Haier HCG604WFCX2 - User Manual

BUILT-IN GAS HOB

INSTALLATION AND USER INSTRUCTIONS

Note: Do not use the hob until you have read the instruction manual

1.INTRODUCTION

Thank you for purchasing a new Gas Hob.

4.SAFETY INSTRUCTIONS

(*)Air inlet minimum section:100c

m

2

Fig 1 Fig 2 Fig 3

WARNING!

the relevant instructions regarding ventilation.

The appliance must not be connected to a combustion products evacuation device. It shall be installed

and connected in accordance with current installation regulations. Particular attention shall be given to

LOCATION
The cooker may be located in a kitchen, kitchen/diner or a bed-sitting room, but not in a room containing

LPG models shall not be installed in a room or internal space below ground level, e.g. in a basement.

The room must have an opening window or equivalent; some rooms may also require a permanent

PROVISION FOR VENTILATIO
The room containing the cooker should have an air supply in accordance with BS 5440: Part 2.

a bath or shower. The hob must not be installed in a bed-sitting room of less than 20

m

3

.

vent. If the room has a volume between 5 and 10

m

3

, it will require an air vent of 50 c

m

2

effective

area unless it has a door which opens directly to

If the room has a volume of less than 5

m

3

,

it will require an air vent of 100 c

m

2

effective area (fig.1). If there are

other fuel burning appliances in

the same room, BS 5440: Part 2 should be consulted to determine air yent requirements.

open or install a mechanical ventilation device (fig 2).
In particular, when using the grill or more than one hotplate burner, open a window if a mechanical

ventilation device is not operating (fig. 3).

NOTE

: The use of a gas cooking appliance results in the production of heat and moisture in the room

in which it is installed. Always ensure that the kitchen is well ventilated; keep natural ventilation holes

1

2

3

2.YOUR HOB

3.CLEANING

Applicable For gas

477x 557

477x 557

Semirapid

gas burner

burner

Auxiliary

gas

Material

Flame

failure

device

Power

Supply

Size

(mm)

Built-in

(mm)

Type

580x 56

500x

580x 50

500x

220-240V

~50Hz

220-240V

~50Hz

Glass

13.7 MJ/H
13.7 MJ/H

Stainless steel

Yes
Yes

Cod:

3.6 MJ/H

3.6 MJ/H
3.6 MJ/H

3.6 MJ/H

6.3 MJ/H

6.3 MJ/H
6.3 MJ/H

6.3 MJ/H

6.3 MJ/H

6.3 MJ/H

Triple flame

gas burner

13.7 MJ/H

Triple flame

gas burner

Semirapid

gas burner

Triple flame

gas burner

13.7 MJ/H

Semirapid

gas burner

Semirapid

Auxiliary

gas burner

gas burner

Semirapid

Auxiliary

gas burner

gas burner

Even if you have used a gas hob before, it is important that you read these instructions thoroughly

before starting to cook, paying particular attention to the installation and safety instructions. If you have

any problems with installing, operating, or cooking with your hob, please check through these

instructions thoroughly to make sure that you have not missed anything.

WARNING!

For your own safety, make sure that these instructions on Installation, use and

maintenance are followed. We advise you to keep these instructions in a safe place for future

reference. If you sell or transfer ownership of this product, please pass on these instructions to the new

owner.

VITREOUS ENAMEL

Hotplate, burner caps, pan supports.

Cloth wrung out in hot soapy water. Stubborn stains.can be removed with a cream paste.

approved by the Vitreous Enamel Development Council, liquid cleaner or by rubbing with fine steel

wool soap pads.

ALUMINIUM

Hotplate burner bodies.

Similar to paint cleaning above. Use a nylon brush to remove any cleaning materials, water or dirt from

the hotplate burner bodies. After cleaning, wipe dry and refit to the hob ensuring they are correctly

seated.

Check parts are reassembled correctly by lighting the burners and allowing to dry out.

PLASTIC

Control knobs.

Wipe with a cloth wrung out in hot soapy water.

