Hansgrohe 31701001 - Manual
Hansgrohe 31701001 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Technical Information; English; Installation Considerations
- Page 4 – Installation; Place the faucet and sealing gasket on the; Use two wrenches, as
- Page 5 – Placez le robinet et le joint d’étanchéité sur la; Utilisez deux clés, tel; Instalación; Coloque el grifo y el aro de sellado sobre la; No permita las mangueras se
- Page 6 – Install the pop-up drain; rod must go through the loop in the bottom of
- Page 7 – Instale el tapón elevable
- Page 8 – Set the High Temperature
- Page 9 – Réglage de la butée limite
- Page 10 – Replacement Parts / Pièces détachées / Repuestos
- Page 12 – User Instructions / Instructions de service / Manejo
- Page 13 – Cleaning Recommendation for Hansgrohe Products; Conseil de nettoyage pour les produits Hansgrohe
- Page 14 – Recomendación de limpieza para los productos de Hansgrohe
- Page 15 – Limited Consumer Warranty
- Page 16 – EXCLUSIONS AND LIMITATIONS
Focus
31701001
31711001
Focus
31721001
EN
Installation / User Instructions / Warranty
FR
Instructions de montage / Mode d'emploi / Garantie
ES
Instrucciones de montaje / Manejo / Garantía
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Technical Information Recommended water pressure 15 - 75 PSI Max. water pressure 145 PSI Recommended hot water temp. 10° - 140° F* Max. hot water temp 176°F* Flow rate - lavatory 1.5 GPM Flow rate - bidet . GPM Hole size in mounting surface 1¼" Max. depth of mounting surface 1⅝" English *Ple...
4 English Installation Place the faucet and sealing gasket on the mounting surface.Slide the washer over the bolt. Install the collar. Tighten the collar using a screwdriver. Secure the supply hoses to the stops. Use two wrenches, as shown, to keep the hoses from twisting. 1 2 06490xx0 baseplate opt...
5 Français Español Installation Placez le robinet et le joint d’étanchéité sur la surface de montage.Installez la rondelle et le collier de montage. Serrez le collier de montage. Installez les tuyaux d’arrivée flexibles sur les butées d’arrêt. Utilisez deux clés, tel qu’illustré dans le schéma, pour...