Page 2 - Introduction; Safety is important; Warranty
Introduction Thank you for buying this Grundig product, which is designed to give you many years of trouble-free service. You may already be familiar with using a similar unit, but please take time to read these instructions. They are designed to familiarize you with the unit’s many features and to ...
Page 3 - Table Of Contents; Menu Tree
2 Table Of Contents Introduction …………………………………………………………….……..1 Safety instructions………………………………………………………….. 3 About the Set-Top-Box………………………………………………………4 Front panel and rear panel illustration………………………………..…5 Front Panel……………………………………………………………………5 Rear Panel……………………………………………………………..……5 Remo te co nt...
Page 4 - Safety Instructions
3 Safety Instructions • Always read the safety instructions carefully. • Keep this User's Manual for future reference. • Keep this equipment away from humidity. • Lay this equipment on a reliable flat surface before setting it up. • Do not stand it on soft furnishings. • If any of the following situ...
Page 5 - About the Set Top Box; Main Features
4 About the Set Top Box This DVB-T TV Receiver is a Free-To-Air digital terrestrial receiver, allowing you to access all free-to-air digital terrestrial TV channels and radio broadcasts on your TV set. Its digital reception covers VHF & UHF band. Compared with the analog TV programs, digital TV ...
Page 6 - Front panel and rear panel illustration; Front Panel
5 Front panel and rear panel illustration Front Panel ① ① POWER To turn the Stand-by mode ON/OFF. Rear Panel ① ANT IN To connect the antenna here. ② LOOP OUT To connect a RF signal from the STB to either the RF Input jack (antenna) on your VCR or to the antenna input of your TV. ③ HDMI video output ...
Page 7 - Remote control
6 Remote control 1. POWER To turn the Stand-by mode ON/OFF. 2. Numeric buttons (0-9) To select a channel by direct number input. 3. SUBT To switch the close caption ON/OFF. 4. FAV To access and exit the favourite program list. 5. EPG To provide the user with TV programming information. 6. MENU To en...
Page 8 - Installing the batteries; Using the Remote Control
7 Installing the batteries Remove the battery cover from the remote control and put two AA size batteries inside the compartment. The diagram inside the battery compartment shows the correct way to install the batteries. Caution: 1. Keep batteries out of children’s reach. 2. Don’t attempt to recharg...
Page 9 - Connecting to equipments; How to get good reception; Connections to a TV; Connect the STB receiver via Video/S-Video and Audio
8 Connecting to equipments How to get good reception • In general you are not required to change the existing antenna. However if your antenna is not in good condition you should consider replacing them to ensure uninterrupted digital television viewing. • Viewers in areas of poor analog reception m...
Page 11 - Audio connections via Optical/Coaxial/Mixed Audio L/R Output
10 Connecting to equipments Connect the receiver via HDMI output (for high definition viewing) Audio connections via Optical/Coaxial/Mixed Audio L/R Output
Page 12 - First time installation; Power; First Time Installation; MENU
11 First time installation Note: Be sure to turn on the main power at the rear of your receiver before using the receiver. After all the connections have been made properly, switch on your TV. Make sure the receiver is connected to the mains and press Power to switch the receiver on. If you are usin...
Page 13 - Basic operations
12 Basic operations Switch program 1. Press the NUMERIC keys (0~9) on the remote control to select the channel number you want. 2. Press the ▲▼ key on the remote control or the front panel to change the available channels upward/downward. 3. Press the RECALL key to view the previous channel selected...
Page 16 - Main menu; Navigation in the main menu; OK; EXIT; Installation
15 Main menu This section guides you to walk through of all options on the Menu screen. Navigation in the main menu 1. Press MENU key to bring up the main menu or return previous. 2. Press ▲▼ key to move upward/down to the desired sub menu. 3. Press OK key to enter into the sub menu you select. 4. P...
Page 18 - Auto Scan; BLUE; Manual Scan
17 Installation Auto Scan 1. Go to Main menu > Installation. 2. Press BLUE key to auto scan all the channels. 3. Press EXIT key if you want to stop during the auto scan. Manual Scan 1. Go to Main menu > Installation. 2. Press ▲▼ to select the channels you want to scan. Press ◀▶ key to page up/...
Page 19 - Program edit; Edit Favourite
18 Program edit NOTE: If there is no program stored, you can not access the edit menu. Edit Favourite 1. Go to Main menu > Program edit > TV or Radio list. 2. Press YELLOW key to show the favorite list and then press ▲▼ key to select the desired favorite list, press OK key to enter favorite ed...
Page 20 - Delete Program
19 Program edit Delete Program 1. Go to Main menu > Program edit > TV or Radio list. 2. Press RED key to show a list of Edit modes. Press ▲▼ key to select the delete item. 3. Press OK key to enable the delete function. 4. Press ▲▼ key to select the program you dislike, and press OK key to mark...
Page 21 - System setup; Local Time Setting
20 System setup A/V Output Settings 1. Go to Main menu > System setup > A/V output setting. 2. Press ▲▼ key to select the options: Resolution, Video output, Screen aspect, Audio output. And press OK to enter submenu of selected option. 3. Press ▲▼ key to select the item you want to set, and pr...
Page 22 - User preferences; OSD Language
21 User preferences OSD Language Go to Main menu > User preferences >OSD language. Only English is supported for this receiver. OSD Transparency 1. Go to Main menu > User preferences >OSD Transparency. 2. Press ▲▼ key to select the OSD Transparency option, and press OK key to enter subme...
Page 23 - Parental Control
22 User preferences Parental Control 1. Go to Main menu > User preferences >Parental control. 2. Press ▲▼ key to select the Parental Control option, and press OK key and input the correct the PIN code to enter the submenu. 1. Parental Rating To set the rating level. There are up to 8 levels ar...
Page 24 - Trouble shooting; If this doesn’t work, contact a qualified repair technician, never
23 Trouble shooting If you experience problems with this receiver or its installation, in the first instance please read carefully the relevant sections of this User Manual and this Troubleshooting section. Problem Possible cause What to do Main lead unplugged Check mains lead Display on front panel...
Page 25 - Technical specifications
24 Technical specifications Item Specification Frequency Range VHF: 174MHz to 230MHz UHF: 470MHz to 862MHz Input Impedance 75Ohms unbalanced Signal Input Level -78~-25dbm Tuner Bandwidth 7MHz Demodulator COFDM OFDM Modulation 2K, 8K FFT, SFN and MFN Packed Carries 2K/8K Demodulation Guard Interval 1...
Page 26 - Grundig
25 Warranty Please keep your receipt as proof of purchase. This product is warranted for any defect in materials or workmanship for one year after the original date of purchase. This product is for normal domestic and office use only. This warranty does not cover damage from misuse or neglect, accid...