NOTE: The pan supports can also be cleaned in the dishwasher

STAINLESS STEEL

Cloth wrung out in hot soapy water.

GLASS

A non-abrasive cleaner should be used on glass surfaces.

Any abrasive cleaner (including Cif) will scratch the surface and could erase the control panel markings. Glass

can be effectively cleaned by simply using a dilute solution of water and mild detergent and drying to a shine

with a clean cloth.

Caution:

In case of hotplate glass breakage:

shut immediately off all burners and any electrical heating element and isolate the appliance from the

power supply do not touch the appliance surface

-- do not touch the appliance surface

-- do not use the appliance

Ensure that these notes and that the whole of this instruction book are thoroughly read and understood before

installation or operation of the hob.

The instructions are provided in the interest of your safety.

GAS SAFETY (INSTALLATION & USE) REGULATIONS

1.It is the law that all gas appliances are installed by competent persons in accordance with current edition

of the above regulations. It is In your interest and that of safety to ensure compliance with the law.

2.Repairs or servicing of this product must only be carried out by an authorised agent service agent

service agent using only approved parts.

3.No attempt must be made to modify this appliance.

4.Cooking appliances become very hot in use, therefore ensure children and pets are kept away. The use

of oven gloves is recommended when during use.

5.Do not allow children to operate or play with any part of the appliance.

6.Do not use unstable pans and position handle away from the edge of the hob.The use of a suitable hob.

7.In the interests of safety and hygiene, ensure the hob is kept clean as a build up of grease could cause.

8.This appliance is designed for domestic cooking only, commercial catering may invalidate the warranty.

9.Do not cover the hob or place combustible materials on or near the surface even when the hob is not in use.

10.Do not fill deep fat frying pans more than one third full of oil. Do not leave unattended.

11.Before cleaning the hob, switch off at the mains.

12.When finished cooking, switch all controls off and allow to cool.

13.If you sell or transfer ownership of this product, please pass on these instructions to the new owner.

14.This appliance is not intended for use by persons (including children) with reduced physical, sensory

or mental capabilities, or lack of experience and knowledge, unless they have been given

supervision or instruction concerning use of the appliance by a person responsible for their safety.

15.Children should be supervised to ensure that they do not play with the appliance.

16.If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a

similarly qualified person in order to avoid a hazard.

17.Do not immerse appliance or power cord into water or any other liquids.

18.Please pull the pin out when you do cleaning and maintenance. When the appliance is installed, you

can pull out the pin.

HCG604WFCX2

HCG604WFCX2

HCG604WFCG1

HCG604WFCX2

HCG604WFCG1

HCG604WFCG1

0070302059

UNPACKING THE APPLIANCE

Remove all packaging and make sure the appliance is in perfect condition.

If you have any doubts, do not use the appliance and call your supplier.

Some parts on the appliance are protected by a plastic film. This protective film must be removed

before the appliance is used.

The packaging materials should be carefully discarded and not left within

easy reach of children as they are a potential hazard.

INSTALLING AND FIXING THE HOB (QUALIFIED PERSONNEL ONLY)

The appliance can be fitted to any worktop with a thickness of 40mm or 50mm.

No overhanging surface or cooker hood should be closer to the hob than 650mm.

Fix the appliance in position (Fig. 4). The sides of the adjacent cabinets above may be lower than

650mm down to 400mm, provided they are heat and steam resistant.

These hobs are supplied with a special seal which prevents liquids from seeping underneath the

appliance. Follow these instructions in order to correctly fit this seal:

5. INSTALLATION INSTRUCTIONS

TECHNICAL INFORMATION

The Installation, the adjustments, conversions and maintenance listed in this part must only be

carried out by qualified persons.

The safety and automatic adjustment devices of the appliance may only be modified by an

authorised service agent.

The Installation of this gas hob must comply with the standards in force.

This appliance is not connected to a flue for discharge of the combustion products; therefore, it

must be connected in compliance with the above mentioned installation rules. Particular

attention must be paid to the instructions given below for ventilation and aeration.