Hanna Instruments HI 4101 - Manual

Page 3 - Delrin

3 H I 4 1 0 1 A m m o n i a E l e c t r o d e H I 4 1 0 1 A m m o n i a E l e c t r o d e H I 4 1 0 1 A m m o n i a E l e c t r o d e H I 4 1 0 1 A m m o n i a E l e c t r o d e H I 4 1 0 1 A m m o n i a E l e c t r o d e I. I. I. I. I. Introduction: Introduction: Introduction: Introduction: Introdu...

Page 8 - Protective shipping cap

8 VIII. VIII. VIII. VIII. VIII. Inner Electrode Check Inner Electrode Check Inner Electrode Check Inner Electrode Check Inner Electrode Check Before assembling the electrode for the first time first time first time first time first time or if reactivating it after storage, the inner electrode assemb...

Page 11 - ) Install assembled electrode in gas sensor test vessel

11 6) Insert and position the inner glass/reference assem- bly into the outer body so that the anti-rotation keysits in the cut out on the outer probe body. 7) Holding the electrode upright, slide spring and elec- trode cap down cable and screw cap on outer bodyuntil fully engaged. Do not invert ele...

Page 13 - org

13 XII. XII. XII. XII. XII. Sample Handling Sample Handling Sample Handling Sample Handling Sample Handling • Keep samples stored in tightly covered bottles to pre-vent ammonia loss or ammonia contamination fromother sources. • Alkaline samples must be measured at once or acidi-fied for storage. (HC...

Page 17 - The unknown ammonia concentration in the original; ) can then be determined by using the

17 7) The procedure can be repeated with a second standard addition to verify slope and operation of the method. Note: This method is preprogrammed in the Hanna HI 4222pH/ISE/mV meter, which simplifies the methodgreatly and permits repeated determinations easily. Example:Ammonia determination with k...

Hanna Instruments HI 4101 - Manual

Table of Contents:

Summary

Other Hanna Instruments Models