Hansgrohe 15181XX1 - Manual
Hansgrohe 15181XX1 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – do not bend or twist the supply; Technical data; Recommended pressure:
- Page 3 – Installation
- Page 6 – Faucet Maintenance; Remove the set screw with a .5 mm
- Page 7 – Cleaning the filters and aerator; If the flow of water is reduced, the filters and/or the aera-; To clean the aerator; : Block the sensor for 5 seconds
- Page 8 – the filters out and clean them.
- Page 9 – Replacement Parts
- Page 10 – Cleaning Recommendation for Hansgrohe Products; Cleaning Materials for Faucets and Showers
- Page 11 – Limited Lifetime Consumer Warranty; WHO IS COVERED BY THE WARRANTY; purchase price in exchange for the return of the product.; LENGTH OF WARRANTY
- Page 12 – 40 Bluegrass Lakes Parkway; TO OBTAIN WARRANTY PARTS OR INFORMATION; Contact your Hansgrohe retailer, or contact Technical Service at:; EXCLUSIONS AND LIMITATIONS
Electronic
15181XX1
Electronic
15180XX1
Installation Instructions / Warranty
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Hansgrohe Electronic Lavatory Faucet with Temperature Control 15180XX1 Hansgrohe Electronic Lavatory Faucet 15181XX1 16 Caution: do not bend or twist the supply hoses! Technical data Max. water pressure: 116 psi Recommended pressure: 14.5 - 7 psi Hot water temperature: max. 158 °F* Recommended hot w...
3 Installation Flush the hot and cold supplies thoroughly before installing this faucet. Place the faucet in the hole in the mounting surface (1). From beneath the sink, install the fiber washer, metal washer and mounting nut (). Install the adapters on the stops (3). Install the filters (4) and sup...
6 Faucet Maintenance Reset the faucet: Remove the set screw with a .5 mm Allen wrench. Block the sensor for seconds. Wait 10 seconds (1), then replace the set screw ().
