Hansgrohe 28110XX1 - Manual
Hansgrohe 28110XX1 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Max. flow rate of showerhead
- Page 3 – If you are not using the 28108XX1 wall outlet adapter, go to page 9; brass; nipple required to install the wall outlet
- Page 4 – Installation; Do not overtighten, or damage will
- Page 5 – Seal the wall around the anchors; Install the mounting plate, using the screws and offset
- Page 6 – Install the handshower; Place a black rubber washer in one end of the hose.
- Page 7 – Replacement Parts; check valve; Check Valve Maintenance:; tion is provided by a check valve, which is integral
- Page 8 – Install the corner mount with the screws and offset
- Page 9 – Do not drill through the mounting plate.; Place the mounting plate against the wall at the de-
- Page 10 – Install the handshower:
- Page 11 – Slide the handshower into the holder, until the holder; Using the Allrounder; Turn the knob to the front to make the Allrounder
- Page 12 – Change the spray modes; Limescale Removal; function lever
Raindance Allrounder
28110XX1
Wall Outlet Adapter with Hose
Connection
28108XX1
Installation Instructions / Warranty
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 Raindance Allrounder 28110XX1 Technical Data Max. flow rate of showerhead 2.5 gpm Determining the mounting height (X) The Allrounder should be mounted according to the preferences of the users. It should be conve- nient for all adult users.
Install the Allrounder with the Optional Wall Outlet Adapter with Hose Connection 28108XX1 Roughing in If you are not using the 28108XX1 wall outlet adapter, go to page 9 . Install a properly anchored 1/2" NPT drop-eared ell, at least 2" behind the surface of the finished wall. Install a tes...
Installation Wrap both ends of the brass nipple with Teflon tape. Screw it into the mounting piece. Screw the test nipple / mounting piece assembly into the drop-eared ell. Tighten with a 12 mm Allen wrench (not included). Position the mounting plate over the mounting piece. Use a grease pencil or s...