DTS source is play-ing, it is not possible to make an analog record-ing using the Tape ‚ and VID 1 h record outputs. However, the digital signals will bepassed through to the digital audio outputs ‡ . PCM Audio Playback PCM (Pulse Code Modulation) is...
Page 30 - Output Level Trim Adjustment; -Channel Direct Input
30 OPERATION Operation Output Level Trim Adjustment Normal output level adjustment for the AVR 7000 is established using the test tone, asoutlined on page 23. In some cases, however, itmay be desirable to adjust the output levelsusing program material such as a test disc, or aselection you are famil...
Page 31 - ADVANCED FEATURES; Advanced Features
31 ADVANCED FEATURES Advanced Features The AVR 7000 is equipped with a number ofadvanced features that add extra flexibility tothe unit’s operation. While it is not necessary to use these features to operate the unit, theyprovide additional options that you may wish to use. Front Panel Input/Output ...
Page 33 - MULTIROOM OPERATION; Multiroom Operation; Multiroom Setup
33 MULTIROOM OPERATION Multiroom Operation The AVR 7000 is fully equipped to operate as the control center for a sophisticatedaudio/video multiroom system with optionalremote external Infrared (IR) sensors, speakersand power amplifiers. Although some multi-room installations will require the service...
Page 34 - PROGRAMMING THE REMOTE; Programming the Remote
34 PROGRAMMING THE REMOTE Programming the Remote The AVR 7000 is equipped with a powerfulremote control that will control not only thereceiver’s functions, but also most popularbrands of audio and video equipment, includingCD players, cassette decks, TV sets, cable boxes,VCRs, satellite receivers an...
Page 35 - Learning Codes
35 PROGRAMMING THE REMOTE Programming the Remote Learning Codes In addition to using codes from the remote’sinternal code library, the AVR 7000’s remote isable to “learn” codes from remotes that maynot be in the code library. In addition, you mayuse this function to “learn over” the codes froma prep...
Page 37 - Erasing Learned Command Codes
37 PROGRAMMING THE REMOTE Programming the Remote 3. Press either the AVR b or the TV Device Control Selector , depending on which system’s volume control you wish to haveattached for the punch-through mode. Notethat the red light under the AVR button or Device Control Selector will blink twice and t...
Page 38 - SETUP CODES; Function List
38 SETUP CODES Function List No. Button Name CD Tape Aux (DVD) TV VCR CBL SAT 1 AVR Selector 2 CD Selector Power On 3 Tape Selector 4 Aux/DVD Selector Power On 5 Power Off Power Off Power Off Power On/Off Power On/Off Power On/Off Power On/Off 6 Sleep CDP Select Skip Fwd Channel + Channel + Channel ...
Page 39 - Setup Code Tables: TV; Setup Code Number
39 SETUP CODES Setup Code Tables: TV Manufacturer/Brand Setup Code Number ADMIRAL 072 081 161 AKAI 001 146 AMPRO 073 167 ANAM 043 056 080 104 108 112 118 121 AOC 001 004 112 CANDLE 001 003 004 CAPEHART 058 CENTRONIC 043 CITIZEN 001 003 004 101 143 CLASSIC 043 CONCERTO 004 CONTEC 043 CRAIG 054 CROWN ...
Page 42 - Setup Code Tables: VCR
42 SETUP CODES Setup Code Tables: VCR Manufacturer/Brand Setup Code Number AIWA 034 161 AKAI 043 046 124 142 146 ANAM 031 103 AUDIO DYNAMICS 012 023 043 BROKSONIC 035 037 129 CANON 028 031 CAPEHART 108 CRAIG 001 040 135 CURTIS MATHES 031 041 DAEWOO 010 017 108 111 116 117 DAYTRON 108 DBX 012 023 043...
Page 44 - Setup Code Tables: CD
44 SETUP CODES Setup Code Tables: CD Setup Code Tables: DVD Manufacturer/Brand Setup Code Number ADCOM 062 AIWA 089 170 187 AKAI 195 202 CARVER 041 050 135 138 139 167 203 DENON 205 226 FISHER 016 HARMAN KARDON 001 002 033 047 208 JVC 004 136 163 KENWOOD 007 016 023 055 137 MARANTZ 044 107 MONDIAL 1...
Page 45 - Setup Code Tables: CABLE; Setup Code Tables: SAT
45 SETUP CODES Setup Code Tables: DVD/LD Setup Code Tables: CABLE Manufacturer/Brand Setup Code Number DAEWOO 024 DENON 030 GOLDSTAR 027 KENWOOD 025 MAGNAVOX 026 OPTIMUS 032 PANASONIC 021 PHILIPS 026 PIONEER 020 034 RCA 031 REALISTIC 032 SAMSUNG 023 029 SHARP 025 028 SONY 022 TECHNICS 021 TOSHIBA 02...
Page 46 - TROUBLESHOOTING GUIDE; Troubleshooting Guide; SYMPTOM; Processor Reset
46 TROUBLESHOOTING GUIDE Troubleshooting Guide SYMPTOM CAUSE SOLUTION Unit does not function when Main • No AC Power • Make certain AC power cord is plugged into Power Switch is pushed a live outlet • Check to see if outlet is switch-controlled Display lights, but no sound • Intermittent input conne...
Page 47 - TECHNICAL SPECIFICATIONS; Technical Specifications; Audio Section
47 TECHNICAL SPECIFICATIONS Technical Specifications Audio Section Stereo Mode Continuous Average Power (FTC) 110 Watts per channel, 20Hz–20kHz,@ < 0.07% THD, both channels driven into 8 ohms Five-Channel Surround Modes Power Per Individual Channel Front L&R channels:100 Watts per channel,@ &...
