Hansgrohe 26017XX1 - Manual

Page 2 - Installation Considerations; Pharo Skyline Showerpanel; Technical Information

2 Installation Considerations For best results, Hansgrohe recommends that this unit be installed by a licensed, professional plumber.Please read over these instructions thoroughly before beginning installation. Make sure that you have all tools and supplies needed to complete the installation.A mini...

Page 3 - Suggested installation

3 Suggested installation Minimum ceiling height -- 86 5/8”

Page 4 - Package Contents; good condition, please contact Hansgrohe Technical Service.

4 Rough-in Install 1/2” NPT male nipples at the positions shown on the rough-in diagram for the hot and cold water supplies. The nipples should extend 5/8” outside the surface of the finished wall.Install the finished wall surface. Make the wall watertight. The showerpanel will hang on the finished ...

Page 6 - Installation; Drill the holes for the mounting screws with an 8 mm; Seal the wall around the anchors; Install the screws. Install the nuts. There should be; Do not drill into water lines!

6 Seal the wall around the elbows with waterproof sealant.Failure to seal the wall can lead to possible water damage. Installation Wrap the threads on the nipples with Teflon tape. Install the elbows. The elbow outlets should face downward. Drill the holes for the mounting screws with an 8 mm bit. S...

Page 9 - Reset the HIgh Temperature Limit Stop; Turn the water on to the handshower. Turn the stem

9 Reset the HIgh Temperature Limit Stop (Optional -- if required by local code)Remove the thermostatic mixer handle and safety set.Remove the clip and stop ring from the thermostatic mixer stem. Turn the water on to the handshower. Turn the stem until the output water is the desired maximum high tem...

Page 10 - Justify the handle

10 Justify the handle Turn the water on to the handshower.Turn the thermostatic mixer handle until the output water is 100�F.Turn the water off. Remove the thermostatic mixer handle and safety set.Reinstall the safety set so that the notch is at the 12:00 position.Reinstall the handle with the safet...

Page 11 - Problem

11 Limited Lifetime Consumer Warranty This product has been manufactured and tested to the highest quality standards by Hansgrohe, Inc. (“Hansgrohe”). This warranty is limited to Hansgrohe products which are purchased by a consumer in the United States after March 1, 1996, and installed in either th...

Page 13 - User Instructions / Warranty; Pharo Skyline

User Instructions / Warranty Pharo Skyline 26017XX1

Page 14 - Recommended hot water temp.

2 Technical Information Recommended water pressure 14.7 - 72.5 psi Minimum water pressure 29 psi Max. water pressure 147 psi Recommended hot water temp. 120� - 140� F* Max. hot water temp 165�F* Max. flow rate: showerhead 2.5 gpm handshower 2.5 gpm neck spray 2.5 gpm bodysprays 0.72 gpm each Thermos...

Page 15 - User Instructions

3 User Instructions Turn the top volume control clockwise to obtain water from the overhead shower. Turn the top volume control counter-clockwise to obtain water from the neck spray.It is not possible to run the overhead shower and the neck spray simultaneously. Turn the bottom volume control clockw...

Page 17 - Using the thermostatic mixer; Turn the thermostatic mixer handle clockwise to make

5 Neck spray and handshower • Neck spray and bodysprays • Using the thermostatic mixer Turn the thermostatic mixer handle clockwise to make the water cooler.Turn it counter-clockwise to make it warmer. The handle will stop at the 100° safety stop.To override the safety stop, press the override butto...

Page 18 - To open the overhead shower and neck spray, press

6 Open the overhead shower and neck spray To open the overhead shower and neck spray, press the lower left hand corner of the cover.To open the footrest, press the upper left corner of the cover. The showerhead will open to the 95° position. Push it upward to the 110° position, if desired.

Page 19 - Adjust the showerhead cover; If the showerhead or neckspray cover does not hang

7 Adjust the showerhead cover If the showerhead or neckspray cover does not hang straight, loosen or tighten the set screw with a 3 mm Allen wrench to correct. 3 mm 3 mm

Page 20 - The handshower and overhead shower use the Rubit; turn the water on lightly and rub over the channels; Troubleshooting; Not a product defect; Filters inside supply elbows; The check valves located in the hot and cold elbows; check valve

8 Cleaning the hand and overhead showers The handshower and overhead shower use the Rubit TM self-cleaning system.If scale deposits are noticed in the spray channels, turn the water on lightly and rub over the channels with a finger or a sponge to dislodge them. Troubleshooting Problem Possible caus...

Page 21 - Replacement Parts

9 Replacement Parts 28532XX1 28276XX0 98875XX0 98874XX0 98883000 94082000 94074000 97582000 96509000 97342XX0 98891XX0 98891XX0 97441XX0 94282000 95041000 96519XX1 96483XX0 98879000 98880000 98882001 98744000 98878000 98884000 98884000 98743000 98742XX0 98900001 98901001 98881001 98877000 98876000 X...

Page 22 - Limited Lifetime Consumer Warranty; Cleaning Recommendation for Hansgrohe Products

10 Limited Lifetime Consumer Warranty This product has been manufactured and tested to the highest quality standards by Hansgrohe, Inc. (“Hansgrohe”). This warranty is limited to Hansgrohe products which are purchased by a consumer in the United States after March 1, 1996, and installed in either th...

Hansgrohe 26017XX1 - Manual

Table of Contents:

Summary

Other Hansgrohe Models